diff options
Diffstat (limited to 'drivers/scsi/hpsa.h')
| -rw-r--r-- | drivers/scsi/hpsa.h | 273 |
1 files changed, 273 insertions, 0 deletions
diff --git a/drivers/scsi/hpsa.h b/drivers/scsi/hpsa.h new file mode 100644 index 00000000000..6bd1949144b --- /dev/null +++ b/drivers/scsi/hpsa.h @@ -0,0 +1,273 @@ +/* + * Disk Array driver for HP Smart Array SAS controllers + * Copyright 2000, 2009 Hewlett-Packard Development Company, L.P. + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License as published by + * the Free Software Foundation; version 2 of the License. + * + * This program is distributed in the hope that it will be useful, + * but WITHOUT ANY WARRANTY; without even the implied warranty of + * MERCHANTABILITY OR FITNESS FOR A PARTICULAR PURPOSE, GOOD TITLE or + * NON INFRINGEMENT. See the GNU General Public License for more details. + * + * You should have received a copy of the GNU General Public License + * along with this program; if not, write to the Free Software + * Foundation, Inc., 675 Mass Ave, Cambridge, MA 02139, USA. + * + * Questions/Comments/Bugfixes to iss_storagedev@hp.com + * + */ +#ifndef HPSA_H +#define HPSA_H + +#include <scsi/scsicam.h> + +#define IO_OK 0 +#define IO_ERROR 1 + +struct ctlr_info; + +struct access_method { + void (*submit_command)(struct ctlr_info *h, + struct CommandList *c); + void (*set_intr_mask)(struct ctlr_info *h, unsigned long val); + unsigned long (*fifo_full)(struct ctlr_info *h); + unsigned long (*intr_pending)(struct ctlr_info *h); + unsigned long (*command_completed)(struct ctlr_info *h); +}; + +struct hpsa_scsi_dev_t { + int devtype; + int bus, target, lun; /* as presented to the OS */ + unsigned char scsi3addr[8]; /* as presented to the HW */ +#define RAID_CTLR_LUNID "\0\0\0\0\0\0\0\0" + unsigned char device_id[16]; /* from inquiry pg. 0x83 */ + unsigned char vendor[8]; /* bytes 8-15 of inquiry data */ + unsigned char model[16]; /* bytes 16-31 of inquiry data */ + unsigned char revision[4]; /* bytes 32-35 of inquiry data */ + unsigned char raid_level; /* from inquiry page 0xC1 */ +}; + +struct ctlr_info { + int ctlr; + char devname[8]; + char *product_name; + char firm_ver[4]; /* Firmware version */ + struct pci_dev *pdev; + __u32 board_id; + void __iomem *vaddr; + unsigned long paddr; + int nr_cmds; /* Number of commands allowed on this controller */ + struct CfgTable __iomem *cfgtable; + int interrupts_enabled; + int major; + int max_commands; + int commands_outstanding; + int max_outstanding; /* Debug */ + int usage_count; /* number of opens all all minor devices */ +# define DOORBELL_INT 0 +# define PERF_MODE_INT 1 +# define SIMPLE_MODE_INT 2 +# define MEMQ_MODE_INT 3 + unsigned int intr[4]; + unsigned int msix_vector; + unsigned int msi_vector; + struct access_method access; + + /* queue and queue Info */ + struct hlist_head reqQ; + struct hlist_head cmpQ; + unsigned int Qdepth; + unsigned int maxQsinceinit; + unsigned int maxSG; + spinlock_t lock; + + /* pointers to command and error info pool */ + struct CommandList *cmd_pool; + dma_addr_t cmd_pool_dhandle; + struct ErrorInfo *errinfo_pool; + dma_addr_t errinfo_pool_dhandle; + unsigned long *cmd_pool_bits; + int nr_allocs; + int nr_frees; + int busy_initializing; + int busy_scanning; + struct mutex busy_shutting_down; + struct list_head scan_list; + struct completion scan_wait; + + struct Scsi_Host *scsi_host; + spinlock_t devlock; /* to protect hba[ctlr]->dev[]; */ + int ndevices; /* number of used elements in .dev[] array. */ +#define HPSA_MAX_SCSI_DEVS_PER_HBA 256 + struct hpsa_scsi_dev_t *dev[HPSA_MAX_SCSI_DEVS_PER_HBA]; +}; +#define HPSA_ABORT_MSG 0 +#define HPSA_DEVICE_RESET_MSG 1 +#define HPSA_BUS_RESET_MSG 2 +#define HPSA_HOST_RESET_MSG 3 +#define HPSA_MSG_SEND_RETRY_LIMIT 10 +#define HPSA_MSG_SEND_RETRY_INTERVAL_MSECS 1000 + +/* Maximum time in seconds driver will wait for command completions + * when polling before giving up. + */ +#define HPSA_MAX_POLL_TIME_SECS (20) + +/* During SCSI error recovery, HPSA_TUR_RETRY_LIMIT defines + * how many times to retry TEST UNIT READY on a device + * while waiting for it to become ready before giving up. + * HPSA_MAX_WAIT_INTERVAL_SECS is the max wait interval + * between sending TURs while waiting for a device + * to become ready. + */ +#define HPSA_TUR_RETRY_LIMIT (20) +#define HPSA_MAX_WAIT_INTERVAL_SECS (30) + +/* HPSA_BOARD_READY_WAIT_SECS is how long to wait for a board + * to become ready, in seconds, before giving up on it. + * HPSA_BOARD_READY_POLL_INTERVAL_MSECS * is how long to wait + * between polling the board to see if it is ready, in + * milliseconds. HPSA_BOARD_READY_POLL_INTERVAL and + * HPSA_BOARD_READY_ITERATIONS are derived from those. + */ +#define HPSA_BOARD_READY_WAIT_SECS (120) +#define HPSA_BOARD_READY_POLL_INTERVAL_MSECS (100) +#define HPSA_BOARD_READY_POLL_INTERVAL \ + ((HPSA_BOARD_READY_POLL_INTERVAL_MSECS * HZ) / 1000) +#define HPSA_BOARD_READY_ITERATIONS \ + ((HPSA_BOARD_READY_WAIT_SECS * 1000) / \ + HPSA_BOARD_READY_POLL_INTERVAL_MSECS) +#define HPSA_POST_RESET_PAUSE_MSECS (3000) +#define HPSA_POST_RESET_NOOP_RETRIES (12) + +/* Defining the diffent access_menthods */ +/* + * Memory mapped FIFO interface (SMART 53xx cards) + */ +#define SA5_DOORBELL 0x20 +#define SA5_REQUEST_PORT_OFFSET 0x40 +#define SA5_REPLY_INTR_MASK_OFFSET 0x34 +#define SA5_REPLY_PORT_OFFSET 0x44 +#define SA5_INTR_STATUS 0x30 +#define SA5_SCRATCHPAD_OFFSET 0xB0 + +#define SA5_CTCFG_OFFSET 0xB4 +#define SA5_CTMEM_OFFSET 0xB8 + +#define SA5_INTR_OFF 0x08 +#define SA5B_INTR_OFF 0x04 +#define SA5_INTR_PENDING 0x08 +#define SA5B_INTR_PENDING 0x04 +#define FIFO_EMPTY 0xffffffff +#define HPSA_FIRMWARE_READY 0xffff0000 /* value in scratchpad register */ + +#define HPSA_ERROR_BIT 0x02 +#define HPSA_TAG_CONTAINS_INDEX(tag) ((tag) & 0x04) +#define HPSA_TAG_TO_INDEX(tag) ((tag) >> 3) +#define HPSA_TAG_DISCARD_ERROR_BITS(tag) ((tag) & ~3) + +#define HPSA_INTR_ON 1 +#define HPSA_INTR_OFF 0 +/* + Send the command to the hardware +*/ +static void SA5_submit_command(struct ctlr_info *h, + struct CommandList *c) +{ +#ifdef HPSA_DEBUG + printk(KERN_WARNING "hpsa: Sending %x - down to controller\n", + c->busaddr); +#endif /* HPSA_DEBUG */ + writel(c->busaddr, h->vaddr + SA5_REQUEST_PORT_OFFSET); + h->commands_outstanding++; + if (h->commands_outstanding > h->max_outstanding) + h->max_outstanding = h->commands_outstanding; +} + +/* + * This card is the opposite of the other cards. + * 0 turns interrupts on... + * 0x08 turns them off... + */ +static void SA5_intr_mask(struct ctlr_info *h, unsigned long val) +{ + if (val) { /* Turn interrupts on */ + h->interrupts_enabled = 1; + writel(0, h->vaddr + SA5_REPLY_INTR_MASK_OFFSET); + } else { /* Turn them off */ + h->interrupts_enabled = 0; + writel(SA5_INTR_OFF, + h->vaddr + SA5_REPLY_INTR_MASK_OFFSET); + } +} +/* + * Returns true if fifo is full. + * + */ +static unsigned long SA5_fifo_full(struct ctlr_info *h) +{ + if (h->commands_outstanding >= h->max_commands) + return 1; + else + return 0; + +} +/* + * returns value read from hardware. + * returns FIFO_EMPTY if there is nothing to read + */ +static unsigned long SA5_completed(struct ctlr_info *h) +{ + unsigned long register_value + = readl(h->vaddr + SA5_REPLY_PORT_OFFSET); + + if (register_value != FIFO_EMPTY) + h->commands_outstanding--; + +#ifdef HPSA_DEBUG + if (register_value != FIFO_EMPTY) + printk(KERN_INFO "hpsa: Read %lx back from board\n", + register_value); + else + printk(KERN_INFO "hpsa: FIFO Empty read\n"); +#endif + + return register_value; +} +/* + * Returns true if an interrupt is pending.. + */ +static unsigned long SA5_intr_pending(struct ctlr_info *h) +{ + unsigned long register_value = + readl(h->vaddr + SA5_INTR_STATUS); +#ifdef HPSA_DEBUG + printk(KERN_INFO "hpsa: intr_pending %lx\n", register_value); +#endif /* HPSA_DEBUG */ + if (register_value & SA5_INTR_PENDING) + return 1; + return 0 ; +} + + +static struct access_method SA5_access = { + SA5_submit_command, + SA5_intr_mask, + SA5_fifo_full, + SA5_intr_pending, + SA5_completed, +}; + +struct board_type { + __u32 board_id; + char *product_name; + struct access_method *access; +}; + + +/* end of old hpsa_scsi.h file */ + +#endif /* HPSA_H */ + |