diff options
Diffstat (limited to 'drivers/spi/amba-pl022.c')
| -rw-r--r-- | drivers/spi/amba-pl022.c | 10 |
1 files changed, 5 insertions, 5 deletions
diff --git a/drivers/spi/amba-pl022.c b/drivers/spi/amba-pl022.c index c0f950a7cbe..ff5bbb9c43c 100644 --- a/drivers/spi/amba-pl022.c +++ b/drivers/spi/amba-pl022.c @@ -532,7 +532,7 @@ static void restore_state(struct pl022 *pl022) GEN_MASK_BITS(SSP_DATA_BITS_12, SSP_CR0_MASK_DSS, 0) | \ GEN_MASK_BITS(SSP_MICROWIRE_CHANNEL_FULL_DUPLEX, SSP_CR0_MASK_HALFDUP, 5) | \ GEN_MASK_BITS(SSP_CLK_POL_IDLE_LOW, SSP_CR0_MASK_SPO, 6) | \ - GEN_MASK_BITS(SSP_CLK_FALLING_EDGE, SSP_CR0_MASK_SPH, 7) | \ + GEN_MASK_BITS(SSP_CLK_SECOND_EDGE, SSP_CR0_MASK_SPH, 7) | \ GEN_MASK_BITS(NMDK_SSP_DEFAULT_CLKRATE, SSP_CR0_MASK_SCR, 8) | \ GEN_MASK_BITS(SSP_BITS_8, SSP_CR0_MASK_CSS, 16) | \ GEN_MASK_BITS(SSP_INTERFACE_MOTOROLA_SPI, SSP_CR0_MASK_FRF, 21) \ @@ -1247,8 +1247,8 @@ static int verify_controller_parameters(struct pl022 *pl022, return -EINVAL; } if (chip_info->iface == SSP_INTERFACE_MOTOROLA_SPI) { - if ((chip_info->clk_phase != SSP_CLK_RISING_EDGE) - && (chip_info->clk_phase != SSP_CLK_FALLING_EDGE)) { + if ((chip_info->clk_phase != SSP_CLK_FIRST_EDGE) + && (chip_info->clk_phase != SSP_CLK_SECOND_EDGE)) { dev_err(chip_info->dev, "Clock Phase is configured incorrectly\n"); return -EINVAL; @@ -1485,7 +1485,7 @@ static int pl022_setup(struct spi_device *spi) chip_info->data_size = SSP_DATA_BITS_12; chip_info->rx_lev_trig = SSP_RX_1_OR_MORE_ELEM; chip_info->tx_lev_trig = SSP_TX_1_OR_MORE_EMPTY_LOC; - chip_info->clk_phase = SSP_CLK_FALLING_EDGE; + chip_info->clk_phase = SSP_CLK_SECOND_EDGE; chip_info->clk_pol = SSP_CLK_POL_IDLE_LOW; chip_info->ctrl_len = SSP_BITS_8; chip_info->wait_state = SSP_MWIRE_WAIT_ZERO; @@ -1826,7 +1826,7 @@ static struct amba_id pl022_ids[] = { * ST Micro derivative, this has 32bit wide * and 32 locations deep TX/RX FIFO */ - .id = 0x00108022, + .id = 0x01080022, .mask = 0xffffffff, .data = &vendor_st, }, |