diff options
Diffstat (limited to 'drivers/staging/lirc/TODO.lirc_zilog')
| -rw-r--r-- | drivers/staging/lirc/TODO.lirc_zilog | 36 |
1 files changed, 30 insertions, 6 deletions
diff --git a/drivers/staging/lirc/TODO.lirc_zilog b/drivers/staging/lirc/TODO.lirc_zilog index 6aa312df401..2d0263f0793 100644 --- a/drivers/staging/lirc/TODO.lirc_zilog +++ b/drivers/staging/lirc/TODO.lirc_zilog @@ -1,13 +1,37 @@ -The binding between hdpvr and lirc_zilog is currently disabled, +1. Both ir-kbd-i2c and lirc_zilog provide support for RX events. +The 'tx_only' lirc_zilog module parameter will allow ir-kbd-i2c +and lirc_zilog to coexist in the kernel, if the user requires such a set-up. +However the IR unit will not work well without coordination between the +two modules. A shared mutex, for transceiver access locking, needs to be +supplied by bridge drivers, in struct IR_i2_init_data, to both ir-kbd-i2c +and lirc_zilog, before they will coexist usefully. This should be fixed +before moving out of staging. + +2. References and locking need careful examination. For cx18 and ivtv PCI +cards, which are not easily "hot unplugged", the imperfect state of reference +counting and locking is acceptable if not correct. For USB connected units +like HD PVR, PVR USB2, HVR-1900, and HVR1950, the likelyhood of an Ooops on +unplug is probably great. Proper reference counting and locking needs to be +implemented before this module is moved out of staging. + +3. The binding between hdpvr and lirc_zilog is currently disabled, due to an OOPS reported a few years ago when both the hdpvr and cx18 drivers were loaded in his system. More details can be seen at: http://www.mail-archive.com/linux-media@vger.kernel.org/msg09163.html More tests need to be done, in order to fix the reported issue. -There's a conflict between ir-kbd-i2c: Both provide support for RX events. -Such conflict needs to be fixed, before moving it out of staging. +4. In addition to providing a shared mutex for transceiver access +locking, bridge drivers, if able, should provide a chip reset() callback +to lirc_zilog via struct IR_i2c_init_data. cx18 and ivtv already have routines +to perform Z8 chip resets via GPIO manipulations. This will allow lirc_zilog +to bring the chip back to normal when it hangs, in the same places the +original lirc_pvr150 driver code does. This is not strictly needed, so it +is not required to move lirc_zilog out of staging. + +5. Both lirc_zilog and ir-kbd-i2c support the Zilog Z8 for IR, as programmed +and installed on Hauppauge products. When working on either module, developers +must consider at least the following bridge drivers which mention an IR Rx unit +at address 0x71 (indicative of a Z8): -The way I2C probe works, it will try to register the driver twice, one -for RX and another for TX. The logic needs to be fixed to avoid such -issue. + ivtv cx18 hdpvr pvrusb2 bt8xx cx88 saa7134 |