diff options
Diffstat (limited to 'drivers/usb/host/ehci-pci.c')
| -rw-r--r-- | drivers/usb/host/ehci-pci.c | 64 |
1 files changed, 64 insertions, 0 deletions
diff --git a/drivers/usb/host/ehci-pci.c b/drivers/usb/host/ehci-pci.c index a1e8d273103..76179c39c0e 100644 --- a/drivers/usb/host/ehci-pci.c +++ b/drivers/usb/host/ehci-pci.c @@ -22,6 +22,9 @@ #error "This file is PCI bus glue. CONFIG_PCI must be defined." #endif +/* defined here to avoid adding to pci_ids.h for single instance use */ +#define PCI_DEVICE_ID_INTEL_CE4100_USB 0x2e70 + /*-------------------------------------------------------------------------*/ /* called after powerup, by probe or system-pm "wakeup" */ @@ -41,6 +44,35 @@ static int ehci_pci_reinit(struct ehci_hcd *ehci, struct pci_dev *pdev) return 0; } +static int ehci_quirk_amd_SB800(struct ehci_hcd *ehci) +{ + struct pci_dev *amd_smbus_dev; + u8 rev = 0; + + amd_smbus_dev = pci_get_device(PCI_VENDOR_ID_ATI, 0x4385, NULL); + if (!amd_smbus_dev) + return 0; + + pci_read_config_byte(amd_smbus_dev, PCI_REVISION_ID, &rev); + if (rev < 0x40) { + pci_dev_put(amd_smbus_dev); + amd_smbus_dev = NULL; + return 0; + } + + if (!amd_nb_dev) + amd_nb_dev = pci_get_device(PCI_VENDOR_ID_AMD, 0x1510, NULL); + if (!amd_nb_dev) + ehci_err(ehci, "QUIRK: unable to get AMD NB device\n"); + + ehci_info(ehci, "QUIRK: Enable AMD SB800 L1 fix\n"); + + pci_dev_put(amd_smbus_dev); + amd_smbus_dev = NULL; + + return 1; +} + /* called during probe() after chip reset completes */ static int ehci_pci_setup(struct usb_hcd *hcd) { @@ -99,10 +131,26 @@ static int ehci_pci_setup(struct usb_hcd *hcd) /* cache this readonly data; minimize chip reads */ ehci->hcs_params = ehci_readl(ehci, &ehci->caps->hcs_params); + if (ehci_quirk_amd_SB800(ehci)) + ehci->amd_l1_fix = 1; + retval = ehci_halt(ehci); if (retval) return retval; + if ((pdev->vendor == PCI_VENDOR_ID_AMD && pdev->device == 0x7808) || + (pdev->vendor == PCI_VENDOR_ID_ATI && pdev->device == 0x4396)) { + /* EHCI controller on AMD SB700/SB800/Hudson-2/3 platforms may + * read/write memory space which does not belong to it when + * there is NULL pointer with T-bit set to 1 in the frame list + * table. To avoid the issue, the frame list link pointer + * should always contain a valid pointer to a inactive qh. + */ + ehci->use_dummy_qh = 1; + ehci_info(ehci, "applying AMD SB700/SB800/Hudson-2/3 EHCI " + "dummy qh workaround\n"); + } + /* data structure init */ retval = ehci_init(hcd); if (retval) @@ -124,6 +172,10 @@ static int ehci_pci_setup(struct usb_hcd *hcd) ehci_info(ehci, "disable lpm for langwell/penwell\n"); ehci->has_lpm = 0; } + if (pdev->device == PCI_DEVICE_ID_INTEL_CE4100_USB) { + hcd->has_tt = 1; + tdi_reset(ehci); + } break; case PCI_VENDOR_ID_TDI: if (pdev->device == PCI_DEVICE_ID_TDI_EHCI) { @@ -148,6 +200,18 @@ static int ehci_pci_setup(struct usb_hcd *hcd) if (pdev->revision < 0xa4) ehci->no_selective_suspend = 1; break; + + /* MCP89 chips on the MacBookAir3,1 give EPROTO when + * fetching device descriptors unless LPM is disabled. + * There are also intermittent problems enumerating + * devices with PPCD enabled. + */ + case 0x0d9d: + ehci_info(ehci, "disable lpm/ppcd for nvidia mcp89"); + ehci->has_lpm = 0; + ehci->has_ppcd = 0; + ehci->command &= ~CMD_PPCEE; + break; } break; case PCI_VENDOR_ID_VIA: |