diff options
Diffstat (limited to 'include/asm-arm/hardware/locomo.h')
| -rw-r--r-- | include/asm-arm/hardware/locomo.h | 206 |
1 files changed, 206 insertions, 0 deletions
diff --git a/include/asm-arm/hardware/locomo.h b/include/asm-arm/hardware/locomo.h new file mode 100644 index 00000000000..5f10048ec54 --- /dev/null +++ b/include/asm-arm/hardware/locomo.h @@ -0,0 +1,206 @@ +/* + * linux/include/asm-arm/hardware/locomo.h + * + * This file contains the definitions for the LoCoMo G/A Chip + * + * (C) Copyright 2004 John Lenz + * + * May be copied or modified under the terms of the GNU General Public + * License. See linux/COPYING for more information. + * + * Based on sa1111.h + */ +#ifndef _ASM_ARCH_LOCOMO +#define _ASM_ARCH_LOCOMO + +#define locomo_writel(val,addr) ({ *(volatile u16 *)(addr) = (val); }) +#define locomo_readl(addr) (*(volatile u16 *)(addr)) + +/* LOCOMO version */ +#define LOCOMO_VER 0x00 + +/* Pin status */ +#define LOCOMO_ST 0x04 + +/* Pin status */ +#define LOCOMO_C32K 0x08 + +/* Interrupt controller */ +#define LOCOMO_ICR 0x0C + +/* MCS decoder for boot selecting */ +#define LOCOMO_MCSX0 0x10 +#define LOCOMO_MCSX1 0x14 +#define LOCOMO_MCSX2 0x18 +#define LOCOMO_MCSX3 0x1c + +/* Touch panel controller */ +#define LOCOMO_ASD 0x20 /* AD start delay */ +#define LOCOMO_HSD 0x28 /* HSYS delay */ +#define LOCOMO_HSC 0x2c /* HSYS period */ +#define LOCOMO_TADC 0x30 /* tablet ADC clock */ + + +/* Long time timer */ +#define LOCOMO_LTC 0xd8 /* LTC interrupt setting */ +#define LOCOMO_LTINT 0xdc /* LTC interrupt */ + +/* DAC control signal for LCD (COMADJ ) */ +#define LOCOMO_DAC 0xe0 +/* DAC control */ +#define LOCOMO_DAC_SCLOEB 0x08 /* SCL pin output data */ +#define LOCOMO_DAC_TEST 0x04 /* Test bit */ +#define LOCOMO_DAC_SDA 0x02 /* SDA pin level (read-only) */ +#define LOCOMO_DAC_SDAOEB 0x01 /* SDA pin output data */ + +/* SPI interface */ +#define LOCOMO_SPIMD 0x60 /* SPI mode setting */ +#define LOCOMO_SPICT 0x64 /* SPI mode control */ +#define LOCOMO_SPIST 0x68 /* SPI status */ +#define LOCOMO_SPIIS 0x70 /* SPI interrupt status */ +#define LOCOMO_SPIWE 0x74 /* SPI interrupt status write enable */ +#define LOCOMO_SPIIE 0x78 /* SPI interrupt enable */ +#define LOCOMO_SPIIR 0x7c /* SPI interrupt request */ +#define LOCOMO_SPITD 0x80 /* SPI transfer data write */ +#define LOCOMO_SPIRD 0x84 /* SPI receive data read */ +#define LOCOMO_SPITS 0x88 /* SPI transfer data shift */ +#define LOCOMO_SPIRS 0x8C /* SPI receive data shift */ +#define LOCOMO_SPI_TEND (1 << 3) /* Transfer end bit */ +#define LOCOMO_SPI_OVRN (1 << 2) /* Over Run bit */ +#define LOCOMO_SPI_RFW (1 << 1) /* write buffer bit */ +#define LOCOMO_SPI_RFR (1) /* read buffer bit */ + +/* GPIO */ +#define LOCOMO_GPD 0x90 /* GPIO direction */ +#define LOCOMO_GPE 0x94 /* GPIO input enable */ +#define LOCOMO_GPL 0x98 /* GPIO level */ +#define LOCOMO_GPO 0x9c /* GPIO out data setteing */ +#define LOCOMO_GRIE 0xa0 /* GPIO rise detection */ +#define LOCOMO_GFIE 0xa4 /* GPIO fall detection */ +#define LOCOMO_GIS 0xa8 /* GPIO edge detection status */ +#define LOCOMO_GWE 0xac /* GPIO status write enable */ +#define LOCOMO_GIE 0xb0 /* GPIO interrupt enable */ +#define LOCOMO_GIR 0xb4 /* GPIO interrupt request */ +#define LOCOMO_GPIO(Nb) (0x01 << (Nb)) +#define LOCOMO_GPIO_RTS LOCOMO_GPIO(0) +#define LOCOMO_GPIO_CTS LOCOMO_GPIO(1) +#define LOCOMO_GPIO_DSR LOCOMO_GPIO(2) +#define LOCOMO_GPIO_DTR LOCOMO_GPIO(3) +#define LOCOMO_GPIO_LCD_VSHA_ON LOCOMO_GPIO(4) +#define LOCOMO_GPIO_LCD_VSHD_ON LOCOMO_GPIO(5) +#define LOCOMO_GPIO_LCD_VEE_ON LOCOMO_GPIO(6) +#define LOCOMO_GPIO_LCD_MOD LOCOMO_GPIO(7) +#define LOCOMO_GPIO_DAC_ON LOCOMO_GPIO(8) +#define LOCOMO_GPIO_FL_VR LOCOMO_GPIO(9) +#define LOCOMO_GPIO_DAC_SDATA LOCOMO_GPIO(10) +#define LOCOMO_GPIO_DAC_SCK LOCOMO_GPIO(11) +#define LOCOMO_GPIO_DAC_SLOAD LOCOMO_GPIO(12) + +/* Start the definitions of the devices. Each device has an initial + * base address and a series of offsets from that base address. */ + +/* Keyboard controller */ +#define LOCOMO_KEYBOARD 0x40 +#define LOCOMO_KIB 0x00 /* KIB level */ +#define LOCOMO_KSC 0x04 /* KSTRB control */ +#define LOCOMO_KCMD 0x08 /* KSTRB command */ +#define LOCOMO_KIC 0x0c /* Key interrupt */ + +/* Front light adjustment controller */ +#define LOCOMO_FRONTLIGHT 0xc8 +#define LOCOMO_ALS 0x00 /* Adjust light cycle */ +#define LOCOMO_ALD 0x04 /* Adjust light duty */ + +/* Backlight controller: TFT signal */ +#define LOCOMO_BACKLIGHT 0x38 +#define LOCOMO_TC 0x00 /* TFT control signal */ +#define LOCOMO_CPSD 0x04 /* CPS delay */ + +/* Audio controller */ +#define LOCOMO_AUDIO 0x54 +#define LOCOMO_ACC 0x00 /* Audio clock */ +#define LOCOMO_PAIF 0x7C /* PCM audio interface */ +/* Audio clock */ +#define LOCOMO_ACC_XON 0x80 +#define LOCOMO_ACC_XEN 0x40 +#define LOCOMO_ACC_XSEL0 0x00 +#define LOCOMO_ACC_XSEL1 0x20 +#define LOCOMO_ACC_MCLKEN 0x10 +#define LOCOMO_ACC_64FSEN 0x08 +#define LOCOMO_ACC_CLKSEL000 0x00 /* mclk 2 */ +#define LOCOMO_ACC_CLKSEL001 0x01 /* mclk 3 */ +#define LOCOMO_ACC_CLKSEL010 0x02 /* mclk 4 */ +#define LOCOMO_ACC_CLKSEL011 0x03 /* mclk 6 */ +#define LOCOMO_ACC_CLKSEL100 0x04 /* mclk 8 */ +#define LOCOMO_ACC_CLKSEL101 0x05 /* mclk 12 */ +/* PCM audio interface */ +#define LOCOMO_PAIF_SCINV 0x20 +#define LOCOMO_PAIF_SCEN 0x10 +#define LOCOMO_PAIF_LRCRST 0x08 +#define LOCOMO_PAIF_LRCEVE 0x04 +#define LOCOMO_PAIF_LRCINV 0x02 +#define LOCOMO_PAIF_LRCEN 0x01 + +/* LED controller */ +#define LOCOMO_LED 0xe8 +#define LOCOMO_LPT0 0x00 +#define LOCOMO_LPT1 0x04 +/* LED control */ +#define LOCOMO_LPT_TOFH 0x80 +#define LOCOMO_LPT_TOFL 0x08 +#define LOCOMO_LPT_TOH(TOH) ((TOH & 0x7) << 4) +#define LOCOMO_LPT_TOL(TOL) ((TOL & 0x7)) + +extern struct bus_type locomo_bus_type; + +#define LOCOMO_DEVID_KEYBOARD 0 +#define LOCOMO_DEVID_FRONTLIGHT 1 +#define LOCOMO_DEVID_BACKLIGHT 2 +#define LOCOMO_DEVID_AUDIO 3 +#define LOCOMO_DEVID_LED 4 +#define LOCOMO_DEVID_UART 5 + +struct locomo_dev { + struct device dev; + unsigned int devid; + unsigned int irq[1]; + + void *mapbase; + unsigned long length; + + u64 dma_mask; +}; + +#define LOCOMO_DEV(_d) container_of((_d), struct locomo_dev, dev) + +#define locomo_get_drvdata(d) dev_get_drvdata(&(d)->dev) +#define locomo_set_drvdata(d,p) dev_set_drvdata(&(d)->dev, p) + +struct locomo_driver { + struct device_driver drv; + unsigned int devid; + int (*probe)(struct locomo_dev *); + int (*remove)(struct locomo_dev *); + int (*suspend)(struct locomo_dev *, pm_message_t); + int (*resume)(struct locomo_dev *); +}; + +#define LOCOMO_DRV(_d) container_of((_d), struct locomo_driver, drv) + +#define LOCOMO_DRIVER_NAME(_ldev) ((_ldev)->dev.driver->name) + +void locomo_lcd_power(struct locomo_dev *, int, unsigned int); + +int locomo_driver_register(struct locomo_driver *); +void locomo_driver_unregister(struct locomo_driver *); + +/* GPIO control functions */ +void locomo_gpio_set_dir(struct locomo_dev *ldev, unsigned int bits, unsigned int dir); +unsigned int locomo_gpio_read_level(struct locomo_dev *ldev, unsigned int bits); +unsigned int locomo_gpio_read_output(struct locomo_dev *ldev, unsigned int bits); +void locomo_gpio_write(struct locomo_dev *ldev, unsigned int bits, unsigned int set); + +/* M62332 control function */ +void locomo_m62332_senddata(struct locomo_dev *ldev, unsigned int dac_data, int channel); + +#endif |