diff options
Diffstat (limited to 'include/asm-generic/pgtable.h')
| -rw-r--r-- | include/asm-generic/pgtable.h | 73 |
1 files changed, 38 insertions, 35 deletions
diff --git a/include/asm-generic/pgtable.h b/include/asm-generic/pgtable.h index f605e8d0eed..5f0d797d33f 100644 --- a/include/asm-generic/pgtable.h +++ b/include/asm-generic/pgtable.h @@ -2,6 +2,7 @@ #define _ASM_GENERIC_PGTABLE_H #ifndef __ASSEMBLY__ +#ifdef CONFIG_MMU #ifndef __HAVE_ARCH_PTEP_SET_ACCESS_FLAGS /* @@ -133,41 +134,6 @@ static inline void ptep_set_wrprotect(struct mm_struct *mm, unsigned long addres #endif /* - * A facility to provide lazy MMU batching. This allows PTE updates and - * page invalidations to be delayed until a call to leave lazy MMU mode - * is issued. Some architectures may benefit from doing this, and it is - * beneficial for both shadow and direct mode hypervisors, which may batch - * the PTE updates which happen during this window. Note that using this - * interface requires that read hazards be removed from the code. A read - * hazard could result in the direct mode hypervisor case, since the actual - * write to the page tables may not yet have taken place, so reads though - * a raw PTE pointer after it has been modified are not guaranteed to be - * up to date. This mode can only be entered and left under the protection of - * the page table locks for all page tables which may be modified. In the UP - * case, this is required so that preemption is disabled, and in the SMP case, - * it must synchronize the delayed page table writes properly on other CPUs. - */ -#ifndef __HAVE_ARCH_ENTER_LAZY_MMU_MODE -#define arch_enter_lazy_mmu_mode() do {} while (0) -#define arch_leave_lazy_mmu_mode() do {} while (0) -#define arch_flush_lazy_mmu_mode() do {} while (0) -#endif - -/* - * A facility to provide batching of the reload of page tables with the - * actual context switch code for paravirtualized guests. By convention, - * only one of the lazy modes (CPU, MMU) should be active at any given - * time, entry should never be nested, and entry and exits should always - * be paired. This is for sanity of maintaining and reasoning about the - * kernel code. - */ -#ifndef __HAVE_ARCH_ENTER_LAZY_CPU_MODE -#define arch_enter_lazy_cpu_mode() do {} while (0) -#define arch_leave_lazy_cpu_mode() do {} while (0) -#define arch_flush_lazy_cpu_mode() do {} while (0) -#endif - -/* * When walking page tables, get the address of the next boundary, * or the end address of the range if that comes earlier. Although no * vma end wraps to 0, rounded up __boundary may wrap to 0 throughout. @@ -233,6 +199,43 @@ static inline int pmd_none_or_clear_bad(pmd_t *pmd) } return 0; } +#endif /* CONFIG_MMU */ + +/* + * A facility to provide lazy MMU batching. This allows PTE updates and + * page invalidations to be delayed until a call to leave lazy MMU mode + * is issued. Some architectures may benefit from doing this, and it is + * beneficial for both shadow and direct mode hypervisors, which may batch + * the PTE updates which happen during this window. Note that using this + * interface requires that read hazards be removed from the code. A read + * hazard could result in the direct mode hypervisor case, since the actual + * write to the page tables may not yet have taken place, so reads though + * a raw PTE pointer after it has been modified are not guaranteed to be + * up to date. This mode can only be entered and left under the protection of + * the page table locks for all page tables which may be modified. In the UP + * case, this is required so that preemption is disabled, and in the SMP case, + * it must synchronize the delayed page table writes properly on other CPUs. + */ +#ifndef __HAVE_ARCH_ENTER_LAZY_MMU_MODE +#define arch_enter_lazy_mmu_mode() do {} while (0) +#define arch_leave_lazy_mmu_mode() do {} while (0) +#define arch_flush_lazy_mmu_mode() do {} while (0) +#endif + +/* + * A facility to provide batching of the reload of page tables with the + * actual context switch code for paravirtualized guests. By convention, + * only one of the lazy modes (CPU, MMU) should be active at any given + * time, entry should never be nested, and entry and exits should always + * be paired. This is for sanity of maintaining and reasoning about the + * kernel code. + */ +#ifndef __HAVE_ARCH_ENTER_LAZY_CPU_MODE +#define arch_enter_lazy_cpu_mode() do {} while (0) +#define arch_leave_lazy_cpu_mode() do {} while (0) +#define arch_flush_lazy_cpu_mode() do {} while (0) +#endif + #endif /* !__ASSEMBLY__ */ #endif /* _ASM_GENERIC_PGTABLE_H */ |