diff options
Diffstat (limited to 'include/asm-sparc64/dma.h')
| -rw-r--r-- | include/asm-sparc64/dma.h | 221 |
1 files changed, 221 insertions, 0 deletions
diff --git a/include/asm-sparc64/dma.h b/include/asm-sparc64/dma.h new file mode 100644 index 00000000000..1aab3c8dce2 --- /dev/null +++ b/include/asm-sparc64/dma.h @@ -0,0 +1,221 @@ +/* $Id: dma.h,v 1.21 2001/12/13 04:16:52 davem Exp $ + * include/asm-sparc64/dma.h + * + * Copyright 1996 (C) David S. Miller (davem@caip.rutgers.edu) + */ + +#ifndef _ASM_SPARC64_DMA_H +#define _ASM_SPARC64_DMA_H + +#include <linux/config.h> +#include <linux/kernel.h> +#include <linux/types.h> +#include <linux/spinlock.h> + +#include <asm/sbus.h> +#include <asm/delay.h> +#include <asm/oplib.h> + +extern spinlock_t dma_spin_lock; + +#define claim_dma_lock() \ +({ unsigned long flags; \ + spin_lock_irqsave(&dma_spin_lock, flags); \ + flags; \ +}) + +#define release_dma_lock(__flags) \ + spin_unlock_irqrestore(&dma_spin_lock, __flags); + +/* These are irrelevant for Sparc DMA, but we leave it in so that + * things can compile. + */ +#define MAX_DMA_CHANNELS 8 +#define DMA_MODE_READ 1 +#define DMA_MODE_WRITE 2 +#define MAX_DMA_ADDRESS (~0UL) + +/* Useful constants */ +#define SIZE_16MB (16*1024*1024) +#define SIZE_64K (64*1024) + +/* SBUS DMA controller reg offsets */ +#define DMA_CSR 0x00UL /* rw DMA control/status register 0x00 */ +#define DMA_ADDR 0x04UL /* rw DMA transfer address register 0x04 */ +#define DMA_COUNT 0x08UL /* rw DMA transfer count register 0x08 */ +#define DMA_TEST 0x0cUL /* rw DMA test/debug register 0x0c */ + +/* DVMA chip revisions */ +enum dvma_rev { + dvmarev0, + dvmaesc1, + dvmarev1, + dvmarev2, + dvmarev3, + dvmarevplus, + dvmahme +}; + +#define DMA_HASCOUNT(rev) ((rev)==dvmaesc1) + +/* Linux DMA information structure, filled during probe. */ +struct sbus_dma { + struct sbus_dma *next; + struct sbus_dev *sdev; + void __iomem *regs; + + /* Status, misc info */ + int node; /* Prom node for this DMA device */ + int running; /* Are we doing DMA now? */ + int allocated; /* Are we "owned" by anyone yet? */ + + /* Transfer information. */ + u32 addr; /* Start address of current transfer */ + int nbytes; /* Size of current transfer */ + int realbytes; /* For splitting up large transfers, etc. */ + + /* DMA revision */ + enum dvma_rev revision; +}; + +extern struct sbus_dma *dma_chain; + +/* Broken hardware... */ +#define DMA_ISBROKEN(dma) ((dma)->revision == dvmarev1) +#define DMA_ISESC1(dma) ((dma)->revision == dvmaesc1) + +/* Main routines in dma.c */ +extern void dvma_init(struct sbus_bus *); + +/* Fields in the cond_reg register */ +/* First, the version identification bits */ +#define DMA_DEVICE_ID 0xf0000000 /* Device identification bits */ +#define DMA_VERS0 0x00000000 /* Sunray DMA version */ +#define DMA_ESCV1 0x40000000 /* DMA ESC Version 1 */ +#define DMA_VERS1 0x80000000 /* DMA rev 1 */ +#define DMA_VERS2 0xa0000000 /* DMA rev 2 */ +#define DMA_VERHME 0xb0000000 /* DMA hme gate array */ +#define DMA_VERSPLUS 0x90000000 /* DMA rev 1 PLUS */ + +#define DMA_HNDL_INTR 0x00000001 /* An IRQ needs to be handled */ +#define DMA_HNDL_ERROR 0x00000002 /* We need to take an error */ +#define DMA_FIFO_ISDRAIN 0x0000000c /* The DMA FIFO is draining */ +#define DMA_INT_ENAB 0x00000010 /* Turn on interrupts */ +#define DMA_FIFO_INV 0x00000020 /* Invalidate the FIFO */ +#define DMA_ACC_SZ_ERR 0x00000040 /* The access size was bad */ +#define DMA_FIFO_STDRAIN 0x00000040 /* DMA_VERS1 Drain the FIFO */ +#define DMA_RST_SCSI 0x00000080 /* Reset the SCSI controller */ +#define DMA_RST_ENET DMA_RST_SCSI /* Reset the ENET controller */ +#define DMA_ST_WRITE 0x00000100 /* write from device to memory */ +#define DMA_ENABLE 0x00000200 /* Fire up DMA, handle requests */ +#define DMA_PEND_READ 0x00000400 /* DMA_VERS1/0/PLUS Pending Read */ +#define DMA_ESC_BURST 0x00000800 /* 1=16byte 0=32byte */ +#define DMA_READ_AHEAD 0x00001800 /* DMA read ahead partial longword */ +#define DMA_DSBL_RD_DRN 0x00001000 /* No EC drain on slave reads */ +#define DMA_BCNT_ENAB 0x00002000 /* If on, use the byte counter */ +#define DMA_TERM_CNTR 0x00004000 /* Terminal counter */ +#define DMA_SCSI_SBUS64 0x00008000 /* HME: Enable 64-bit SBUS mode. */ +#define DMA_CSR_DISAB 0x00010000 /* No FIFO drains during csr */ +#define DMA_SCSI_DISAB 0x00020000 /* No FIFO drains during reg */ +#define DMA_DSBL_WR_INV 0x00020000 /* No EC inval. on slave writes */ +#define DMA_ADD_ENABLE 0x00040000 /* Special ESC DVMA optimization */ +#define DMA_E_BURSTS 0x000c0000 /* ENET: SBUS r/w burst mask */ +#define DMA_E_BURST32 0x00040000 /* ENET: SBUS 32 byte r/w burst */ +#define DMA_E_BURST16 0x00000000 /* ENET: SBUS 16 byte r/w burst */ +#define DMA_BRST_SZ 0x000c0000 /* SCSI: SBUS r/w burst size */ +#define DMA_BRST64 0x000c0000 /* SCSI: 64byte bursts (HME on UltraSparc only) */ +#define DMA_BRST32 0x00040000 /* SCSI: 32byte bursts */ +#define DMA_BRST16 0x00000000 /* SCSI: 16byte bursts */ +#define DMA_BRST0 0x00080000 /* SCSI: no bursts (non-HME gate arrays) */ +#define DMA_ADDR_DISAB 0x00100000 /* No FIFO drains during addr */ +#define DMA_2CLKS 0x00200000 /* Each transfer = 2 clock ticks */ +#define DMA_3CLKS 0x00400000 /* Each transfer = 3 clock ticks */ +#define DMA_EN_ENETAUI DMA_3CLKS /* Put lance into AUI-cable mode */ +#define DMA_CNTR_DISAB 0x00800000 /* No IRQ when DMA_TERM_CNTR set */ +#define DMA_AUTO_NADDR 0x01000000 /* Use "auto nxt addr" feature */ +#define DMA_SCSI_ON 0x02000000 /* Enable SCSI dma */ +#define DMA_PARITY_OFF 0x02000000 /* HME: disable parity checking */ +#define DMA_LOADED_ADDR 0x04000000 /* Address has been loaded */ +#define DMA_LOADED_NADDR 0x08000000 /* Next address has been loaded */ +#define DMA_RESET_FAS366 0x08000000 /* HME: Assert RESET to FAS366 */ + +/* Values describing the burst-size property from the PROM */ +#define DMA_BURST1 0x01 +#define DMA_BURST2 0x02 +#define DMA_BURST4 0x04 +#define DMA_BURST8 0x08 +#define DMA_BURST16 0x10 +#define DMA_BURST32 0x20 +#define DMA_BURST64 0x40 +#define DMA_BURSTBITS 0x7f + +/* Determine highest possible final transfer address given a base */ +#define DMA_MAXEND(addr) (0x01000000UL-(((unsigned long)(addr))&0x00ffffffUL)) + +/* Yes, I hack a lot of elisp in my spare time... */ +#define DMA_ERROR_P(regs) (((sbus_readl((regs) + DMA_CSR) & DMA_HNDL_ERROR)) +#define DMA_IRQ_P(regs) (((sbus_readl((regs) + DMA_CSR)) & (DMA_HNDL_INTR | DMA_HNDL_ERROR))) +#define DMA_WRITE_P(regs) (((sbus_readl((regs) + DMA_CSR) & DMA_ST_WRITE)) +#define DMA_OFF(__regs) \ +do { u32 tmp = sbus_readl((__regs) + DMA_CSR); \ + tmp &= ~DMA_ENABLE; \ + sbus_writel(tmp, (__regs) + DMA_CSR); \ +} while(0) +#define DMA_INTSOFF(__regs) \ +do { u32 tmp = sbus_readl((__regs) + DMA_CSR); \ + tmp &= ~DMA_INT_ENAB; \ + sbus_writel(tmp, (__regs) + DMA_CSR); \ +} while(0) +#define DMA_INTSON(__regs) \ +do { u32 tmp = sbus_readl((__regs) + DMA_CSR); \ + tmp |= DMA_INT_ENAB; \ + sbus_writel(tmp, (__regs) + DMA_CSR); \ +} while(0) +#define DMA_PUNTFIFO(__regs) \ +do { u32 tmp = sbus_readl((__regs) + DMA_CSR); \ + tmp |= DMA_FIFO_INV; \ + sbus_writel(tmp, (__regs) + DMA_CSR); \ +} while(0) +#define DMA_SETSTART(__regs, __addr) \ + sbus_writel((u32)(__addr), (__regs) + DMA_ADDR); +#define DMA_BEGINDMA_W(__regs) \ +do { u32 tmp = sbus_readl((__regs) + DMA_CSR); \ + tmp |= (DMA_ST_WRITE|DMA_ENABLE|DMA_INT_ENAB); \ + sbus_writel(tmp, (__regs) + DMA_CSR); \ +} while(0) +#define DMA_BEGINDMA_R(__regs) \ +do { u32 tmp = sbus_readl((__regs) + DMA_CSR); \ + tmp |= (DMA_ENABLE|DMA_INT_ENAB); \ + tmp &= ~DMA_ST_WRITE; \ + sbus_writel(tmp, (__regs) + DMA_CSR); \ +} while(0) + +/* For certain DMA chips, we need to disable ints upon irq entry + * and turn them back on when we are done. So in any ESP interrupt + * handler you *must* call DMA_IRQ_ENTRY upon entry and DMA_IRQ_EXIT + * when leaving the handler. You have been warned... + */ +#define DMA_IRQ_ENTRY(dma, dregs) do { \ + if(DMA_ISBROKEN(dma)) DMA_INTSOFF(dregs); \ + } while (0) + +#define DMA_IRQ_EXIT(dma, dregs) do { \ + if(DMA_ISBROKEN(dma)) DMA_INTSON(dregs); \ + } while(0) + +#define for_each_dvma(dma) \ + for((dma) = dma_chain; (dma); (dma) = (dma)->next) + +extern int get_dma_list(char *); +extern int request_dma(unsigned int, __const__ char *); +extern void free_dma(unsigned int); + +/* From PCI */ + +#ifdef CONFIG_PCI +extern int isa_dma_bridge_buggy; +#else +#define isa_dma_bridge_buggy (0) +#endif + +#endif /* !(_ASM_SPARC64_DMA_H) */ |