diff options
Diffstat (limited to 'include/linux/amba/mmci.h')
| -rw-r--r-- | include/linux/amba/mmci.h | 42 |
1 files changed, 0 insertions, 42 deletions
diff --git a/include/linux/amba/mmci.h b/include/linux/amba/mmci.h index 32a89cf5ec4..8c98113069c 100644 --- a/include/linux/amba/mmci.h +++ b/include/linux/amba/mmci.h @@ -6,28 +6,9 @@ #include <linux/mmc/host.h> - -/* - * These defines is places here due to access is needed from machine - * configuration files. The ST Micro version does not have ROD and - * reuse the voltage registers for direction settings. - */ -#define MCI_ST_DATA2DIREN (1 << 2) -#define MCI_ST_CMDDIREN (1 << 3) -#define MCI_ST_DATA0DIREN (1 << 4) -#define MCI_ST_DATA31DIREN (1 << 5) -#define MCI_ST_FBCLKEN (1 << 7) -#define MCI_ST_DATA74DIREN (1 << 8) - -/* Just some dummy forwarding */ -struct dma_chan; - /** * struct mmci_platform_data - platform configuration for the MMCI * (also known as PL180) block. - * @f_max: the maximum operational frequency for this host in this - * platform configuration. When this is specified it takes precedence - * over the module parameter for the same frequency. * @ocr_mask: available voltages on the 4 pins from the block, this * is ignored if a regulator is used, see the MMC_VDD_* masks in * mmc/host.h @@ -42,37 +23,14 @@ struct dma_chan; * @gpio_wp: read this GPIO pin to see if the card is write protected * @gpio_cd: read this GPIO pin to detect card insertion * @cd_invert: true if the gpio_cd pin value is active low - * @capabilities: the capabilities of the block as implemented in - * this platform, signify anything MMC_CAP_* from mmc/host.h - * @capabilities2: more capabilities, MMC_CAP2_* from mmc/host.h - * @sigdir: a bit field indicating for what bits in the MMC bus the host - * should enable signal direction indication. - * @dma_filter: function used to select an appropriate RX and TX - * DMA channel to be used for DMA, if and only if you're deploying the - * generic DMA engine - * @dma_rx_param: parameter passed to the DMA allocation - * filter in order to select an appropriate RX channel. If - * there is a bidirectional RX+TX channel, then just specify - * this and leave dma_tx_param set to NULL - * @dma_tx_param: parameter passed to the DMA allocation - * filter in order to select an appropriate TX channel. If this - * is NULL the driver will attempt to use the RX channel as a - * bidirectional channel */ struct mmci_platform_data { - unsigned int f_max; unsigned int ocr_mask; int (*ios_handler)(struct device *, struct mmc_ios *); unsigned int (*status)(struct device *); int gpio_wp; int gpio_cd; bool cd_invert; - unsigned long capabilities; - unsigned long capabilities2; - u32 sigdir; - bool (*dma_filter)(struct dma_chan *chan, void *filter_param); - void *dma_rx_param; - void *dma_tx_param; }; #endif |