diff options
Diffstat (limited to 'include/linux/ethtool.h')
| -rw-r--r-- | include/linux/ethtool.h | 190 |
1 files changed, 139 insertions, 51 deletions
diff --git a/include/linux/ethtool.h b/include/linux/ethtool.h index 991269e5b15..6628a507fd3 100644 --- a/include/linux/ethtool.h +++ b/include/linux/ethtool.h @@ -14,6 +14,7 @@ #define _LINUX_ETHTOOL_H #include <linux/types.h> +#include <linux/if_ether.h> /* This should work for both 32 and 64 bit userland. */ struct ethtool_cmd { @@ -308,15 +309,28 @@ struct ethtool_perm_addr { * flag differs from the read-only value. */ enum ethtool_flags { + ETH_FLAG_TXVLAN = (1 << 7), /* TX VLAN offload enabled */ + ETH_FLAG_RXVLAN = (1 << 8), /* RX VLAN offload enabled */ ETH_FLAG_LRO = (1 << 15), /* LRO is enabled */ ETH_FLAG_NTUPLE = (1 << 27), /* N-tuple filters enabled */ ETH_FLAG_RXHASH = (1 << 28), }; /* The following structures are for supporting RX network flow - * classification configuration. Note, all multibyte fields, e.g., - * ip4src, ip4dst, psrc, pdst, spi, etc. are expected to be in network - * byte order. + * classification and RX n-tuple configuration. Note, all multibyte + * fields, e.g., ip4src, ip4dst, psrc, pdst, spi, etc. are expected to + * be in network byte order. + */ + +/** + * struct ethtool_tcpip4_spec - flow specification for TCP/IPv4 etc. + * @ip4src: Source host + * @ip4dst: Destination host + * @psrc: Source port + * @pdst: Destination port + * @tos: Type-of-service + * + * This can be used to specify a TCP/IPv4, UDP/IPv4 or SCTP/IPv4 flow. */ struct ethtool_tcpip4_spec { __be32 ip4src; @@ -326,6 +340,15 @@ struct ethtool_tcpip4_spec { __u8 tos; }; +/** + * struct ethtool_ah_espip4_spec - flow specification for IPsec/IPv4 + * @ip4src: Source host + * @ip4dst: Destination host + * @spi: Security parameters index + * @tos: Type-of-service + * + * This can be used to specify an IPsec transport or tunnel over IPv4. + */ struct ethtool_ah_espip4_spec { __be32 ip4src; __be32 ip4dst; @@ -333,21 +356,17 @@ struct ethtool_ah_espip4_spec { __u8 tos; }; -struct ethtool_rawip4_spec { - __be32 ip4src; - __be32 ip4dst; - __u8 hdata[64]; -}; - -struct ethtool_ether_spec { - __be16 ether_type; - __u8 frame_size; - __u8 eframe[16]; -}; - #define ETH_RX_NFC_IP4 1 -#define ETH_RX_NFC_IP6 2 +/** + * struct ethtool_usrip4_spec - general flow specification for IPv4 + * @ip4src: Source host + * @ip4dst: Destination host + * @l4_4_bytes: First 4 bytes of transport (layer 4) header + * @tos: Type-of-service + * @ip_ver: Value must be %ETH_RX_NFC_IP4; mask must be 0 + * @proto: Transport protocol number; mask must be 0 + */ struct ethtool_usrip4_spec { __be32 ip4src; __be32 ip4dst; @@ -357,6 +376,15 @@ struct ethtool_usrip4_spec { __u8 proto; }; +/** + * struct ethtool_rx_flow_spec - specification for RX flow filter + * @flow_type: Type of match to perform, e.g. %TCP_V4_FLOW + * @h_u: Flow fields to match (dependent on @flow_type) + * @m_u: Masks for flow field bits to be ignored + * @ring_cookie: RX ring/queue index to deliver to, or %RX_CLS_FLOW_DISC + * if packets should be discarded + * @location: Index of filter in hardware table + */ struct ethtool_rx_flow_spec { __u32 flow_type; union { @@ -365,36 +393,91 @@ struct ethtool_rx_flow_spec { struct ethtool_tcpip4_spec sctp_ip4_spec; struct ethtool_ah_espip4_spec ah_ip4_spec; struct ethtool_ah_espip4_spec esp_ip4_spec; - struct ethtool_rawip4_spec raw_ip4_spec; - struct ethtool_ether_spec ether_spec; struct ethtool_usrip4_spec usr_ip4_spec; - __u8 hdata[64]; - } h_u, m_u; /* entry, mask */ + struct ethhdr ether_spec; + __u8 hdata[72]; + } h_u, m_u; __u64 ring_cookie; __u32 location; }; +/** + * struct ethtool_rxnfc - command to get or set RX flow classification rules + * @cmd: Specific command number - %ETHTOOL_GRXFH, %ETHTOOL_SRXFH, + * %ETHTOOL_GRXRINGS, %ETHTOOL_GRXCLSRLCNT, %ETHTOOL_GRXCLSRULE, + * %ETHTOOL_GRXCLSRLALL, %ETHTOOL_SRXCLSRLDEL or %ETHTOOL_SRXCLSRLINS + * @flow_type: Type of flow to be affected, e.g. %TCP_V4_FLOW + * @data: Command-dependent value + * @fs: Flow filter specification + * @rule_cnt: Number of rules to be affected + * @rule_locs: Array of valid rule indices + * + * For %ETHTOOL_GRXFH and %ETHTOOL_SRXFH, @data is a bitmask indicating + * the fields included in the flow hash, e.g. %RXH_IP_SRC. The following + * structure fields must not be used. + * + * For %ETHTOOL_GRXRINGS, @data is set to the number of RX rings/queues + * on return. + * + * For %ETHTOOL_GRXCLSRLCNT, @rule_cnt is set to the number of defined + * rules on return. + * + * For %ETHTOOL_GRXCLSRULE, @fs.@location specifies the index of an + * existing filter rule on entry and @fs contains the rule on return. + * + * For %ETHTOOL_GRXCLSRLALL, @rule_cnt specifies the array size of the + * user buffer for @rule_locs on entry. On return, @data is the size + * of the filter table and @rule_locs contains the indices of the + * defined rules. + * + * For %ETHTOOL_SRXCLSRLINS, @fs specifies the filter rule to add or + * update. @fs.@location specifies the index to use and must not be + * ignored. + * + * For %ETHTOOL_SRXCLSRLDEL, @fs.@location specifies the index of an + * existing filter rule on entry. + * + * Implementation of indexed classification rules generally requires a + * TCAM. + */ struct ethtool_rxnfc { __u32 cmd; __u32 flow_type; - /* The rx flow hash value or the rule DB size */ __u64 data; - /* The following fields are not valid and must not be used for - * the ETHTOOL_{G,X}RXFH commands. */ struct ethtool_rx_flow_spec fs; __u32 rule_cnt; __u32 rule_locs[0]; }; +/** + * struct ethtool_rxfh_indir - command to get or set RX flow hash indirection + * @cmd: Specific command number - %ETHTOOL_GRXFHINDIR or %ETHTOOL_SRXFHINDIR + * @size: On entry, the array size of the user buffer. On return from + * %ETHTOOL_GRXFHINDIR, the array size of the hardware indirection table. + * @ring_index: RX ring/queue index for each hash value + */ struct ethtool_rxfh_indir { __u32 cmd; - /* On entry, this is the array size of the user buffer. On - * return from ETHTOOL_GRXFHINDIR, this is the array size of - * the hardware indirection table. */ __u32 size; - __u32 ring_index[0]; /* ring/queue index for each hash value */ + __u32 ring_index[0]; }; +/** + * struct ethtool_rx_ntuple_flow_spec - specification for RX flow filter + * @flow_type: Type of match to perform, e.g. %TCP_V4_FLOW + * @h_u: Flow field values to match (dependent on @flow_type) + * @m_u: Masks for flow field value bits to be ignored + * @vlan_tag: VLAN tag to match + * @vlan_tag_mask: Mask for VLAN tag bits to be ignored + * @data: Driver-dependent data to match + * @data_mask: Mask for driver-dependent data bits to be ignored + * @action: RX ring/queue index to deliver to (non-negative) or other action + * (negative, e.g. %ETHTOOL_RXNTUPLE_ACTION_DROP) + * + * For flow types %TCP_V4_FLOW, %UDP_V4_FLOW and %SCTP_V4_FLOW, where + * a field value and mask are both zero this is treated as if all mask + * bits are set i.e. the field is ignored. + */ struct ethtool_rx_ntuple_flow_spec { __u32 flow_type; union { @@ -403,22 +486,26 @@ struct ethtool_rx_ntuple_flow_spec { struct ethtool_tcpip4_spec sctp_ip4_spec; struct ethtool_ah_espip4_spec ah_ip4_spec; struct ethtool_ah_espip4_spec esp_ip4_spec; - struct ethtool_rawip4_spec raw_ip4_spec; - struct ethtool_ether_spec ether_spec; struct ethtool_usrip4_spec usr_ip4_spec; - __u8 hdata[64]; - } h_u, m_u; /* entry, mask */ + struct ethhdr ether_spec; + __u8 hdata[72]; + } h_u, m_u; __u16 vlan_tag; __u16 vlan_tag_mask; - __u64 data; /* user-defined flow spec data */ - __u64 data_mask; /* user-defined flow spec mask */ + __u64 data; + __u64 data_mask; - /* signed to distinguish between queue and actions (DROP) */ __s32 action; -#define ETHTOOL_RXNTUPLE_ACTION_DROP -1 +#define ETHTOOL_RXNTUPLE_ACTION_DROP (-1) /* drop packet */ +#define ETHTOOL_RXNTUPLE_ACTION_CLEAR (-2) /* clear filter */ }; +/** + * struct ethtool_rx_ntuple - command to set or clear RX flow filter + * @cmd: Command number - %ETHTOOL_SRXNTUPLE + * @fs: Flow filter specification + */ struct ethtool_rx_ntuple { __u32 cmd; struct ethtool_rx_ntuple_flow_spec fs; @@ -759,22 +846,23 @@ struct ethtool_ops { #define WAKE_MAGIC (1 << 5) #define WAKE_MAGICSECURE (1 << 6) /* only meaningful if WAKE_MAGIC */ -/* L3-L4 network traffic flow types */ -#define TCP_V4_FLOW 0x01 -#define UDP_V4_FLOW 0x02 -#define SCTP_V4_FLOW 0x03 -#define AH_ESP_V4_FLOW 0x04 -#define TCP_V6_FLOW 0x05 -#define UDP_V6_FLOW 0x06 -#define SCTP_V6_FLOW 0x07 -#define AH_ESP_V6_FLOW 0x08 -#define AH_V4_FLOW 0x09 -#define ESP_V4_FLOW 0x0a -#define AH_V6_FLOW 0x0b -#define ESP_V6_FLOW 0x0c -#define IP_USER_FLOW 0x0d -#define IPV4_FLOW 0x10 -#define IPV6_FLOW 0x11 +/* L2-L4 network traffic flow types */ +#define TCP_V4_FLOW 0x01 /* hash or spec (tcp_ip4_spec) */ +#define UDP_V4_FLOW 0x02 /* hash or spec (udp_ip4_spec) */ +#define SCTP_V4_FLOW 0x03 /* hash or spec (sctp_ip4_spec) */ +#define AH_ESP_V4_FLOW 0x04 /* hash only */ +#define TCP_V6_FLOW 0x05 /* hash only */ +#define UDP_V6_FLOW 0x06 /* hash only */ +#define SCTP_V6_FLOW 0x07 /* hash only */ +#define AH_ESP_V6_FLOW 0x08 /* hash only */ +#define AH_V4_FLOW 0x09 /* hash or spec (ah_ip4_spec) */ +#define ESP_V4_FLOW 0x0a /* hash or spec (esp_ip4_spec) */ +#define AH_V6_FLOW 0x0b /* hash only */ +#define ESP_V6_FLOW 0x0c /* hash only */ +#define IP_USER_FLOW 0x0d /* spec only (usr_ip4_spec) */ +#define IPV4_FLOW 0x10 /* hash only */ +#define IPV6_FLOW 0x11 /* hash only */ +#define ETHER_FLOW 0x12 /* spec only (ether_spec) */ /* L3-L4 network traffic flow hash options */ #define RXH_L2DA (1 << 1) |