diff options
Diffstat (limited to 'include/linux/libata.h')
| -rw-r--r-- | include/linux/libata.h | 52 |
1 files changed, 15 insertions, 37 deletions
diff --git a/include/linux/libata.h b/include/linux/libata.h index b3f32eadbef..ab275483032 100644 --- a/include/linux/libata.h +++ b/include/linux/libata.h @@ -140,6 +140,7 @@ enum { ATA_DFLAG_LBA48 = (1 << 1), /* device supports LBA48 */ ATA_DFLAG_CDB_INTR = (1 << 2), /* device asserts INTRQ when ready for CDB */ ATA_DFLAG_NCQ = (1 << 3), /* device supports NCQ */ + ATA_DFLAG_FLUSH_EXT = (1 << 4), /* do FLUSH_EXT instead of FLUSH */ ATA_DFLAG_CFG_MASK = (1 << 8) - 1, ATA_DFLAG_PIO = (1 << 8), /* device limited to PIO mode */ @@ -175,6 +176,7 @@ enum { ATA_FLAG_SKIP_D2H_BSY = (1 << 12), /* can't wait for the first D2H * Register FIS clearing BSY */ ATA_FLAG_DEBUGMSG = (1 << 13), + ATA_FLAG_SETXFER_POLLING= (1 << 14), /* use polling for SETXFER */ /* The following flag belongs to ap->pflags but is kept in * ap->flags because it's referenced in many LLDs and will be @@ -283,6 +285,9 @@ enum { ATA_EHI_QUIET = (1 << 3), /* be quiet */ ATA_EHI_DID_RESET = (1 << 16), /* already reset this port */ + ATA_EHI_PRINTINFO = (1 << 17), /* print configuration info */ + ATA_EHI_SETMODE = (1 << 18), /* configure transfer mode */ + ATA_EHI_POST_SETMODE = (1 << 19), /* revaildating after setmode */ ATA_EHI_RESET_MODIFIER_MASK = ATA_EHI_RESUME_LINK, @@ -307,10 +312,11 @@ enum { (some horkage may be drive/controller pair dependant */ ATA_HORKAGE_DIAGNOSTIC = (1 << 0), /* Failed boot diag */ + ATA_HORKAGE_NODMA = (1 << 1), /* DMA problems */ + ATA_HORKAGE_NONCQ = (1 << 2), /* Don't use NCQ */ }; enum hsm_task_states { - HSM_ST_UNKNOWN, /* state unknown */ HSM_ST_IDLE, /* no command on going */ HSM_ST, /* (waiting the device to) transfer data */ HSM_ST_LAST, /* (waiting the device to) complete command */ @@ -329,6 +335,7 @@ enum ata_completion_errors { AC_ERR_SYSTEM = (1 << 6), /* system error */ AC_ERR_INVALID = (1 << 7), /* invalid argument */ AC_ERR_OTHER = (1 << 8), /* unknown */ + AC_ERR_NODEV_HINT = (1 << 9), /* polling device detection hint */ }; /* forward declarations */ @@ -701,6 +708,8 @@ extern int sata_phy_debounce(struct ata_port *ap, const unsigned long *param); extern int sata_phy_resume(struct ata_port *ap, const unsigned long *param); extern int ata_std_prereset(struct ata_port *ap); extern int ata_std_softreset(struct ata_port *ap, unsigned int *classes); +extern int sata_port_hardreset(struct ata_port *ap, + const unsigned long *timing); extern int sata_std_hardreset(struct ata_port *ap, unsigned int *class); extern void ata_std_postreset(struct ata_port *ap, unsigned int *classes); extern void ata_port_disable(struct ata_port *); @@ -745,9 +754,8 @@ extern int ata_scsi_device_suspend(struct scsi_device *, pm_message_t mesg); extern int ata_host_suspend(struct ata_host *host, pm_message_t mesg); extern void ata_host_resume(struct ata_host *host); extern int ata_ratelimit(void); -extern unsigned int ata_busy_sleep(struct ata_port *ap, - unsigned long timeout_pat, - unsigned long timeout); +extern int ata_busy_sleep(struct ata_port *ap, + unsigned long timeout_pat, unsigned long timeout); extern void ata_port_queue_task(struct ata_port *ap, work_func_t fn, void *data, unsigned long delay); extern u32 ata_wait_register(void __iomem *reg, u32 mask, u32 val, @@ -788,6 +796,7 @@ extern void ata_id_string(const u16 *id, unsigned char *s, unsigned int ofs, unsigned int len); extern void ata_id_c_string(const u16 *id, unsigned char *s, unsigned int ofs, unsigned int len); +extern unsigned long ata_device_blacklisted(const struct ata_device *dev); extern void ata_bmdma_setup (struct ata_queued_cmd *qc); extern void ata_bmdma_start (struct ata_queued_cmd *qc); extern void ata_bmdma_stop(struct ata_queued_cmd *qc); @@ -1062,7 +1071,7 @@ static inline u8 ata_busy_wait(struct ata_port *ap, unsigned int bits, udelay(10); status = ata_chk_status(ap); max--; - } while ((status & bits) && (max > 0)); + } while (status != 0xff && (status & bits) && (max > 0)); return status; } @@ -1083,7 +1092,7 @@ static inline u8 ata_wait_idle(struct ata_port *ap) { u8 status = ata_busy_wait(ap, ATA_BUSY | ATA_DRQ, 1000); - if (status & (ATA_BUSY | ATA_DRQ)) { + if (status != 0xff && (status & (ATA_BUSY | ATA_DRQ))) { unsigned long l = ap->ioaddr.status_addr; if (ata_msg_warn(ap)) printk(KERN_WARNING "ATA: abnormal status 0x%X on port 0x%lX\n", @@ -1149,37 +1158,6 @@ static inline void ata_qc_reinit(struct ata_queued_cmd *qc) } /** - * ata_irq_on - Enable interrupts on a port. - * @ap: Port on which interrupts are enabled. - * - * Enable interrupts on a legacy IDE device using MMIO or PIO, - * wait for idle, clear any pending interrupts. - * - * LOCKING: - * Inherited from caller. - */ - -static inline u8 ata_irq_on(struct ata_port *ap) -{ - struct ata_ioports *ioaddr = &ap->ioaddr; - u8 tmp; - - ap->ctl &= ~ATA_NIEN; - ap->last_ctl = ap->ctl; - - if (ap->flags & ATA_FLAG_MMIO) - writeb(ap->ctl, (void __iomem *) ioaddr->ctl_addr); - else - outb(ap->ctl, ioaddr->ctl_addr); - tmp = ata_wait_idle(ap); - - ap->ops->irq_clear(ap); - - return tmp; -} - - -/** * ata_irq_ack - Acknowledge a device interrupt. * @ap: Port on which interrupts are enabled. * |