diff options
Diffstat (limited to 'include/linux/pinctrl')
| -rw-r--r-- | include/linux/pinctrl/pinconf-generic.h | 12 |
1 files changed, 6 insertions, 6 deletions
diff --git a/include/linux/pinctrl/pinconf-generic.h b/include/linux/pinctrl/pinconf-generic.h index 72474e18f1e..6aa23809662 100644 --- a/include/linux/pinctrl/pinconf-generic.h +++ b/include/linux/pinctrl/pinconf-generic.h @@ -37,17 +37,17 @@ * if it is 0, pull-down is disabled. * @PIN_CONFIG_DRIVE_PUSH_PULL: the pin will be driven actively high and * low, this is the most typical case and is typically achieved with two - * active transistors on the output. Sending this config will enabale + * active transistors on the output. Setting this config will enable * push-pull mode, the argument is ignored. * @PIN_CONFIG_DRIVE_OPEN_DRAIN: the pin will be driven with open drain (open * collector) which means it is usually wired with other output ports - * which are then pulled up with an external resistor. Sending this - * config will enabale open drain mode, the argument is ignored. + * which are then pulled up with an external resistor. Setting this + * config will enable open drain mode, the argument is ignored. * @PIN_CONFIG_DRIVE_OPEN_SOURCE: the pin will be driven with open source - * (open emitter). Sending this config will enabale open drain mode, the + * (open emitter). Setting this config will enable open drain mode, the * argument is ignored. - * @PIN_CONFIG_DRIVE_STRENGTH: the pin will output the current passed as - * argument. The argument is in mA. + * @PIN_CONFIG_DRIVE_STRENGTH: the pin will sink or source at most the current + * passed as argument. The argument is in mA. * @PIN_CONFIG_INPUT_SCHMITT_ENABLE: control schmitt-trigger mode on the pin. * If the argument != 0, schmitt-trigger mode is enabled. If it's 0, * schmitt-trigger mode is disabled. |