diff options
Diffstat (limited to 'include/linux/regulator/driver.h')
| -rw-r--r-- | include/linux/regulator/driver.h | 30 |
1 files changed, 30 insertions, 0 deletions
diff --git a/include/linux/regulator/driver.h b/include/linux/regulator/driver.h index b0432cc2b16..bac4c871f3b 100644 --- a/include/linux/regulator/driver.h +++ b/include/linux/regulator/driver.h @@ -32,6 +32,8 @@ enum regulator_status { REGULATOR_STATUS_NORMAL, REGULATOR_STATUS_IDLE, REGULATOR_STATUS_STANDBY, + /* in case that any other status doesn't apply */ + REGULATOR_STATUS_UNDEFINED, }; /** @@ -67,6 +69,8 @@ enum regulator_status { * * @enable_time: Time taken for the regulator voltage output voltage to * stabilise after being enabled, in microseconds. + * @set_ramp_delay: Set the ramp delay for the regulator. The driver should + * select ramp delay equal to or less than(closest) ramp_delay. * @set_voltage_time_sel: Time taken for the regulator voltage output voltage * to stabilise after being set to a new value, in microseconds. * The function provides the from and to voltage selector, the @@ -113,6 +117,7 @@ struct regulator_ops { /* Time taken to enable or set voltage on the regulator */ int (*enable_time) (struct regulator_dev *); + int (*set_ramp_delay) (struct regulator_dev *, int ramp_delay); int (*set_voltage_time_sel) (struct regulator_dev *, unsigned int old_selector, unsigned int new_selector); @@ -170,11 +175,15 @@ enum regulator_type { * * @min_uV: Voltage given by the lowest selector (if linear mapping) * @uV_step: Voltage increase with each selector (if linear mapping) + * @ramp_delay: Time to settle down after voltage change (unit: uV/us) + * @volt_table: Voltage mapping table (if table based mapping) * * @vsel_reg: Register for selector when using regulator_regmap_X_voltage_ * @vsel_mask: Mask for register bitfield used for selector * @enable_reg: Register for control when using regmap enable/disable ops * @enable_mask: Mask for control when using regmap enable/disable ops + * + * @enable_time: Time taken for initial enable of regulator (in uS). */ struct regulator_desc { const char *name; @@ -188,11 +197,16 @@ struct regulator_desc { unsigned int min_uV; unsigned int uV_step; + unsigned int ramp_delay; + + const unsigned int *volt_table; unsigned int vsel_reg; unsigned int vsel_mask; unsigned int enable_reg; unsigned int enable_mask; + + unsigned int enable_time; }; /** @@ -208,6 +222,9 @@ struct regulator_desc { * @of_node: OpenFirmware node to parse for device tree bindings (may be * NULL). * @regmap: regmap to use for core regmap helpers + * @ena_gpio: GPIO controlling regulator enable. + * @ena_gpio_invert: Sense for GPIO enable control. + * @ena_gpio_flags: Flags to use when calling gpio_request_one() */ struct regulator_config { struct device *dev; @@ -215,6 +232,10 @@ struct regulator_config { void *driver_data; struct device_node *of_node; struct regmap *regmap; + + int ena_gpio; + unsigned int ena_gpio_invert:1; + unsigned int ena_gpio_flags; }; /* @@ -253,6 +274,10 @@ struct regulator_dev { void *reg_data; /* regulator_dev data */ struct dentry *debugfs; + + int ena_gpio; + unsigned int ena_gpio_invert:1; + unsigned int ena_gpio_state:1; }; struct regulator_dev * @@ -271,6 +296,8 @@ int regulator_mode_to_status(unsigned int); int regulator_list_voltage_linear(struct regulator_dev *rdev, unsigned int selector); +int regulator_list_voltage_table(struct regulator_dev *rdev, + unsigned int selector); int regulator_map_voltage_linear(struct regulator_dev *rdev, int min_uV, int max_uV); int regulator_map_voltage_iterate(struct regulator_dev *rdev, @@ -280,6 +307,9 @@ int regulator_set_voltage_sel_regmap(struct regulator_dev *rdev, unsigned sel); int regulator_is_enabled_regmap(struct regulator_dev *rdev); int regulator_enable_regmap(struct regulator_dev *rdev); int regulator_disable_regmap(struct regulator_dev *rdev); +int regulator_set_voltage_time_sel(struct regulator_dev *rdev, + unsigned int old_selector, + unsigned int new_selector); void *regulator_get_init_drvdata(struct regulator_init_data *reg_init_data); |