diff options
Diffstat (limited to 'include/linux/regulator')
| -rw-r--r-- | include/linux/regulator/consumer.h | 13 | ||||
| -rw-r--r-- | include/linux/regulator/driver.h | 5 | ||||
| -rw-r--r-- | include/linux/regulator/max8973-regulator.h | 72 | ||||
| -rw-r--r-- | include/linux/regulator/tps51632-regulator.h | 47 | ||||
| -rw-r--r-- | include/linux/regulator/tps65090-regulator.h | 50 |
5 files changed, 137 insertions, 50 deletions
diff --git a/include/linux/regulator/consumer.h b/include/linux/regulator/consumer.h index c43cd3556b1..7bc732ce6e5 100644 --- a/include/linux/regulator/consumer.h +++ b/include/linux/regulator/consumer.h @@ -160,6 +160,7 @@ int regulator_bulk_force_disable(int num_consumers, void regulator_bulk_free(int num_consumers, struct regulator_bulk_data *consumers); +int regulator_can_change_voltage(struct regulator *regulator); int regulator_count_voltages(struct regulator *regulator); int regulator_list_voltage(struct regulator *regulator, unsigned selector); int regulator_is_supported_voltage(struct regulator *regulator, @@ -358,6 +359,10 @@ static inline void regulator_set_drvdata(struct regulator *regulator, { } +static inline int regulator_count_voltages(struct regulator *regulator) +{ + return 0; +} #endif static inline int regulator_set_voltage_tol(struct regulator *regulator, @@ -367,4 +372,12 @@ static inline int regulator_set_voltage_tol(struct regulator *regulator, new_uV - tol_uV, new_uV + tol_uV); } +static inline int regulator_is_supported_voltage_tol(struct regulator *regulator, + int target_uV, int tol_uV) +{ + return regulator_is_supported_voltage(regulator, + target_uV - tol_uV, + target_uV + tol_uV); +} + #endif diff --git a/include/linux/regulator/driver.h b/include/linux/regulator/driver.h index 7932a3bf21b..d10bb0f39c5 100644 --- a/include/linux/regulator/driver.h +++ b/include/linux/regulator/driver.h @@ -181,10 +181,13 @@ enum regulator_type { * @type: Indicates if the regulator is a voltage or current regulator. * @owner: Module providing the regulator, used for refcounting. * + * @continuous_voltage_range: Indicates if the regulator can set any + * voltage within constrains range. * @n_voltages: Number of selectors available for ops.list_voltage(). * * @min_uV: Voltage given by the lowest selector (if linear mapping) * @uV_step: Voltage increase with each selector (if linear mapping) + * @linear_min_sel: Minimal selector for starting linear mapping * @ramp_delay: Time to settle down after voltage change (unit: uV/us) * @volt_table: Voltage mapping table (if table based mapping) * @@ -199,6 +202,7 @@ struct regulator_desc { const char *name; const char *supply_name; int id; + bool continuous_voltage_range; unsigned n_voltages; struct regulator_ops *ops; int irq; @@ -207,6 +211,7 @@ struct regulator_desc { unsigned int min_uV; unsigned int uV_step; + unsigned int linear_min_sel; unsigned int ramp_delay; const unsigned int *volt_table; diff --git a/include/linux/regulator/max8973-regulator.h b/include/linux/regulator/max8973-regulator.h new file mode 100644 index 00000000000..f8acc052e35 --- /dev/null +++ b/include/linux/regulator/max8973-regulator.h @@ -0,0 +1,72 @@ +/* + * max8973-regulator.h -- MAXIM 8973 regulator + * + * Interface for regulator driver for MAXIM 8973 DC-DC step-down + * switching regulator. + * + * Copyright (C) 2012 NVIDIA Corporation + + * Author: Laxman Dewangan <ldewangan@nvidia.com> + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License as published by + * the Free Software Foundation; either version 2 of the License, or + * (at your option) any later version. + * + * This program is distributed in the hope that it will be useful, but WITHOUT + * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or + * FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for + * more details. + * + * You should have received a copy of the GNU General Public License along + * with this program; if not, write to the Free Software Foundation, Inc., + * 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301, USA. + * + */ + +#ifndef __LINUX_REGULATOR_MAX8973_H +#define __LINUX_REGULATOR_MAX8973_H + +/* + * Control flags for configuration of the device. + * Client need to pass this information with ORed + */ +#define MAX8973_CONTROL_REMOTE_SENSE_ENABLE 0x00000001 +#define MAX8973_CONTROL_FALLING_SLEW_RATE_ENABLE 0x00000002 +#define MAX8973_CONTROL_OUTPUT_ACTIVE_DISCH_ENABLE 0x00000004 +#define MAX8973_CONTROL_BIAS_ENABLE 0x00000008 +#define MAX8973_CONTROL_PULL_DOWN_ENABLE 0x00000010 +#define MAX8973_CONTROL_FREQ_SHIFT_9PER_ENABLE 0x00000020 + +#define MAX8973_CONTROL_CLKADV_TRIP_DISABLED 0x00000000 +#define MAX8973_CONTROL_CLKADV_TRIP_75mV_PER_US 0x00010000 +#define MAX8973_CONTROL_CLKADV_TRIP_150mV_PER_US 0x00020000 +#define MAX8973_CONTROL_CLKADV_TRIP_75mV_PER_US_HIST_DIS 0x00030000 + +#define MAX8973_CONTROL_INDUCTOR_VALUE_NOMINAL 0x00000000 +#define MAX8973_CONTROL_INDUCTOR_VALUE_MINUS_30_PER 0x00100000 +#define MAX8973_CONTROL_INDUCTOR_VALUE_PLUS_30_PER 0x00200000 +#define MAX8973_CONTROL_INDUCTOR_VALUE_PLUS_60_PER 0x00300000 + +/* + * struct max8973_regulator_platform_data - max8973 regulator platform data. + * + * @reg_init_data: The regulator init data. + * @control_flags: Control flags which are ORed value of above flags to + * configure device. + * @enable_ext_control: Enable the voltage enable/disable through external + * control signal from EN input pin. If it is false then + * voltage output will be enabled/disabled through EN bit of + * device register. + * @dvs_gpio: GPIO for dvs. It should be -1 if this is tied with fixed logic. + * @dvs_def_state: Default state of dvs. 1 if it is high else 0. + */ +struct max8973_regulator_platform_data { + struct regulator_init_data *reg_init_data; + unsigned long control_flags; + bool enable_ext_control; + int dvs_gpio; + unsigned dvs_def_state:1; +}; + +#endif /* __LINUX_REGULATOR_MAX8973_H */ diff --git a/include/linux/regulator/tps51632-regulator.h b/include/linux/regulator/tps51632-regulator.h new file mode 100644 index 00000000000..d00841e1a75 --- /dev/null +++ b/include/linux/regulator/tps51632-regulator.h @@ -0,0 +1,47 @@ +/* + * tps51632-regulator.h -- TPS51632 regulator + * + * Interface for regulator driver for TPS51632 3-2-1 Phase D-Cap Step Down + * Driverless Controller with serial VID control and DVFS. + * + * Copyright (C) 2012 NVIDIA Corporation + + * Author: Laxman Dewangan <ldewangan@nvidia.com> + * + * This program is free software; you can redistribute it and/or modify + * it under the terms of the GNU General Public License as published by + * the Free Software Foundation; either version 2 of the License, or + * (at your option) any later version. + * + * This program is distributed in the hope that it will be useful, but WITHOUT + * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or + * FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for + * more details. + * + * You should have received a copy of the GNU General Public License along + * with this program; if not, write to the Free Software Foundation, Inc., + * 51 Franklin Street, Fifth Floor, Boston, MA 02110-1301, USA. + * + */ + +#ifndef __LINUX_REGULATOR_TPS51632_H +#define __LINUX_REGULATOR_TPS51632_H + +/* + * struct tps51632_regulator_platform_data - tps51632 regulator platform data. + * + * @reg_init_data: The regulator init data. + * @enable_pwm_dvfs: Enable PWM DVFS or not. + * @dvfs_step_20mV: Step for DVFS is 20mV or 10mV. + * @max_voltage_uV: Maximum possible voltage in PWM-DVFS mode. + * @base_voltage_uV: Base voltage when PWM-DVFS enabled. + */ +struct tps51632_regulator_platform_data { + struct regulator_init_data *reg_init_data; + bool enable_pwm_dvfs; + bool dvfs_step_20mV; + int max_voltage_uV; + int base_voltage_uV; +}; + +#endif /* __LINUX_REGULATOR_TPS51632_H */ diff --git a/include/linux/regulator/tps65090-regulator.h b/include/linux/regulator/tps65090-regulator.h deleted file mode 100644 index 0fa04b64db3..00000000000 --- a/include/linux/regulator/tps65090-regulator.h +++ /dev/null @@ -1,50 +0,0 @@ -/* - * Regulator driver interface for TI TPS65090 PMIC family - * - * Copyright (c) 2012, NVIDIA CORPORATION. All rights reserved. - - * This program is free software; you can redistribute it and/or modify it - * under the terms and conditions of the GNU General Public License, - * version 2, as published by the Free Software Foundation. - - * This program is distributed in the hope it will be useful, but WITHOUT - * ANY WARRANTY; without even the implied warranty of MERCHANTABILITY or - * FITNESS FOR A PARTICULAR PURPOSE. See the GNU General Public License for - * more details. - - * You should have received a copy of the GNU General Public License - * along with this program. If not, see <http://www.gnu.org/licenses/>. - */ - -#ifndef __REGULATOR_TPS65090_H -#define __REGULATOR_TPS65090_H - -#include <linux/regulator/machine.h> - -#define tps65090_rails(_name) "tps65090_"#_name - -enum { - TPS65090_ID_DCDC1, - TPS65090_ID_DCDC2, - TPS65090_ID_DCDC3, - TPS65090_ID_FET1, - TPS65090_ID_FET2, - TPS65090_ID_FET3, - TPS65090_ID_FET4, - TPS65090_ID_FET5, - TPS65090_ID_FET6, - TPS65090_ID_FET7, -}; - -/* - * struct tps65090_regulator_platform_data - * - * @regulator: The regulator init data. - * @slew_rate_uV_per_us: Slew rate microvolt per microsec. - */ - -struct tps65090_regulator_platform_data { - struct regulator_init_data regulator; -}; - -#endif /* __REGULATOR_TPS65090_H */ |