diff options
Diffstat (limited to 'include/net/cfg80211.h')
| -rw-r--r-- | include/net/cfg80211.h | 58 |
1 files changed, 45 insertions, 13 deletions
diff --git a/include/net/cfg80211.h b/include/net/cfg80211.h index 6b2af7aeddd..0d5979924be 100644 --- a/include/net/cfg80211.h +++ b/include/net/cfg80211.h @@ -258,13 +258,9 @@ struct ieee80211_supported_band { /** * struct vif_params - describes virtual interface parameters - * @mesh_id: mesh ID to use - * @mesh_id_len: length of the mesh ID * @use_4addr: use 4-address frames */ struct vif_params { - u8 *mesh_id; - int mesh_id_len; int use_4addr; }; @@ -424,6 +420,7 @@ struct station_parameters { * @STATION_INFO_TX_RETRIES: @tx_retries filled * @STATION_INFO_TX_FAILED: @tx_failed filled * @STATION_INFO_RX_DROP_MISC: @rx_dropped_misc filled + * @STATION_INFO_SIGNAL_AVG: @signal_avg filled */ enum station_info_flags { STATION_INFO_INACTIVE_TIME = 1<<0, @@ -439,6 +436,7 @@ enum station_info_flags { STATION_INFO_TX_RETRIES = 1<<10, STATION_INFO_TX_FAILED = 1<<11, STATION_INFO_RX_DROP_MISC = 1<<12, + STATION_INFO_SIGNAL_AVG = 1<<13, }; /** @@ -485,6 +483,7 @@ struct rate_info { * @plid: mesh peer link id * @plink_state: mesh peer link state * @signal: signal strength of last received packet in dBm + * @signal_avg: signal strength average in dBm * @txrate: current unicast bitrate to this station * @rx_packets: packets received from this station * @tx_packets: packets transmitted to this station @@ -505,6 +504,7 @@ struct station_info { u16 plid; u8 plink_state; s8 signal; + s8 signal_avg; struct rate_info txrate; u32 rx_packets; u32 tx_packets; @@ -605,6 +605,8 @@ struct mpath_info { * (or NULL for no change) * @basic_rates_len: number of basic rates * @ap_isolate: do not forward packets between connected stations + * @ht_opmode: HT Operation mode + * (u16 = opmode, -1 = do not change) */ struct bss_parameters { int use_cts_prot; @@ -613,8 +615,14 @@ struct bss_parameters { u8 *basic_rates; u8 basic_rates_len; int ap_isolate; + int ht_opmode; }; +/* + * struct mesh_config - 802.11s mesh configuration + * + * These parameters can be changed while the mesh is active. + */ struct mesh_config { /* Timeouts in ms */ /* Mesh plink management parameters */ @@ -624,6 +632,8 @@ struct mesh_config { u16 dot11MeshMaxPeerLinks; u8 dot11MeshMaxRetries; u8 dot11MeshTTL; + /* ttl used in path selection information elements */ + u8 element_ttl; bool auto_open_plinks; /* HWMP parameters */ u8 dot11MeshHWMPmaxPREQretries; @@ -636,6 +646,18 @@ struct mesh_config { }; /** + * struct mesh_setup - 802.11s mesh setup configuration + * @mesh_id: the mesh ID + * @mesh_id_len: length of the mesh ID, at least 1 and at most 32 bytes + * + * These parameters are fixed when the mesh is created. + */ +struct mesh_setup { + const u8 *mesh_id; + u8 mesh_id_len; +}; + +/** * struct ieee80211_txq_params - TX queue parameters * @queue: TX queue identifier (NL80211_TXQ_Q_*) * @txop: Maximum burst time in units of 32 usecs, 0 meaning disabled @@ -1031,7 +1053,8 @@ struct cfg80211_pmksa { * * @add_virtual_intf: create a new virtual interface with the given name, * must set the struct wireless_dev's iftype. Beware: You must create - * the new netdev in the wiphy's network namespace! + * the new netdev in the wiphy's network namespace! Returns the netdev, + * or an ERR_PTR. * * @del_virtual_intf: remove the virtual interface determined by ifindex. * @@ -1075,7 +1098,7 @@ struct cfg80211_pmksa { * * @get_mesh_params: Put the current mesh parameters into *params * - * @set_mesh_params: Set mesh parameters. + * @update_mesh_params: Update mesh parameters on a running mesh. * The mask is a bitfield which tells us which parameters to * set, and which to leave alone. * @@ -1166,9 +1189,11 @@ struct cfg80211_ops { int (*suspend)(struct wiphy *wiphy); int (*resume)(struct wiphy *wiphy); - int (*add_virtual_intf)(struct wiphy *wiphy, char *name, - enum nl80211_iftype type, u32 *flags, - struct vif_params *params); + struct net_device * (*add_virtual_intf)(struct wiphy *wiphy, + char *name, + enum nl80211_iftype type, + u32 *flags, + struct vif_params *params); int (*del_virtual_intf)(struct wiphy *wiphy, struct net_device *dev); int (*change_virtual_intf)(struct wiphy *wiphy, struct net_device *dev, @@ -1224,9 +1249,14 @@ struct cfg80211_ops { int (*get_mesh_params)(struct wiphy *wiphy, struct net_device *dev, struct mesh_config *conf); - int (*set_mesh_params)(struct wiphy *wiphy, - struct net_device *dev, - const struct mesh_config *nconf, u32 mask); + int (*update_mesh_params)(struct wiphy *wiphy, + struct net_device *dev, u32 mask, + const struct mesh_config *nconf); + int (*join_mesh)(struct wiphy *wiphy, struct net_device *dev, + const struct mesh_config *conf, + const struct mesh_setup *setup); + int (*leave_mesh)(struct wiphy *wiphy, struct net_device *dev); + int (*change_bss)(struct wiphy *wiphy, struct net_device *dev, struct bss_parameters *params); @@ -1642,6 +1672,8 @@ struct cfg80211_cached_keys; * @bssid: (private) Used by the internal configuration code * @ssid: (private) Used by the internal configuration code * @ssid_len: (private) Used by the internal configuration code + * @mesh_id_len: (private) Used by the internal configuration code + * @mesh_id_up_len: (private) Used by the internal configuration code * @wext: (private) Used by the internal wireless extensions compat code * @use_4addr: indicates 4addr mode is used on this interface, must be * set by driver (if supported) on add_interface BEFORE registering the @@ -1671,7 +1703,7 @@ struct wireless_dev { /* currently used for IBSS and SME - might be rearranged later */ u8 ssid[IEEE80211_MAX_SSID_LEN]; - u8 ssid_len; + u8 ssid_len, mesh_id_len, mesh_id_up_len; enum { CFG80211_SME_IDLE, CFG80211_SME_CONNECTING, |