diff options
Diffstat (limited to 'include/net/mac80211.h')
| -rw-r--r-- | include/net/mac80211.h | 60 |
1 files changed, 55 insertions, 5 deletions
diff --git a/include/net/mac80211.h b/include/net/mac80211.h index 45d7d44d7cb..20823d04e03 100644 --- a/include/net/mac80211.h +++ b/include/net/mac80211.h @@ -144,6 +144,7 @@ struct ieee80211_low_level_stats { * new beacon (beaconing modes) * @BSS_CHANGED_BEACON_ENABLED: Beaconing should be * enabled/disabled (beaconing modes) + * @BSS_CHANGED_CQM: Connection quality monitor config changed */ enum ieee80211_bss_change { BSS_CHANGED_ASSOC = 1<<0, @@ -156,6 +157,7 @@ enum ieee80211_bss_change { BSS_CHANGED_BSSID = 1<<7, BSS_CHANGED_BEACON = 1<<8, BSS_CHANGED_BEACON_ENABLED = 1<<9, + BSS_CHANGED_CQM = 1<<10, }; /** @@ -185,6 +187,9 @@ enum ieee80211_bss_change { * @enable_beacon: whether beaconing should be enabled or not * @ht_operation_mode: HT operation mode (like in &struct ieee80211_ht_info). * This field is only valid when the channel type is one of the HT types. + * @cqm_rssi_thold: Connection quality monitor RSSI threshold, a zero value + * implies disabled + * @cqm_rssi_hyst: Connection quality monitor RSSI hysteresis */ struct ieee80211_bss_conf { const u8 *bssid; @@ -202,6 +207,8 @@ struct ieee80211_bss_conf { u64 timestamp; u32 basic_rates; u16 ht_operation_mode; + s32 cqm_rssi_thold; + u32 cqm_rssi_hyst; }; /** @@ -543,7 +550,7 @@ enum mac80211_rx_flags { * @signal: signal strength when receiving this frame, either in dBm, in dB or * unspecified depending on the hardware capabilities flags * @IEEE80211_HW_SIGNAL_* - * @noise: noise when receiving this frame, in dBm. + * @noise: noise when receiving this frame, in dBm (DEPRECATED). * @antenna: antenna used * @rate_idx: index of data rate into band's supported rates or MCS index if * HT rates are use (RX_FLAG_HT) @@ -554,7 +561,7 @@ struct ieee80211_rx_status { enum ieee80211_band band; int freq; int signal; - int noise; + int noise __deprecated; int antenna; int rate_idx; int flag; @@ -954,6 +961,17 @@ enum ieee80211_tkip_key_type { * Hardware can provide ack status reports of Tx frames to * the stack. * + * @IEEE80211_HW_CONNECTION_MONITOR: + * The hardware performs its own connection monitoring, including + * periodic keep-alives to the AP and probing the AP on beacon loss. + * When this flag is set, signaling beacon-loss will cause an immediate + * change to disassociated state. + * + * @IEEE80211_HW_SUPPORTS_CQM_RSSI: + * Hardware can do connection quality monitoring - i.e. it can monitor + * connection quality related parameters, such as the RSSI level and + * provide notifications if configured trigger levels are reached. + * */ enum ieee80211_hw_flags { IEEE80211_HW_HAS_RATE_CONTROL = 1<<0, @@ -975,6 +993,8 @@ enum ieee80211_hw_flags { IEEE80211_HW_SUPPORTS_DYNAMIC_SMPS = 1<<16, IEEE80211_HW_SUPPORTS_UAPSD = 1<<17, IEEE80211_HW_REPORTS_TX_ACK_STATUS = 1<<18, + IEEE80211_HW_CONNECTION_MONITOR = 1<<19, + IEEE80211_HW_SUPPORTS_CQM_RSSI = 1<<20, }; /** @@ -1606,7 +1626,7 @@ struct ieee80211_ops { struct ieee80211_bss_conf *info, u32 changed); u64 (*prepare_multicast)(struct ieee80211_hw *hw, - int mc_count, struct dev_addr_list *mc_list); + struct netdev_hw_addr_list *mc_list); void (*configure_filter)(struct ieee80211_hw *hw, unsigned int changed_flags, unsigned int *total_flags, @@ -2364,12 +2384,42 @@ void ieee80211_sta_block_awake(struct ieee80211_hw *hw, * * @vif: &struct ieee80211_vif pointer from the add_interface callback. * - * When beacon filtering is enabled with IEEE80211_HW_BEACON_FILTERING and - * IEEE80211_CONF_PS is set, the driver needs to inform whenever the + * When beacon filtering is enabled with %IEEE80211_HW_BEACON_FILTERING and + * %IEEE80211_CONF_PS is set, the driver needs to inform whenever the * hardware is not receiving beacons with this function. */ void ieee80211_beacon_loss(struct ieee80211_vif *vif); +/** + * ieee80211_connection_loss - inform hardware has lost connection to the AP + * + * @vif: &struct ieee80211_vif pointer from the add_interface callback. + * + * When beacon filtering is enabled with %IEEE80211_HW_BEACON_FILTERING, and + * %IEEE80211_CONF_PS and %IEEE80211_HW_CONNECTION_MONITOR are set, the driver + * needs to inform if the connection to the AP has been lost. + * + * This function will cause immediate change to disassociated state, + * without connection recovery attempts. + */ +void ieee80211_connection_loss(struct ieee80211_vif *vif); + +/** + * ieee80211_cqm_rssi_notify - inform a configured connection quality monitoring + * rssi threshold triggered + * + * @vif: &struct ieee80211_vif pointer from the add_interface callback. + * @rssi_event: the RSSI trigger event type + * @gfp: context flags + * + * When the %IEEE80211_HW_SUPPORTS_CQM_RSSI is set, and a connection quality + * monitoring is configured with an rssi threshold, the driver will inform + * whenever the rssi level reaches the threshold. + */ +void ieee80211_cqm_rssi_notify(struct ieee80211_vif *vif, + enum nl80211_cqm_rssi_threshold_event rssi_event, + gfp_t gfp); + /* Rate control API */ /** |