diff options
Diffstat (limited to 'lib/zlib_inflate/infblock.c')
| -rw-r--r-- | lib/zlib_inflate/infblock.c | 365 |
1 files changed, 0 insertions, 365 deletions
diff --git a/lib/zlib_inflate/infblock.c b/lib/zlib_inflate/infblock.c deleted file mode 100644 index c16cdeff51a..00000000000 --- a/lib/zlib_inflate/infblock.c +++ /dev/null @@ -1,365 +0,0 @@ -/* infblock.c -- interpret and process block types to last block - * Copyright (C) 1995-1998 Mark Adler - * For conditions of distribution and use, see copyright notice in zlib.h - */ - -#include <linux/zutil.h> -#include "infblock.h" -#include "inftrees.h" -#include "infcodes.h" -#include "infutil.h" - -struct inflate_codes_state; - -/* simplify the use of the inflate_huft type with some defines */ -#define exop word.what.Exop -#define bits word.what.Bits - -/* Table for deflate from PKZIP's appnote.txt. */ -static const uInt border[] = { /* Order of the bit length code lengths */ - 16, 17, 18, 0, 8, 7, 9, 6, 10, 5, 11, 4, 12, 3, 13, 2, 14, 1, 15}; - -/* - Notes beyond the 1.93a appnote.txt: - - 1. Distance pointers never point before the beginning of the output - stream. - 2. Distance pointers can point back across blocks, up to 32k away. - 3. There is an implied maximum of 7 bits for the bit length table and - 15 bits for the actual data. - 4. If only one code exists, then it is encoded using one bit. (Zero - would be more efficient, but perhaps a little confusing.) If two - codes exist, they are coded using one bit each (0 and 1). - 5. There is no way of sending zero distance codes--a dummy must be - sent if there are none. (History: a pre 2.0 version of PKZIP would - store blocks with no distance codes, but this was discovered to be - too harsh a criterion.) Valid only for 1.93a. 2.04c does allow - zero distance codes, which is sent as one code of zero bits in - length. - 6. There are up to 286 literal/length codes. Code 256 represents the - end-of-block. Note however that the static length tree defines - 288 codes just to fill out the Huffman codes. Codes 286 and 287 - cannot be used though, since there is no length base or extra bits - defined for them. Similarily, there are up to 30 distance codes. - However, static trees define 32 codes (all 5 bits) to fill out the - Huffman codes, but the last two had better not show up in the data. - 7. Unzip can check dynamic Huffman blocks for complete code sets. - The exception is that a single code would not be complete (see #4). - 8. The five bits following the block type is really the number of - literal codes sent minus 257. - 9. Length codes 8,16,16 are interpreted as 13 length codes of 8 bits - (1+6+6). Therefore, to output three times the length, you output - three codes (1+1+1), whereas to output four times the same length, - you only need two codes (1+3). Hmm. - 10. In the tree reconstruction algorithm, Code = Code + Increment - only if BitLength(i) is not zero. (Pretty obvious.) - 11. Correction: 4 Bits: # of Bit Length codes - 4 (4 - 19) - 12. Note: length code 284 can represent 227-258, but length code 285 - really is 258. The last length deserves its own, short code - since it gets used a lot in very redundant files. The length - 258 is special since 258 - 3 (the min match length) is 255. - 13. The literal/length and distance code bit lengths are read as a - single stream of lengths. It is possible (and advantageous) for - a repeat code (16, 17, or 18) to go across the boundary between - the two sets of lengths. - */ - - -void zlib_inflate_blocks_reset( - inflate_blocks_statef *s, - z_streamp z, - uLong *c -) -{ - if (c != NULL) - *c = s->check; - if (s->mode == CODES) - zlib_inflate_codes_free(s->sub.decode.codes, z); - s->mode = TYPE; - s->bitk = 0; - s->bitb = 0; - s->read = s->write = s->window; - if (s->checkfn != NULL) - z->adler = s->check = (*s->checkfn)(0L, NULL, 0); -} - -inflate_blocks_statef *zlib_inflate_blocks_new( - z_streamp z, - check_func c, - uInt w -) -{ - inflate_blocks_statef *s; - - s = &WS(z)->working_blocks_state; - s->hufts = WS(z)->working_hufts; - s->window = WS(z)->working_window; - s->end = s->window + w; - s->checkfn = c; - s->mode = TYPE; - zlib_inflate_blocks_reset(s, z, NULL); - return s; -} - - -int zlib_inflate_blocks( - inflate_blocks_statef *s, - z_streamp z, - int r -) -{ - uInt t; /* temporary storage */ - uLong b; /* bit buffer */ - uInt k; /* bits in bit buffer */ - Byte *p; /* input data pointer */ - uInt n; /* bytes available there */ - Byte *q; /* output window write pointer */ - uInt m; /* bytes to end of window or read pointer */ - - /* copy input/output information to locals (UPDATE macro restores) */ - LOAD - - /* process input based on current state */ - while (1) switch (s->mode) - { - case TYPE: - NEEDBITS(3) - t = (uInt)b & 7; - s->last = t & 1; - switch (t >> 1) - { - case 0: /* stored */ - DUMPBITS(3) - t = k & 7; /* go to byte boundary */ - DUMPBITS(t) - s->mode = LENS; /* get length of stored block */ - break; - case 1: /* fixed */ - { - uInt bl, bd; - inflate_huft *tl, *td; - - zlib_inflate_trees_fixed(&bl, &bd, &tl, &td, s->hufts, z); - s->sub.decode.codes = zlib_inflate_codes_new(bl, bd, tl, td, z); - if (s->sub.decode.codes == NULL) - { - r = Z_MEM_ERROR; - LEAVE - } - } - DUMPBITS(3) - s->mode = CODES; - break; - case 2: /* dynamic */ - DUMPBITS(3) - s->mode = TABLE; - break; - case 3: /* illegal */ - DUMPBITS(3) - s->mode = B_BAD; - z->msg = (char*)"invalid block type"; - r = Z_DATA_ERROR; - LEAVE - } - break; - case LENS: - NEEDBITS(32) - if ((((~b) >> 16) & 0xffff) != (b & 0xffff)) - { - s->mode = B_BAD; - z->msg = (char*)"invalid stored block lengths"; - r = Z_DATA_ERROR; - LEAVE - } - s->sub.left = (uInt)b & 0xffff; - b = k = 0; /* dump bits */ - s->mode = s->sub.left ? STORED : (s->last ? DRY : TYPE); - break; - case STORED: - if (n == 0) - LEAVE - NEEDOUT - t = s->sub.left; - if (t > n) t = n; - if (t > m) t = m; - memcpy(q, p, t); - p += t; n -= t; - q += t; m -= t; - if ((s->sub.left -= t) != 0) - break; - s->mode = s->last ? DRY : TYPE; - break; - case TABLE: - NEEDBITS(14) - s->sub.trees.table = t = (uInt)b & 0x3fff; -#ifndef PKZIP_BUG_WORKAROUND - if ((t & 0x1f) > 29 || ((t >> 5) & 0x1f) > 29) - { - s->mode = B_BAD; - z->msg = (char*)"too many length or distance symbols"; - r = Z_DATA_ERROR; - LEAVE - } -#endif - { - s->sub.trees.blens = WS(z)->working_blens; - } - DUMPBITS(14) - s->sub.trees.index = 0; - s->mode = BTREE; - case BTREE: - while (s->sub.trees.index < 4 + (s->sub.trees.table >> 10)) - { - NEEDBITS(3) - s->sub.trees.blens[border[s->sub.trees.index++]] = (uInt)b & 7; - DUMPBITS(3) - } - while (s->sub.trees.index < 19) - s->sub.trees.blens[border[s->sub.trees.index++]] = 0; - s->sub.trees.bb = 7; - t = zlib_inflate_trees_bits(s->sub.trees.blens, &s->sub.trees.bb, - &s->sub.trees.tb, s->hufts, z); - if (t != Z_OK) - { - r = t; - if (r == Z_DATA_ERROR) - s->mode = B_BAD; - LEAVE - } - s->sub.trees.index = 0; - s->mode = DTREE; - case DTREE: - while (t = s->sub.trees.table, - s->sub.trees.index < 258 + (t & 0x1f) + ((t >> 5) & 0x1f)) - { - inflate_huft *h; - uInt i, j, c; - - t = s->sub.trees.bb; - NEEDBITS(t) - h = s->sub.trees.tb + ((uInt)b & zlib_inflate_mask[t]); - t = h->bits; - c = h->base; - if (c < 16) - { - DUMPBITS(t) - s->sub.trees.blens[s->sub.trees.index++] = c; - } - else /* c == 16..18 */ - { - i = c == 18 ? 7 : c - 14; - j = c == 18 ? 11 : 3; - NEEDBITS(t + i) - DUMPBITS(t) - j += (uInt)b & zlib_inflate_mask[i]; - DUMPBITS(i) - i = s->sub.trees.index; - t = s->sub.trees.table; - if (i + j > 258 + (t & 0x1f) + ((t >> 5) & 0x1f) || - (c == 16 && i < 1)) - { - s->mode = B_BAD; - z->msg = (char*)"invalid bit length repeat"; - r = Z_DATA_ERROR; - LEAVE - } - c = c == 16 ? s->sub.trees.blens[i - 1] : 0; - do { - s->sub.trees.blens[i++] = c; - } while (--j); - s->sub.trees.index = i; - } - } - s->sub.trees.tb = NULL; - { - uInt bl, bd; - inflate_huft *tl, *td; - inflate_codes_statef *c; - - bl = 9; /* must be <= 9 for lookahead assumptions */ - bd = 6; /* must be <= 9 for lookahead assumptions */ - t = s->sub.trees.table; - t = zlib_inflate_trees_dynamic(257 + (t & 0x1f), 1 + ((t >> 5) & 0x1f), - s->sub.trees.blens, &bl, &bd, &tl, &td, - s->hufts, z); - if (t != Z_OK) - { - if (t == (uInt)Z_DATA_ERROR) - s->mode = B_BAD; - r = t; - LEAVE - } - if ((c = zlib_inflate_codes_new(bl, bd, tl, td, z)) == NULL) - { - r = Z_MEM_ERROR; - LEAVE - } - s->sub.decode.codes = c; - } - s->mode = CODES; - case CODES: - UPDATE - if ((r = zlib_inflate_codes(s, z, r)) != Z_STREAM_END) - return zlib_inflate_flush(s, z, r); - r = Z_OK; - zlib_inflate_codes_free(s->sub.decode.codes, z); - LOAD - if (!s->last) - { - s->mode = TYPE; - break; - } - s->mode = DRY; - case DRY: - FLUSH - if (s->read != s->write) - LEAVE - s->mode = B_DONE; - case B_DONE: - r = Z_STREAM_END; - LEAVE - case B_BAD: - r = Z_DATA_ERROR; - LEAVE - default: - r = Z_STREAM_ERROR; - LEAVE - } -} - - -int zlib_inflate_blocks_free( - inflate_blocks_statef *s, - z_streamp z -) -{ - zlib_inflate_blocks_reset(s, z, NULL); - return Z_OK; -} - - -#if 0 -void zlib_inflate_set_dictionary( - inflate_blocks_statef *s, - const Byte *d, - uInt n -) -{ - memcpy(s->window, d, n); - s->read = s->write = s->window + n; -} -#endif /* 0 */ - - -/* Returns true if inflate is currently at the end of a block generated - * by Z_SYNC_FLUSH or Z_FULL_FLUSH. - * IN assertion: s != NULL - */ -#if 0 -int zlib_inflate_blocks_sync_point( - inflate_blocks_statef *s -) -{ - return s->mode == LENS; -} -#endif /* 0 */ |