Age | Commit message (Expand) | Author |
2008-02-15 | mkiss: ax_bump() locking fix | Jarek Poplawski |
2008-02-15 | Fix station address detection in smc | Chuck Ebbert |
2008-02-11 | ixgbe: remove accidentally added #ifdef | Auke Kok |
2008-02-11 | ixgbe: Disallow device reset during ethtool test | Auke Kok |
2008-02-11 | ixgbe: warn when device is in a x4 or lower width slot | Auke Kok |
2008-02-11 | e1000e: Fix logic reversal keeping link active | Auke Kok |
2008-02-11 | e1000: warn if this driver is used for e1000e devices | Auke Kok |
2008-02-11 | replace code with FIELD_SIZEOF | Julia Lawall |
2008-02-11 | Tsi108_eth: Add ethtool support | Alex Bounine |
2008-02-11 | Tsi108_eth: fix link recovery after disconnect | Alex Bounine |
2008-02-11 | Tsi108_eth: remove not needed code | Alex Bounine |
2008-02-11 | Tsi108_eth: fix detection of 1000Mb mode | Alex Bounine |
2008-02-11 | Tsi108_eth: add missing linking to driver data | Alex Bounine |
2008-02-11 | net/phy/fixed.c: fix a use-after-free | Adrian Bunk |
2008-02-11 | drivers/net/sis190: fix section mismatch warning in sis190_get_mac_addr | Sergio Luis |
2008-02-11 | claw/lcs/netiucv: check s390dbf level before sprints | Peter Tiedemann |
2008-02-11 | lcs: avoid/reduce unused s390dbf debug areas. | Peter Tiedemann |
2008-02-11 | netiucv: change name of nop function | Ursula Braun |
2008-02-11 | netiucv: Remember to set driver->owner. | Cornelia Huck |
2008-02-11 | claw: removal of volatile variables | Ursula Braun |
2008-02-11 | forcedeth: tx pause watermarks | Ayaz Abdulla |
2008-02-11 | forcedeth: tx collision fix | Ayaz Abdulla |
2008-02-11 | cxgb3: Handle ARP completions that mark neighbors stale. | Steve Wise |
2008-02-11 | Merge branch 'r6040' of git://git.kernel.org/pub/scm/linux/kernel/git/romieu/... | Jeff Garzik |
2008-02-11 | DM9000: Show the MAC address source after printing MAC | Ben Dooks |
2008-02-11 | DM9000: Update retry count whilst identifying chip | Ben Dooks |
2008-02-11 | DM9000: Add support for MII ioctl() calls | Ben Dooks |
2008-02-11 | DM9000: Add platform flag for no attached EEPROM | Ben Dooks |
2008-02-11 | DM9000: Remove redudant use of "& 0xff" | Ben Dooks |
2008-02-11 | DM9000: Remove cal_CRC() and use ether_crc_le instead | Ben Dooks |
2008-02-11 | DM9000: Fix delays used by EEPROM read and write | Ben Dooks |
2008-02-11 | DM9000: Use netif_msg to enable debugging options | Ben Dooks |
2008-02-11 | DM9000: Remove unnecessary changelog in header comment | Ben Dooks |
2008-02-11 | DM9000: Ensure spinlock held whilst accessing EEPROM registers | Ben Dooks |
2008-02-11 | DM9000: Remove EEPROM initialisation code. | Ben Dooks |
2008-02-11 | DM9000: Add ethtool control of msg_enable value | Ben Dooks |
2008-02-11 | DM9000: Add ethtool support for reading and writing EEPROM | Ben Dooks |
2008-02-11 | DM9000: Add mutex to protect access | Ben Dooks |
2008-02-11 | DM9000: Remove barely used SROM array read. | Ben Dooks |
2008-02-11 | DM9000: Use msleep() instead of udelay() | Ben Dooks |
2008-02-11 | DM9000: Do not sleep with spinlock and IRQs held | Ben Dooks |
2008-02-11 | DM9000: Add initial ethtool support | Ben Dooks |
2008-02-11 | DM9000: Remove old timer based poll routines | Ben Dooks |
2008-02-11 | DM9000: Pass IRQ flags via platform resources | Ben Dooks |
2008-02-11 | DM9000 update debugging macros to use debug level | Ben Dooks |
2008-02-11 | DM9000 use dev_xxx() instead of printk for output. | Ben Dooks |
2008-02-11 | DM9000: Add platform data to specify external phy | Ben Dooks |
2008-02-11 | DM9000: Fix endian-ness of data accesses. | Ben Dooks |
2008-02-11 | Optimize cxgb3 xmit path (a bit) | Krishna Kumar |
2008-02-11 | e1000: Fix for 32 bits platforms with 64 bits resources | Benjamin Herrenschmidt |