summaryrefslogtreecommitdiffstats
AgeCommit message (Expand)Author
2012-08-21iwlwifi: fix FW restart on init FWAmit Beka
2012-08-21iwlwifi: fix the preparation of the cardEmmanuel Grumbach
2012-08-20mac80211: clean up ieee80211_subif_start_xmitJohannes Berg
2012-08-20mac80211: pass channel to ieee80211_send_probe_reqJohannes Berg
2012-08-20mac80211: convert ops checks to WARN_ONJohannes Berg
2012-08-20mac80211: check operating channel in scanJohannes Berg
2012-08-20mac80211: use RX status band instead of current bandJohannes Berg
2012-08-20mac80211: don't assume channel is set in tracingJohannes Berg
2012-08-20mac80211: use oper_channel in rate initJohannes Berg
2012-08-20mac80211: remove freq/chantype from debugfsJohannes Berg
2012-08-20mac80211: remove almost unused local variableJohannes Berg
2012-08-20mac80211: mesh: don't use global channel typeJohannes Berg
2012-08-20mac80211: simplify buffers in aes_128_cmac_vectorJohannes Berg
2012-08-20mac80211_hwsim: add support for P2P DeviceJohannes Berg
2012-08-20mac80211: add IEEE80211_HW_P2P_DEV_ADDR_FOR_INTFJohannes Berg
2012-08-20mac80211: support P2P Device abstractionJohannes Berg
2012-08-20cfg80211: add P2P Device abstractionJohannes Berg
2012-08-20mac80211: make ieee80211_beacon_connection_loss_work staticJohannes Berg
2012-08-20mac80211: check size of channel switch IE when parsingJohannes Berg
2012-08-20mac80211: fix CSA handling timerJohannes Berg
2012-08-20mac80211: clean up CSA handling codeJohannes Berg
2012-08-20mac80211: remove unneeded 'bssid' variableJohannes Berg
2012-08-20mac80211: support A-MPDU status reportingJohannes Berg
2012-08-20wireless: add radiotap A-MPDU status fieldJohannes Berg
2012-08-20mac80211: add supported rates change notification in IBSSAntonio Quartulli
2012-08-20mac80211: clean up mpath_move_to_queue()Thomas Pedersen
2012-08-20mac80211: use skb_queue_walk() in mesh_path_assign_nexthopThomas Pedersen
2012-08-20mac80211: avoid using synchronize_rcu in ieee80211_set_probe_respEyal Shapira
2012-08-13p54: fix powerpc gcc warningsChristian Lamparter
2012-08-13mac80211: fix unnecessary beacon update after peering status changeMarco Porsch
2012-08-10brcmsmac: document firmware dependenciesJeff Mahoney
2012-08-10ath9k: tune rc_stats to display only valid ratesRajkumar Manoharan
2012-08-10ath9k: Trim rate tableSujith Manoharan
2012-08-10ath9k: Remove MIMO-PS specific codeSujith Manoharan
2012-08-10ath9k: Cleanup TX status APISujith Manoharan
2012-08-10ath9k: Bail out properly before calculating rate indexSujith Manoharan
2012-08-10ath9k: Fix RTS/CTS rate selectionSujith Manoharan
2012-08-10ath9k: Do not set IEEE80211_TX_RC_USE_SHORT_PREAMBLESujith Manoharan
2012-08-10ath9k: Unify valid rate calculation routinesSujith Manoharan
2012-08-10ath9k: Remove ath_rc_set_valid_rate_idxSujith Manoharan
2012-08-10ath9k: Change rateset calculationSujith Manoharan
2012-08-10ath9k: Cleanup index retrieval routinesSujith Manoharan
2012-08-10ath9k: Cleanup ath_rc_setvalid_htratesSujith Manoharan
2012-08-10ath9k: Cleanup ath_rc_setvalid_ratesSujith Manoharan
2012-08-10ath9k: Cleanup RC init APISujith Manoharan
2012-08-10ath9k: Simplify rate table initializationSujith Manoharan
2012-08-10mwifiex: use GFP_ATOMIC under spin lockDan Carpenter
2012-08-10mwifiex: notify cfg80211 about MIC failuresAmitkumar Karwar
2012-08-10mwifiex: fix 'smatch' warning in preparing key_material cmdBing Zhao
2012-08-10ssb: check for flash presentenceRafał Miłecki