|
In perf_ip_adjust() we potentially use the MMCRA[SLOT] field to adjust
the reported IP of a sampled instruction.
Currently the logic is written so that if the backend does NOT have
the PPMU_ALT_SIPR flag set then we assume MMCRA[SLOT] exists.
However on power8 we do not want to set ALT_SIPR (it's in a third
location), and we also do not have MMCRA[SLOT].
So add a new flag which only indicates whether MMCRA[SLOT] exists.
Naively we'd set it on everything except power6/7, because they set
ALT_SIPR, and we've reversed the polarity of the flag. But it's more
complicated than that.
mpc7450 is 32-bit, and uses its own version of perf_ip_adjust()
which doesn't use MMCRA[SLOT], so it doesn't need the new flag set and
the behaviour is unchanged.
PPC970 (and I assume power4) don't have MMCRA[SLOT], so shouldn't have
the new flag set. This is a behaviour change on those cpus, though we
were probably getting lucky and the bits in question were 0.
power5 and power5+ set the new flag, behaviour unchanged.
power6 & power7 do not set the new flag, behaviour unchanged.
Signed-off-by: Michael Ellerman <michael@ellerman.id.au>
Acked-by: Paul Mackerras <paulus@samba.org>
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
|
|
The perf code has grown a lot since it started, and is big enough to
warrant its own subdirectory. For reference it's ~60% bigger than the
oprofile code. It declutters the kernel directory, makes it simpler to
grep for "just perf stuff", and allows us to shorten some filenames.
While we're at it, make it more obvious that we have two implementations
of the core perf logic. One for (roughly) Book3S CPUs, which was the
original implementation, and the other for Freescale embedded CPUs.
Signed-off-by: Michael Ellerman <michael@ellerman.id.au>
Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>
|
