From be1ff386e768ee4fc19bb7da48cee4fc4cb4e75b Mon Sep 17 00:00:00 2001 From: David Brownell Date: Mon, 23 Jul 2007 18:43:57 -0700 Subject: minor gpio doc update MIME-Version: 1.0 Content-Type: text/plain; charset=UTF-8 Content-Transfer-Encoding: 8bit Fix doc bug noted by Uwe Kleine-König: gpio_set_direction() is long gone, replaced by gpio_direction_input() and gpio_direction_output(). Signed-off-by: David Brownell Cc: Signed-off-by: Andrew Morton Signed-off-by: Linus Torvalds --- Documentation/gpio.txt | 4 ++-- 1 file changed, 2 insertions(+), 2 deletions(-) diff --git a/Documentation/gpio.txt b/Documentation/gpio.txt index 218a8650f48..6bc2ba215df 100644 --- a/Documentation/gpio.txt +++ b/Documentation/gpio.txt @@ -148,7 +148,7 @@ pin ... that won't always match the specified output value, because of issues including wire-OR and output latencies. The get/set calls have no error returns because "invalid GPIO" should have -been reported earlier in gpio_set_direction(). However, note that not all +been reported earlier from gpio_direction_*(). However, note that not all platforms can read the value of output pins; those that can't should always return zero. Also, using these calls for GPIOs that can't safely be accessed without sleeping (see below) is an error. @@ -239,7 +239,7 @@ map between them using calls like: Those return either the corresponding number in the other namespace, or else a negative errno code if the mapping can't be done. (For example, some GPIOs can't used as IRQs.) It is an unchecked error to use a GPIO -number that hasn't been marked as an input using gpio_set_direction(), or +number that wasn't set up as an input using gpio_direction_input(), or to use an IRQ number that didn't originally come from gpio_to_irq(). These two mapping calls are expected to cost on the order of a single -- cgit v1.2.3-70-g09d2