From d928cd2ef8f7f4194e479d4a66452901ec82ccda Mon Sep 17 00:00:00 2001 From: Afzal Mohammed Date: Tue, 6 Nov 2012 20:47:35 +0530 Subject: usb: musb: dsps: document dt bindings properly DT bindings normally use '-' (hyphens) instead of '_' (underscore), driver has it the proper way, but binding documentation does not reflect it, fix it. Signed-off-by: Afzal Mohammed Signed-off-by: Felipe Balbi --- Documentation/devicetree/bindings/usb/am33xx-usb.txt | 8 ++++---- 1 file changed, 4 insertions(+), 4 deletions(-) (limited to 'Documentation/devicetree') diff --git a/Documentation/devicetree/bindings/usb/am33xx-usb.txt b/Documentation/devicetree/bindings/usb/am33xx-usb.txt index ca8fa56e9f0..a92250512a4 100644 --- a/Documentation/devicetree/bindings/usb/am33xx-usb.txt +++ b/Documentation/devicetree/bindings/usb/am33xx-usb.txt @@ -3,12 +3,12 @@ AM33XX MUSB GLUE - ti,hwmods : must be "usb_otg_hs" - multipoint : Should be "1" indicating the musb controller supports multipoint. This is a MUSB configuration-specific setting. - - num_eps : Specifies the number of endpoints. This is also a + - num-eps : Specifies the number of endpoints. This is also a MUSB configuration-specific setting. Should be set to "16" - - ram_bits : Specifies the ram address size. Should be set to "12" - - port0_mode : Should be "3" to represent OTG. "1" signifies HOST and "2" + - ram-bits : Specifies the ram address size. Should be set to "12" + - port0-mode : Should be "3" to represent OTG. "1" signifies HOST and "2" represents PERIPHERAL. - - port1_mode : Should be "1" to represent HOST. "3" signifies OTG and "2" + - port1-mode : Should be "1" to represent HOST. "3" signifies OTG and "2" represents PERIPHERAL. - power : Should be "250". This signifies the controller can supply upto 500mA when operating in host mode. -- cgit v1.2.3-70-g09d2