From dc2d07ebaea839a6e0fa47588c7984931f3c9c71 Mon Sep 17 00:00:00 2001 From: Benoit Cousson Date: Wed, 10 Aug 2011 13:32:08 +0200 Subject: ARM: OMAP: omap_device: Add a method to build an omap_device from a DT node Add a notifier called during device_add phase. If an of_node is present, retrieve the hwmod entry in order to populate properly the omap_device structure. For the moment the resource from the device-tree are overloaded. DT does not support named resource yet, and thus, most driver will not work without that information. Add a documentation to capture the specifics OMAP bindings needed for device-tree support. Signed-off-by: Benoit Cousson Cc: Grant Likely Signed-off-by: Kevin Hilman --- .../devicetree/bindings/arm/omap/omap.txt | 43 ++++++++++++++++++++++ 1 file changed, 43 insertions(+) create mode 100644 Documentation/devicetree/bindings/arm/omap/omap.txt (limited to 'Documentation/devicetree') diff --git a/Documentation/devicetree/bindings/arm/omap/omap.txt b/Documentation/devicetree/bindings/arm/omap/omap.txt new file mode 100644 index 00000000000..dbdab40ed3a --- /dev/null +++ b/Documentation/devicetree/bindings/arm/omap/omap.txt @@ -0,0 +1,43 @@ +* Texas Instruments OMAP + +OMAP is currently using a static file per SoC family to describe the +IPs present in the SoC. +On top of that an omap_device is created to extend the platform_device +capabilities and to allow binding with one or several hwmods. +The hwmods will contain all the information to build the device: +adresse range, irq lines, dma lines, interconnect, PRCM register, +clock domain, input clocks. +For the moment just point to the existing hwmod, the next step will be +to move data from hwmod to device-tree representation. + + +Required properties: +- compatible: Every devices present in OMAP SoC should be in the + form: "ti,XXX" +- ti,hwmods: list of hwmod names (ascii strings), that comes from the OMAP + HW documentation, attached to a device. Must contain at least + one hwmod. + +Optional properties: +- ti,no_idle_on_suspend: When present, it prevents the PM to idle the module + during suspend. + + +Example: + +spinlock@1 { + compatible = "ti,omap4-spinlock"; + ti,hwmods = "spinlock"; +}; + + +Boards: + +- OMAP3 BeagleBoard : Low cost community board + compatible = "ti,omap3-beagle", "ti,omap3" + +- OMAP4 SDP : Software Developement Board + compatible = "ti,omap4-sdp", "ti,omap4430" + +- OMAP4 PandaBoard : Low cost community board + compatible = "ti,omap4-panda", "ti,omap4430" -- cgit v1.2.3-70-g09d2