From a8adcc9012d8502e06ba7b3f966bad8f2c58edc3 Mon Sep 17 00:00:00 2001 From: Ramakrishna Pallala Date: Wed, 27 Aug 2014 23:44:08 +0530 Subject: power_supply: Add boot and calibration attributes Usually PMIC's come with coulomb counting mechanism which can be used to implement a Fuel Gauginig solution in Software itself. One of key input to these SW Fuel Gauge solutioons is the boot up parameters like boot voltage and boot current. This patch adds the VOLTAGE_BOOT and CURRENT_BOOT power supply attributes to report bootup voltage and current. This patch also adds CALIBRATE power supply attribute which useful is for calibrating the battery/coulomb counter. Signed-off-by: Ramakrishna Pallala Signed-off-by: Sebastian Reichel --- Documentation/power/power_supply_class.txt | 6 ++++++ 1 file changed, 6 insertions(+) (limited to 'Documentation/power') diff --git a/Documentation/power/power_supply_class.txt b/Documentation/power/power_supply_class.txt index 48cff881cb8..82dacc06e35 100644 --- a/Documentation/power/power_supply_class.txt +++ b/Documentation/power/power_supply_class.txt @@ -101,6 +101,10 @@ VOLTAGE_MAX, VOLTAGE_MIN - same as _DESIGN voltage values except that these ones should be used if hardware could only guess (measure and retain) the thresholds of a given power supply. +VOLTAGE_BOOT - Reports the voltage measured during boot + +CURRENT_BOOT - Reports the current measured during boot + CHARGE_FULL_DESIGN, CHARGE_EMPTY_DESIGN - design charge values, when battery considered full/empty. @@ -123,6 +127,8 @@ the current drawn from a charging source. CHARGE_TERM_CURRENT - Charge termination current used to detect the end of charge condition. +CALIBRATE - battery or coulomb counter calibration status + CONSTANT_CHARGE_VOLTAGE - constant charge voltage programmed by charger. CONSTANT_CHARGE_VOLTAGE_MAX - maximum charge voltage supported by the power supply object. -- cgit v1.2.3-70-g09d2