From 3322c7bbf60801da2a22d7bd88865d2dc3bd73ac Mon Sep 17 00:00:00 2001 From: Michael Hennerich Date: Tue, 6 Jul 2010 13:57:12 +0000 Subject: Blackfin: document SPI CS limitations with CPHA=0 With the Blackfin on-chip SPI peripheral, there is some logic tied to the CPHA bit whether the Slave Select Line is controlled by hardware (CPHA=0) or controlled by software (CPHA=1). However, the Linux SPI bus driver assumes that the Slave Select being asserted during the entire SPI transfer. So explain these small details for people who need certain SPI modes with standard CS behavior. Signed-off-by: Michael Hennerich Signed-off-by: Mike Frysinger --- Documentation/blackfin/00-INDEX | 5 ++++- Documentation/blackfin/bfin-spi-notes.txt | 14 ++++++++++++++ 2 files changed, 18 insertions(+), 1 deletion(-) create mode 100644 Documentation/blackfin/bfin-spi-notes.txt (limited to 'Documentation') diff --git a/Documentation/blackfin/00-INDEX b/Documentation/blackfin/00-INDEX index 10391d3e9b5..2df0365f2df 100644 --- a/Documentation/blackfin/00-INDEX +++ b/Documentation/blackfin/00-INDEX @@ -1,5 +1,8 @@ 00-INDEX - This file -bfin-gpio-note.txt +bfin-gpio-notes.txt - Notes in developing/using bfin-gpio driver. + +bfin-spi-notes.txt + - Notes for using bfin spi bus driver. diff --git a/Documentation/blackfin/bfin-spi-notes.txt b/Documentation/blackfin/bfin-spi-notes.txt new file mode 100644 index 00000000000..556fa877f2e --- /dev/null +++ b/Documentation/blackfin/bfin-spi-notes.txt @@ -0,0 +1,14 @@ +SPI Chip Select behavior: + +With the Blackfin on-chip SPI peripheral, there is some logic tied to the CPHA +bit whether the Slave Select Line is controlled by hardware (CPHA=0) or +controlled by software (CPHA=1). However, the Linux SPI bus driver assumes that +the Slave Select is always under software control and being asserted during +the entire SPI transfer. - And not just bits_per_word duration. + +In most cases you can utilize SPI MODE_3 instead of MODE_0 to work-around this +behavior. If your SPI slave device in question requires SPI MODE_0 or MODE_2 +timing, you can utilize the GPIO controlled SPI Slave Select option instead. + +You can even use the same pin whose peripheral role is a SSEL, +but use it as a GPIO instead. -- cgit v1.2.3-70-g09d2