From dd1ac5384a08946a99e974bf5749d382e92ed3c0 Mon Sep 17 00:00:00 2001 From: Jean Delvare Date: Thu, 1 May 2008 08:47:33 +0200 Subject: hwmon: (lm85) Drop dead code Drop a lot of useless register defines, conversion macros, data structure members and update code. All these register values were read from the device but nothing is done out of them, so this is all dead code in practice. Signed-off-by: Jean Delvare Acked-by: Juerg Haefliger Signed-off-by: Mark M. Hoffman --- Documentation/hwmon/lm85 | 11 ++++------- 1 file changed, 4 insertions(+), 7 deletions(-) (limited to 'Documentation') diff --git a/Documentation/hwmon/lm85 b/Documentation/hwmon/lm85 index 9549237530c..6d41db7f17f 100644 --- a/Documentation/hwmon/lm85 +++ b/Documentation/hwmon/lm85 @@ -96,11 +96,6 @@ initial testing of the ADM1027 it was 1.00 degC steps. Analog Devices has confirmed this "bug". The ADT7463 is reported to work as described in the documentation. The current lm85 driver does not show the offset register. -The ADT7463 has a THERM asserted counter. This counter has a 22.76ms -resolution and a range of 5.8 seconds. The driver implements a 32-bit -accumulator of the counter value to extend the range to over a year. The -counter will stay at it's max value until read. - See the vendor datasheets for more information. There is application note from National (AN-1260) with some additional information about the LM85. The Analog Devices datasheet is very detailed and describes a procedure for @@ -206,13 +201,15 @@ Configuration choices: The National LM85's have two vendor specific configuration features. Tach. mode and Spinup Control. For more details on these, -see the LM85 datasheet or Application Note AN-1260. +see the LM85 datasheet or Application Note AN-1260. These features +are not currently supported by the lm85 driver. The Analog Devices ADM1027 has several vendor specific enhancements. The number of pulses-per-rev of the fans can be set, Tach monitoring can be optimized for PWM operation, and an offset can be applied to the temperatures to compensate for systemic errors in the -measurements. +measurements. These features are not currently supported by the lm85 +driver. In addition to the ADM1027 features, the ADT7463 also has Tmin control and THERM asserted counts. Automatic Tmin control acts to adjust the -- cgit v1.2.3-70-g09d2