From 068d9f6eb9369a00eb45be91c07653cfef65f4a0 Mon Sep 17 00:00:00 2001 From: Hans-Christian Egtvedt Date: Wed, 31 Jan 2007 18:01:45 +0100 Subject: [AVR32] Add nwait and tdf parameters to SMC configuration Complete the SMC configuration code by adding nwait and tdf parameter. After this change, we support the same parameters as the hardware. Signed-off-by: Haavard Skinnemoen --- arch/avr32/mach-at32ap/hsmc.c | 23 +++++++++++++++++++++++ 1 file changed, 23 insertions(+) (limited to 'arch/avr32/mach-at32ap') diff --git a/arch/avr32/mach-at32ap/hsmc.c b/arch/avr32/mach-at32ap/hsmc.c index 7691721928a..5e22a750632 100644 --- a/arch/avr32/mach-at32ap/hsmc.c +++ b/arch/avr32/mach-at32ap/hsmc.c @@ -75,12 +75,35 @@ int smc_set_configuration(int cs, const struct smc_config *config) return -EINVAL; } + switch (config->nwait_mode) { + case 0: + mode |= HSMC_BF(EXNW_MODE, HSMC_EXNW_MODE_DISABLED); + break; + case 1: + mode |= HSMC_BF(EXNW_MODE, HSMC_EXNW_MODE_RESERVED); + break; + case 2: + mode |= HSMC_BF(EXNW_MODE, HSMC_EXNW_MODE_FROZEN); + break; + case 3: + mode |= HSMC_BF(EXNW_MODE, HSMC_EXNW_MODE_READY); + break; + default: + return -EINVAL; + } + + if (config->tdf_cycles) { + mode |= HSMC_BF(TDF_CYCLES, config->tdf_cycles); + } + if (config->nrd_controlled) mode |= HSMC_BIT(READ_MODE); if (config->nwe_controlled) mode |= HSMC_BIT(WRITE_MODE); if (config->byte_write) mode |= HSMC_BIT(BAT); + if (config->tdf_mode) + mode |= HSMC_BIT(TDF_MODE); pr_debug("smc cs%d: setup/%08x pulse/%08x cycle/%08x mode/%08x\n", cs, setup, pulse, cycle, mode); -- cgit v1.2.3-70-g09d2