From 5dea1c88ed11a1221581c4b202f053c4fc138704 Mon Sep 17 00:00:00 2001 From: Rusty Russell Date: Fri, 22 Jul 2011 14:39:48 +0930 Subject: lguest: use a special 1:1 linear pagetable mode until first switch. The Host used to create some page tables for the Guest to use at the top of Guest memory; it would then tell the Guest where this was. In particular, it created linear mappings for 0 and 0xC0000000 addresses because lguest used to switch to its real page tables quite late in boot. However, since d50d8fe19 Linux initialized boot page tables in head_32.S even before the "are we lguest?" boot jump. So, now we can simplify things: the Host pagetable code assumes 1:1 linear mapping until it first calls the LHCALL_NEW_PGTABLE hypercall, which we now do before we reach C code. This also means that the Host doesn't need to know anything about the Guest's PAGE_OFFSET. (Non-Linux guests might not even have such a thing). Signed-off-by: Rusty Russell --- arch/x86/kernel/asm-offsets_32.c | 1 - arch/x86/lguest/boot.c | 11 +++++------ arch/x86/lguest/i386_head.S | 9 +++++++-- 3 files changed, 12 insertions(+), 9 deletions(-) (limited to 'arch') diff --git a/arch/x86/kernel/asm-offsets_32.c b/arch/x86/kernel/asm-offsets_32.c index c29d631af6f..395a10e6806 100644 --- a/arch/x86/kernel/asm-offsets_32.c +++ b/arch/x86/kernel/asm-offsets_32.c @@ -63,7 +63,6 @@ void foo(void) BLANK(); OFFSET(LGUEST_DATA_irq_enabled, lguest_data, irq_enabled); OFFSET(LGUEST_DATA_irq_pending, lguest_data, irq_pending); - OFFSET(LGUEST_DATA_pgdir, lguest_data, pgdir); BLANK(); OFFSET(LGUEST_PAGES_host_gdt_desc, lguest_pages, state.host_gdt_desc); diff --git a/arch/x86/lguest/boot.c b/arch/x86/lguest/boot.c index db832fd65ec..719a32c6051 100644 --- a/arch/x86/lguest/boot.c +++ b/arch/x86/lguest/boot.c @@ -520,17 +520,16 @@ static unsigned long lguest_read_cr2(void) /* See lguest_set_pte() below. */ static bool cr3_changed = false; +static unsigned long current_cr3; /* * cr3 is the current toplevel pagetable page: the principle is the same as - * cr0. Keep a local copy, and tell the Host when it changes. The only - * difference is that our local copy is in lguest_data because the Host needs - * to set it upon our initial hypercall. + * cr0. Keep a local copy, and tell the Host when it changes. */ static void lguest_write_cr3(unsigned long cr3) { - lguest_data.pgdir = cr3; lazy_hcall1(LHCALL_NEW_PGTABLE, cr3); + current_cr3 = cr3; /* These two page tables are simple, linear, and used during boot */ if (cr3 != __pa(swapper_pg_dir) && cr3 != __pa(initial_page_table)) @@ -539,7 +538,7 @@ static void lguest_write_cr3(unsigned long cr3) static unsigned long lguest_read_cr3(void) { - return lguest_data.pgdir; + return current_cr3; } /* cr4 is used to enable and disable PGE, but we don't care. */ @@ -758,7 +757,7 @@ static void lguest_pmd_clear(pmd_t *pmdp) static void lguest_flush_tlb_single(unsigned long addr) { /* Simply set it to zero: if it was not, it will fault back in. */ - lazy_hcall3(LHCALL_SET_PTE, lguest_data.pgdir, addr, 0); + lazy_hcall3(LHCALL_SET_PTE, current_cr3, addr, 0); } /* diff --git a/arch/x86/lguest/i386_head.S b/arch/x86/lguest/i386_head.S index 4f420c2f2d5..863b03a9fbf 100644 --- a/arch/x86/lguest/i386_head.S +++ b/arch/x86/lguest/i386_head.S @@ -27,13 +27,18 @@ .section .init.text, "ax", @progbits ENTRY(lguest_entry) /* - * We make the "initialization" hypercall now to tell the Host about - * us, and also find out where it put our page tables. + * We make the "initialization" hypercall now to tell the Host where + * our lguest_data struct is. */ movl $LHCALL_LGUEST_INIT, %eax movl $lguest_data - __PAGE_OFFSET, %ebx int $LGUEST_TRAP_ENTRY + /* Now turn our pagetables on; setup by arch/x86/kernel/head_32.S. */ + movl $LHCALL_NEW_PGTABLE, %eax + movl $(initial_page_table - __PAGE_OFFSET), %ebx + int $LGUEST_TRAP_ENTRY + /* Set up the initial stack so we can run C code. */ movl $(init_thread_union+THREAD_SIZE),%esp -- cgit v1.2.3-70-g09d2