From e85477f516c2de7ed515fcf94ceab5282eba7fa4 Mon Sep 17 00:00:00 2001 From: Anton Vorontsov Date: Thu, 5 Feb 2009 23:10:40 +0300 Subject: powerpc/83xx: Fix TSEC0 workability on MPC8313E-RDB boards TSEC0 is connected to Vitesse 7385 5-port switch. The switch isn't connected to any mdio bus, the link to the switch is fixed to Full-duplex 1000 Mb/s (no pause). This patch fixes following failure during bootup: mdio@24520:01 not found eth0: Could not attach to PHY IP-Config: Failed to open eth0 Signed-off-by: Anton Vorontsov Signed-off-by: Kumar Gala --- arch/powerpc/boot/dts/mpc8313erdb.dts | 9 ++------- arch/powerpc/configs/83xx/mpc8313_rdb_defconfig | 2 +- 2 files changed, 3 insertions(+), 8 deletions(-) (limited to 'arch') diff --git a/arch/powerpc/boot/dts/mpc8313erdb.dts b/arch/powerpc/boot/dts/mpc8313erdb.dts index 3f84cd0384e..3ebf7ec0484 100644 --- a/arch/powerpc/boot/dts/mpc8313erdb.dts +++ b/arch/powerpc/boot/dts/mpc8313erdb.dts @@ -191,7 +191,8 @@ interrupts = <37 0x8 36 0x8 35 0x8>; interrupt-parent = <&ipic>; tbi-handle = < &tbi0 >; - phy-handle = < &phy1 >; + /* Vitesse 7385 isn't on the MDIO bus */ + fixed-link = <1 1 1000 0 0>; fsl,magic-packet; mdio@24520 { @@ -199,12 +200,6 @@ #size-cells = <0>; compatible = "fsl,gianfar-mdio"; reg = <0x24520 0x20>; - phy1: ethernet-phy@1 { - interrupt-parent = <&ipic>; - interrupts = <19 0x8>; - reg = <0x1>; - device_type = "ethernet-phy"; - }; phy4: ethernet-phy@4 { interrupt-parent = <&ipic>; interrupts = <20 0x8>; diff --git a/arch/powerpc/configs/83xx/mpc8313_rdb_defconfig b/arch/powerpc/configs/83xx/mpc8313_rdb_defconfig index 9e47ae957e2..409d017621a 100644 --- a/arch/powerpc/configs/83xx/mpc8313_rdb_defconfig +++ b/arch/powerpc/configs/83xx/mpc8313_rdb_defconfig @@ -651,7 +651,7 @@ CONFIG_CICADA_PHY=y # CONFIG_NATIONAL_PHY is not set # CONFIG_STE10XP is not set # CONFIG_LSI_ET1011C_PHY is not set -# CONFIG_FIXED_PHY is not set +CONFIG_FIXED_PHY=y # CONFIG_MDIO_BITBANG is not set CONFIG_NET_ETHERNET=y CONFIG_MII=y -- cgit v1.2.3-70-g09d2