From 07633b5d0723ce2ec31262e1096dcf61311bf078 Mon Sep 17 00:00:00 2001 From: Harvey Harrison Date: Wed, 14 May 2008 16:17:00 -0700 Subject: ata: remove FIT() macro Use the kernel-provided clamp_val() macro. FIT was always applied to a member of struct ata_timing (unsigned short) and two constants. clamp_val will not cast to short anymore. Signed-off-by: Harvey Harrison Cc: Jeff Garzik Cc: Tejun Heo Signed-off-by: Andrew Morton Signed-off-by: Jeff Garzik --- drivers/ata/pata_via.c | 14 +++++++------- 1 file changed, 7 insertions(+), 7 deletions(-) (limited to 'drivers/ata/pata_via.c') diff --git a/drivers/ata/pata_via.c b/drivers/ata/pata_via.c index 2fea6cbe775..708ed144ede 100644 --- a/drivers/ata/pata_via.c +++ b/drivers/ata/pata_via.c @@ -259,15 +259,15 @@ static void via_do_set_mode(struct ata_port *ap, struct ata_device *adev, int mo pci_read_config_byte(pdev, 0x4C, &setup); setup &= ~(3 << shift); - setup |= FIT(t.setup, 1, 4) << shift; /* 1,4 or 1,4 - 1 FIXME */ + setup |= clamp_val(t.setup, 1, 4) << shift; /* 1,4 or 1,4 - 1 FIXME */ pci_write_config_byte(pdev, 0x4C, setup); } /* Load the PIO mode bits */ pci_write_config_byte(pdev, 0x4F - ap->port_no, - ((FIT(t.act8b, 1, 16) - 1) << 4) | (FIT(t.rec8b, 1, 16) - 1)); + ((clamp_val(t.act8b, 1, 16) - 1) << 4) | (clamp_val(t.rec8b, 1, 16) - 1)); pci_write_config_byte(pdev, 0x48 + offset, - ((FIT(t.active, 1, 16) - 1) << 4) | (FIT(t.recover, 1, 16) - 1)); + ((clamp_val(t.active, 1, 16) - 1) << 4) | (clamp_val(t.recover, 1, 16) - 1)); /* Load the UDMA bits according to type */ switch(udma_type) { @@ -275,16 +275,16 @@ static void via_do_set_mode(struct ata_port *ap, struct ata_device *adev, int mo /* BUG() ? */ /* fall through */ case 33: - ut = t.udma ? (0xe0 | (FIT(t.udma, 2, 5) - 2)) : 0x03; + ut = t.udma ? (0xe0 | (clamp_val(t.udma, 2, 5) - 2)) : 0x03; break; case 66: - ut = t.udma ? (0xe8 | (FIT(t.udma, 2, 9) - 2)) : 0x0f; + ut = t.udma ? (0xe8 | (clamp_val(t.udma, 2, 9) - 2)) : 0x0f; break; case 100: - ut = t.udma ? (0xe0 | (FIT(t.udma, 2, 9) - 2)) : 0x07; + ut = t.udma ? (0xe0 | (clamp_val(t.udma, 2, 9) - 2)) : 0x07; break; case 133: - ut = t.udma ? (0xe0 | (FIT(t.udma, 2, 9) - 2)) : 0x07; + ut = t.udma ? (0xe0 | (clamp_val(t.udma, 2, 9) - 2)) : 0x07; break; } -- cgit v1.2.3-70-g09d2