From aedea5910ce44fea79e2c517bb22e0006372156f Mon Sep 17 00:00:00 2001 From: Bartlomiej Zolnierkiewicz Date: Sat, 13 Oct 2007 17:47:50 +0200 Subject: ide-pmac: remove pmac_ide_do_setfeature() (take 2) Use ide_config_drive_speed() instead of pmac_ide_do_setfeature() and remove the latter, also ide-iops.c::__ide_wait_stat() could be static again. Since for IDE PMAC host driver IDE_CONTROL_REG is always true, device's ->quirk_list is always zero and ->ide_dma_host_{on,off} are nops than the only changes in behavior are: * if PIO mode is set then ->dma_off_queitly is called to disable DMA * if setting transfer mode fails ide_dump_status() is called to dump status v2: * IDE PMAC controllers allow separate PIO and DMA timings and PPC userland depends on this fact, and calls "hdparm -p" without calling "hdparm -d". Therefore to compensate for DMA being disabled by ide_config_drive_speed() for PIO modes: - add IDE_HFLAG_SET_PIO_MODE_KEEP_DMA flag and set it in PMAC host driver - add handling of the new flag to ide-io.c::do_special() Cc: Benjamin Herrenschmidt Signed-off-by: Bartlomiej Zolnierkiewicz --- drivers/ide/ppc/pmac.c | 80 ++------------------------------------------------ 1 file changed, 3 insertions(+), 77 deletions(-) (limited to 'drivers/ide/ppc') diff --git a/drivers/ide/ppc/pmac.c b/drivers/ide/ppc/pmac.c index c68e2472345..24f73291c4d 100644 --- a/drivers/ide/ppc/pmac.c +++ b/drivers/ide/ppc/pmac.c @@ -529,81 +529,6 @@ pmac_outbsync(ide_drive_t *drive, u8 value, unsigned long port) tmp = readl(PMAC_IDE_REG(IDE_TIMING_CONFIG)); } -/* - * Send the SET_FEATURE IDE command to the drive and update drive->id with - * the new state. We currently don't use the generic routine as it used to - * cause various trouble, especially with older mediabays. - * This code is sometimes triggering a spurrious interrupt though, I need - * to sort that out sooner or later and see if I can finally get the - * common version to work properly in all cases - */ -static int -pmac_ide_do_setfeature(ide_drive_t *drive, u8 command) -{ - ide_hwif_t *hwif = HWIF(drive); - int result; - u8 stat; - - disable_irq_nosync(hwif->irq); - udelay(1); - SELECT_DRIVE(drive); - SELECT_MASK(drive, 0); - udelay(1); - hwif->OUTB(drive->ctl | 2, IDE_CONTROL_REG); - hwif->OUTB(command, IDE_NSECTOR_REG); - hwif->OUTB(SETFEATURES_XFER, IDE_FEATURE_REG); - hwif->OUTBSYNC(drive, WIN_SETFEATURES, IDE_COMMAND_REG); - result = __ide_wait_stat(drive, drive->ready_stat, - BUSY_STAT|DRQ_STAT|ERR_STAT, - WAIT_CMD, &stat); - if (result) - printk(KERN_ERR "%s: pmac_ide_do_setfeature disk not ready " - "after SET_FEATURE !\n", drive->name); - - SELECT_MASK(drive, 0); - if (result == 0) { - drive->id->dma_ultra &= ~0xFF00; - drive->id->dma_mword &= ~0x0F00; - drive->id->dma_1word &= ~0x0F00; - switch(command) { - case XFER_UDMA_7: - drive->id->dma_ultra |= 0x8080; break; - case XFER_UDMA_6: - drive->id->dma_ultra |= 0x4040; break; - case XFER_UDMA_5: - drive->id->dma_ultra |= 0x2020; break; - case XFER_UDMA_4: - drive->id->dma_ultra |= 0x1010; break; - case XFER_UDMA_3: - drive->id->dma_ultra |= 0x0808; break; - case XFER_UDMA_2: - drive->id->dma_ultra |= 0x0404; break; - case XFER_UDMA_1: - drive->id->dma_ultra |= 0x0202; break; - case XFER_UDMA_0: - drive->id->dma_ultra |= 0x0101; break; - case XFER_MW_DMA_2: - drive->id->dma_mword |= 0x0404; break; - case XFER_MW_DMA_1: - drive->id->dma_mword |= 0x0202; break; - case XFER_MW_DMA_0: - drive->id->dma_mword |= 0x0101; break; - case XFER_SW_DMA_2: - drive->id->dma_1word |= 0x0404; break; - case XFER_SW_DMA_1: - drive->id->dma_1word |= 0x0202; break; - case XFER_SW_DMA_0: - drive->id->dma_1word |= 0x0101; break; - default: break; - } - if (!drive->init_speed) - drive->init_speed = command; - drive->current_speed = command; - } - enable_irq(hwif->irq); - return result; -} - /* * Old tuning functions (called on hdparm -p), sets up drive PIO timings */ @@ -685,7 +610,7 @@ pmac_ide_set_pio_mode(ide_drive_t *drive, const u8 pio) drive->name, pio, *timings); #endif - if (pmac_ide_do_setfeature(drive, XFER_PIO_0 + pio)) + if (ide_config_drive_speed(drive, XFER_PIO_0 + pio)) return; pmac_ide_do_update_timings(drive); @@ -948,7 +873,7 @@ static int pmac_ide_tune_chipset(ide_drive_t *drive, const u8 speed) if (ret) return ret; - ret = pmac_ide_do_setfeature(drive, speed); + ret = ide_config_drive_speed(drive, speed); if (ret) return ret; @@ -1218,6 +1143,7 @@ pmac_ide_setup_device(pmac_ide_hwif_t *pmif, ide_hwif_t *hwif) hwif->cbl = pmif->cable_80 ? ATA_CBL_PATA80 : ATA_CBL_PATA40; hwif->drives[0].unmask = 1; hwif->drives[1].unmask = 1; + hwif->host_flags = IDE_HFLAG_SET_PIO_MODE_KEEP_DMA; hwif->pio_mask = ATA_PIO4; hwif->set_pio_mode = pmac_ide_set_pio_mode; if (pmif->kind == controller_un_ata6 -- cgit v1.2.3-70-g09d2