From 13e0fe49f676607688da7475c33540ec5dac53b5 Mon Sep 17 00:00:00 2001 From: Dmitry Eremin-Solenikov Date: Thu, 2 Jun 2011 18:51:14 +0400 Subject: mtd: drop physmap_configure physmap_configure() and physmap_set_partitions() have no users in kernel. Out of kernel users should have been converted to regular platform device long ago. Drop support for this obsolete API. Signed-off-by: Dmitry Eremin-Solenikov Signed-off-by: Artem Bityutskiy --- drivers/mtd/maps/Kconfig | 6 ------ 1 file changed, 6 deletions(-) (limited to 'drivers/mtd/maps/Kconfig') diff --git a/drivers/mtd/maps/Kconfig b/drivers/mtd/maps/Kconfig index 11cc2307c2c..46eca3b3bcb 100644 --- a/drivers/mtd/maps/Kconfig +++ b/drivers/mtd/maps/Kconfig @@ -41,8 +41,6 @@ config MTD_PHYSMAP_START are mapped on your particular target board. Refer to the memory map which should hopefully be in the documentation for your board. - Ignore this option if you use run-time physmap configuration - (i.e., run-time calling physmap_configure()). config MTD_PHYSMAP_LEN hex "Physical length of flash mapping" @@ -55,8 +53,6 @@ config MTD_PHYSMAP_LEN than the total amount of flash present. Refer to the memory map which should hopefully be in the documentation for your board. - Ignore this option if you use run-time physmap configuration - (i.e., run-time calling physmap_configure()). config MTD_PHYSMAP_BANKWIDTH int "Bank width in octets" @@ -67,8 +63,6 @@ config MTD_PHYSMAP_BANKWIDTH in octets. For example, if you have a data bus width of 32 bits, you would set the bus width octet value to 4. This is used internally by the CFI drivers. - Ignore this option if you use run-time physmap configuration - (i.e., run-time calling physmap_configure()). config MTD_PHYSMAP_OF tristate "Flash device in physical memory map based on OF description" -- cgit v1.2.3-70-g09d2