From 1da177e4c3f41524e886b7f1b8a0c1fc7321cac2 Mon Sep 17 00:00:00 2001 From: Linus Torvalds Date: Sat, 16 Apr 2005 15:20:36 -0700 Subject: Linux-2.6.12-rc2 Initial git repository build. I'm not bothering with the full history, even though we have it. We can create a separate "historical" git archive of that later if we want to, and in the meantime it's about 3.2GB when imported into git - space that would just make the early git days unnecessarily complicated, when we don't have a lot of good infrastructure for it. Let it rip! --- drivers/net/arm/Kconfig | 46 ++++++++++++++++++++++++++++++++++++++++++++++ 1 file changed, 46 insertions(+) create mode 100644 drivers/net/arm/Kconfig (limited to 'drivers/net/arm/Kconfig') diff --git a/drivers/net/arm/Kconfig b/drivers/net/arm/Kconfig new file mode 100644 index 00000000000..470364deded --- /dev/null +++ b/drivers/net/arm/Kconfig @@ -0,0 +1,46 @@ +# +# Acorn Network device configuration +# These are for Acorn's Expansion card network interfaces +# +config ARM_AM79C961A + bool "ARM EBSA110 AM79C961A support" + depends on NET_ETHERNET && ARM && ARCH_EBSA110 + select CRC32 + help + If you wish to compile a kernel for the EBSA-110, then you should + always answer Y to this. + +config ARM_ETHER1 + tristate "Acorn Ether1 support" + depends on NET_ETHERNET && ARM && ARCH_ACORN + help + If you have an Acorn system with one of these (AKA25) network cards, + you should say Y to this option if you wish to use it with Linux. + +config ARM_ETHER3 + tristate "Acorn/ANT Ether3 support" + depends on NET_ETHERNET && ARM && ARCH_ACORN + help + If you have an Acorn system with one of these network cards, you + should say Y to this option if you wish to use it with Linux. + +config ARM_ETHERH + tristate "I-cubed EtherH/ANT EtherM support" + depends on NET_ETHERNET && ARM && ARCH_ACORN + select CRC32 + help + If you have an Acorn system with one of these network cards, you + should say Y to this option if you wish to use it with Linux. + +config ARM_ETHER00 + tristate "Altera Ether00 support" + depends on NET_ETHERNET && ARM && ARCH_CAMELOT + help + This is the driver for Altera's ether00 ethernet mac IP core. Say + Y here if you want to build support for this into the kernel. It + is also available as a module (say M here) that can be inserted/ + removed from the kernel at the same time as the PLD is configured. + If this driver is running on an epxa10 development board then it + will generate a suitable hw address based on the board serial + number (MTD support is required for this). Otherwise you will + need to set a suitable hw address using ifconfig. -- cgit v1.2.3-70-g09d2