From b4ed372b29e458021293e1c791d92d90f1bf5fe3 Mon Sep 17 00:00:00 2001 From: Stephen Hemminger Date: Thu, 24 May 2007 15:22:43 -0700 Subject: sky2: dont set bogus bit in PHY register This code inherited from the sk98lin driver is incorrect on the Yukon2. The GPHY_CTRL register values are specific to the internal PHY of the chip and the values used were leftovers. Driver was setting bit 13 which is now the INT polarity for the PHY! Signed-off-by: Stephen Hemminger Signed-off-by: Jeff Garzik --- drivers/net/sky2.h | 22 ---------------------- 1 file changed, 22 deletions(-) (limited to 'drivers/net/sky2.h') diff --git a/drivers/net/sky2.h b/drivers/net/sky2.h index 5efb5afc45b..3266609cd81 100644 --- a/drivers/net/sky2.h +++ b/drivers/net/sky2.h @@ -1732,28 +1732,6 @@ enum { /* GPHY_CTRL 32 bit GPHY Control Reg (YUKON only) */ enum { - GPC_SEL_BDT = 1<<28, /* Select Bi-Dir. Transfer for MDC/MDIO */ - GPC_INT_POL_HI = 1<<27, /* IRQ Polarity is Active HIGH */ - GPC_75_OHM = 1<<26, /* Use 75 Ohm Termination instead of 50 */ - GPC_DIS_FC = 1<<25, /* Disable Automatic Fiber/Copper Detection */ - GPC_DIS_SLEEP = 1<<24, /* Disable Energy Detect */ - GPC_HWCFG_M_3 = 1<<23, /* HWCFG_MODE[3] */ - GPC_HWCFG_M_2 = 1<<22, /* HWCFG_MODE[2] */ - GPC_HWCFG_M_1 = 1<<21, /* HWCFG_MODE[1] */ - GPC_HWCFG_M_0 = 1<<20, /* HWCFG_MODE[0] */ - GPC_ANEG_0 = 1<<19, /* ANEG[0] */ - GPC_ENA_XC = 1<<18, /* Enable MDI crossover */ - GPC_DIS_125 = 1<<17, /* Disable 125 MHz clock */ - GPC_ANEG_3 = 1<<16, /* ANEG[3] */ - GPC_ANEG_2 = 1<<15, /* ANEG[2] */ - GPC_ANEG_1 = 1<<14, /* ANEG[1] */ - GPC_ENA_PAUSE = 1<<13, /* Enable Pause (SYM_OR_REM) */ - GPC_PHYADDR_4 = 1<<12, /* Bit 4 of Phy Addr */ - GPC_PHYADDR_3 = 1<<11, /* Bit 3 of Phy Addr */ - GPC_PHYADDR_2 = 1<<10, /* Bit 2 of Phy Addr */ - GPC_PHYADDR_1 = 1<<9, /* Bit 1 of Phy Addr */ - GPC_PHYADDR_0 = 1<<8, /* Bit 0 of Phy Addr */ - /* Bits 7..2: reserved */ GPC_RST_CLR = 1<<1, /* Clear GPHY Reset */ GPC_RST_SET = 1<<0, /* Set GPHY Reset */ }; -- cgit v1.2.3-70-g09d2