From 461c078c9cdfc1d24a436a87daed90f18c3b0d0d Mon Sep 17 00:00:00 2001 From: Pavel Roskin Date: Mon, 1 May 2006 02:13:33 -0400 Subject: [PATCH] orinoco: don't put PCI resource data to the network device The resource data in the network device is intended for ISA and other older busses, but not for PCI. Don't put PCI data there. Don't (ab)use the network device for keeping the IRQ number. Retire orinoco_pci_setup_netdev(), and print some minimal information to the kernel log instead, identifying the network device and the driver mostly to identify problems at startup. Scripts should rely on sysfs. Signed-off-by: Pavel Roskin Signed-off-by: John W. Linville --- drivers/net/wireless/orinoco_pci.h | 26 -------------------------- 1 file changed, 26 deletions(-) (limited to 'drivers/net/wireless/orinoco_pci.h') diff --git a/drivers/net/wireless/orinoco_pci.h b/drivers/net/wireless/orinoco_pci.h index 4e8da4ea29f..7eb1e08113e 100644 --- a/drivers/net/wireless/orinoco_pci.h +++ b/drivers/net/wireless/orinoco_pci.h @@ -18,32 +18,6 @@ struct orinoco_pci_card { void __iomem *attr_io; }; -/* Set base address or memory range of the network device based on - * the PCI device it's using. Specify BAR of the "main" resource. - * To be used after request_irq(). */ -static inline void orinoco_pci_setup_netdev(struct net_device *dev, - struct pci_dev *pdev, int bar) -{ - char *range_type; - unsigned long start = pci_resource_start(pdev, bar); - unsigned long len = pci_resource_len(pdev, bar); - unsigned long flags = pci_resource_flags(pdev, bar); - unsigned long end = start + len - 1; - - dev->irq = pdev->irq; - if (flags & IORESOURCE_IO) { - dev->base_addr = start; - range_type = "ports"; - } else { - dev->mem_start = start; - dev->mem_end = end; - range_type = "memory"; - } - - printk(KERN_DEBUG PFX "%s: irq %d, %s 0x%lx-0x%lx\n", - pci_name(pdev), pdev->irq, range_type, start, end); -} - #ifdef CONFIG_PM static int orinoco_pci_suspend(struct pci_dev *pdev, pm_message_t state) { -- cgit v1.2.3-70-g09d2