From 95dac04f881322b510c45e5ae83f0dbee4f823a2 Mon Sep 17 00:00:00 2001 From: Ido Yariv Date: Mon, 6 Jun 2011 14:57:06 +0300 Subject: wl12xx: Support routing FW logs to the host A recently added feature to the firmware enables the driver to retrieve firmware logs via the host bus (SDIO or SPI). There are two modes of operation: 1. On-demand: The FW collects its log in an internal ring buffer. This buffer can later be read, for example, upon recovery. 2. Continuous: The FW pushes the FW logs as special packets in the RX path. Reading the internal ring buffer does not involve the FW. Thus, as long as the HW is not in ELP, it should be possible to read the logs, even if the FW crashes. A sysfs binary file named "fwlog" was added to support this feature, letting a monitor process read the FW messages. The log is transferred from the FW only when available, so the reading process might block. Signed-off-by: Ido Yariv Signed-off-by: Luciano Coelho --- drivers/net/wireless/wl12xx/cmd.h | 62 +++++++++++++++++++++++++++++++++++++++ 1 file changed, 62 insertions(+) (limited to 'drivers/net/wireless/wl12xx/cmd.h') diff --git a/drivers/net/wireless/wl12xx/cmd.h b/drivers/net/wireless/wl12xx/cmd.h index 5cac95d9480..1f7037292c1 100644 --- a/drivers/net/wireless/wl12xx/cmd.h +++ b/drivers/net/wireless/wl12xx/cmd.h @@ -70,6 +70,9 @@ int wl1271_cmd_start_bss(struct wl1271 *wl); int wl1271_cmd_stop_bss(struct wl1271 *wl); int wl1271_cmd_add_sta(struct wl1271 *wl, struct ieee80211_sta *sta, u8 hlid); int wl1271_cmd_remove_sta(struct wl1271 *wl, u8 hlid); +int wl12xx_cmd_config_fwlog(struct wl1271 *wl); +int wl12xx_cmd_start_fwlog(struct wl1271 *wl); +int wl12xx_cmd_stop_fwlog(struct wl1271 *wl); enum wl1271_commands { CMD_INTERROGATE = 1, /*use this to read information elements*/ @@ -107,6 +110,9 @@ enum wl1271_commands { CMD_START_PERIODIC_SCAN = 50, CMD_STOP_PERIODIC_SCAN = 51, CMD_SET_STA_STATE = 52, + CMD_CONFIG_FWLOGGER = 53, + CMD_START_FWLOGGER = 54, + CMD_STOP_FWLOGGER = 55, /* AP mode commands */ CMD_BSS_START = 60, @@ -575,4 +581,60 @@ struct wl1271_cmd_remove_sta { u8 padding1; } __packed; +/* + * Continuous mode - packets are transferred to the host periodically + * via the data path. + * On demand - Log messages are stored in a cyclic buffer in the + * firmware, and only transferred to the host when explicitly requested + */ +enum wl12xx_fwlogger_log_mode { + WL12XX_FWLOG_CONTINUOUS, + WL12XX_FWLOG_ON_DEMAND +}; + +/* Include/exclude timestamps from the log messages */ +enum wl12xx_fwlogger_timestamp { + WL12XX_FWLOG_TIMESTAMP_DISABLED, + WL12XX_FWLOG_TIMESTAMP_ENABLED +}; + +/* + * Logs can be routed to the debug pinouts (where available), to the host bus + * (SDIO/SPI), or dropped + */ +enum wl12xx_fwlogger_output { + WL12XX_FWLOG_OUTPUT_NONE, + WL12XX_FWLOG_OUTPUT_DBG_PINS, + WL12XX_FWLOG_OUTPUT_HOST, +}; + +struct wl12xx_cmd_config_fwlog { + struct wl1271_cmd_header header; + + /* See enum wl12xx_fwlogger_log_mode */ + u8 logger_mode; + + /* Minimum log level threshold */ + u8 log_severity; + + /* Include/exclude timestamps from the log messages */ + u8 timestamp; + + /* See enum wl1271_fwlogger_output */ + u8 output; + + /* Regulates the frequency of log messages */ + u8 threshold; + + u8 padding[3]; +} __packed; + +struct wl12xx_cmd_start_fwlog { + struct wl1271_cmd_header header; +} __packed; + +struct wl12xx_cmd_stop_fwlog { + struct wl1271_cmd_header header; +} __packed; + #endif /* __WL1271_CMD_H__ */ -- cgit v1.2.3-70-g09d2