From dd410ff12925fc49df3174b18e43598b2b2b621f Mon Sep 17 00:00:00 2001 From: Tejun Heo Date: Mon, 15 May 2006 21:03:50 +0900 Subject: [PATCH] ahci: clean up AHCI constants in preparation for NCQ * Rename CMD_TBL_HDR to CMD_TBL_HDR_SZ as it's size not offset. * Define MAX_CMDS and CMD_SZ and use them in calculation of other constants. * Define CMD_TBL_AR_SZ as product of CMD_TBL_SZ and MAX_CMDS, and use it when calculating PRIV_DMA_SZ. * CMD_SLOT_SZ is also dependent on MAX_CMDS but hasn't been changed because I didn't want to change the value used by the original code (32 commands). Later NCQ change will bump MAX_CMDS to 32 anyway and the hard coded 32 can be changed to MAX_CMDS then. * Reorder HOST_CAP_* flags. Signed-off-by: Tejun Heo --- drivers/scsi/ahci.c | 15 +++++++++------ 1 file changed, 9 insertions(+), 6 deletions(-) (limited to 'drivers/scsi') diff --git a/drivers/scsi/ahci.c b/drivers/scsi/ahci.c index 35487e30b0f..b25373f530a 100644 --- a/drivers/scsi/ahci.c +++ b/drivers/scsi/ahci.c @@ -56,12 +56,15 @@ enum { AHCI_MAX_SG = 168, /* hardware max is 64K */ AHCI_DMA_BOUNDARY = 0xffffffff, AHCI_USE_CLUSTERING = 0, - AHCI_CMD_SLOT_SZ = 32 * 32, + AHCI_MAX_CMDS = 1, + AHCI_CMD_SZ = 32, + AHCI_CMD_SLOT_SZ = 32 * AHCI_CMD_SZ, AHCI_RX_FIS_SZ = 256, - AHCI_CMD_TBL_HDR = 0x80, AHCI_CMD_TBL_CDB = 0x40, - AHCI_CMD_TBL_SZ = AHCI_CMD_TBL_HDR + (AHCI_MAX_SG * 16), - AHCI_PORT_PRIV_DMA_SZ = AHCI_CMD_SLOT_SZ + AHCI_CMD_TBL_SZ + + AHCI_CMD_TBL_HDR_SZ = 0x80, + AHCI_CMD_TBL_SZ = AHCI_CMD_TBL_HDR_SZ + (AHCI_MAX_SG * 16), + AHCI_CMD_TBL_AR_SZ = AHCI_CMD_TBL_SZ * AHCI_MAX_CMDS, + AHCI_PORT_PRIV_DMA_SZ = AHCI_CMD_SLOT_SZ + AHCI_CMD_TBL_AR_SZ + AHCI_RX_FIS_SZ, AHCI_IRQ_ON_SG = (1 << 31), AHCI_CMD_ATAPI = (1 << 5), @@ -89,8 +92,8 @@ enum { HOST_AHCI_EN = (1 << 31), /* AHCI enabled */ /* HOST_CAP bits */ - HOST_CAP_64 = (1 << 31), /* PCI DAC (64-bit DMA) support */ HOST_CAP_CLO = (1 << 24), /* Command List Override support */ + HOST_CAP_64 = (1 << 31), /* PCI DAC (64-bit DMA) support */ /* registers for each SATA port */ PORT_LST_ADDR = 0x00, /* command list DMA addr */ @@ -398,7 +401,7 @@ static int ahci_port_start(struct ata_port *ap) pp->cmd_tbl = mem; pp->cmd_tbl_dma = mem_dma; - pp->cmd_tbl_sg = mem + AHCI_CMD_TBL_HDR; + pp->cmd_tbl_sg = mem + AHCI_CMD_TBL_HDR_SZ; ap->private_data = pp; -- cgit v1.2.3-70-g09d2