From f023eab379821365bf265a0240f30c00cecaef7c Mon Sep 17 00:00:00 2001 From: Feng Tang Date: Tue, 22 Feb 2011 15:28:12 +0800 Subject: serial: mfd: add a module parameter for setting each port's working mode The three identical uart ports can work either in DMA or PIO mode. Adding such a module parameter "hsu_dma_enable" will enable user to chose working modes for each port. If the mfd driver is built in kernel, adding a "mfd.hsu_dma_enable=x" in kernel command line has the same effect. Signed-off-by: Feng Tang Signed-off-by: Greg Kroah-Hartman --- drivers/tty/serial/mfd.c | 11 +++++++++++ 1 file changed, 11 insertions(+) (limited to 'drivers/tty/serial/mfd.c') diff --git a/drivers/tty/serial/mfd.c b/drivers/tty/serial/mfd.c index 53ff6af1627..c111f36f5d2 100644 --- a/drivers/tty/serial/mfd.c +++ b/drivers/tty/serial/mfd.c @@ -47,6 +47,11 @@ #define mfd_readl(obj, offset) readl(obj->reg + offset) #define mfd_writel(obj, offset, val) writel(val, obj->reg + offset) +static int hsu_dma_enable; +module_param(hsu_dma_enable, int, 0); +MODULE_PARM_DESC(hsu_dma_enable, "It is a bitmap to set working mode, if \ +bit[x] is 1, then port[x] will work in DMA mode, otherwise in PIO mode."); + struct hsu_dma_buffer { u8 *buf; dma_addr_t dma_addr; @@ -1367,6 +1372,12 @@ static void hsu_global_init(void) serial_hsu_ports[i] = uport; uport->index = i; + + if (hsu_dma_enable & (1<use_dma = 1; + else + uport->use_dma = 0; + uport++; } -- cgit v1.2.3-70-g09d2