From 230f7ede6c2f0e403f29e03e0251a470aa9350dd Mon Sep 17 00:00:00 2001 From: Anatolij Gustschin Date: Tue, 28 Sep 2010 20:55:21 +0200 Subject: USB: add USB EHCI support for MPC5121 SoC Extends FSL EHCI platform driver glue layer to support MPC5121 USB controllers. MPC5121 Rev 2.0 silicon EHCI registers are in big endian format. The appropriate flags are set using the information in the platform data structure. MPC83xx system interface registers are not available on MPC512x, so the access to these registers is isolated in MPC512x case. Furthermore the USB controller clocks must be enabled before 512x register accesses which is done by providing platform specific init callback. The MPC512x internal USB PHY doesn't provide supply voltage. For boards using different power switches allow specifying DRVVBUS and PWR_FAULT signal polarity of the MPC5121 internal PHY using "fsl,invert-drvvbus" and "fsl,invert-pwr-fault" properties in the device tree USB nodes. Adds documentation for this new device tree bindings. Signed-off-by: Anatolij Gustschin Cc: Grant Likely Signed-off-by: Greg Kroah-Hartman --- drivers/usb/host/fsl-mph-dr-of.c | 89 ++++++++++++++++++++++++++++++++++++++++ 1 file changed, 89 insertions(+) (limited to 'drivers/usb/host/fsl-mph-dr-of.c') diff --git a/drivers/usb/host/fsl-mph-dr-of.c b/drivers/usb/host/fsl-mph-dr-of.c index 12db5d5cb0b..574b99ea070 100644 --- a/drivers/usb/host/fsl-mph-dr-of.c +++ b/drivers/usb/host/fsl-mph-dr-of.c @@ -15,6 +15,7 @@ #include #include #include +#include struct fsl_usb2_dev_data { char *dr_mode; /* controller mode */ @@ -153,6 +154,12 @@ static int __devinit fsl_usb2_mph_dr_of_probe(struct platform_device *ofdev) pdata->operating_mode = FSL_USB2_MPH_HOST; } else { + if (of_get_property(np, "fsl,invert-drvvbus", NULL)) + pdata->invert_drvvbus = 1; + + if (of_get_property(np, "fsl,invert-pwr-fault", NULL)) + pdata->invert_pwr_fault = 1; + /* setup mode selected in the device tree */ pdata->operating_mode = dev_data->op_mode; } @@ -186,9 +193,91 @@ static int __devexit fsl_usb2_mph_dr_of_remove(struct platform_device *ofdev) return 0; } +#ifdef CONFIG_PPC_MPC512x + +#define USBGENCTRL 0x200 /* NOTE: big endian */ +#define GC_WU_INT_CLR (1 << 5) /* Wakeup int clear */ +#define GC_ULPI_SEL (1 << 4) /* ULPI i/f select (usb0 only)*/ +#define GC_PPP (1 << 3) /* Inv. Port Power Polarity */ +#define GC_PFP (1 << 2) /* Inv. Power Fault Polarity */ +#define GC_WU_ULPI_EN (1 << 1) /* Wakeup on ULPI event */ +#define GC_WU_IE (1 << 1) /* Wakeup interrupt enable */ + +#define ISIPHYCTRL 0x204 /* NOTE: big endian */ +#define PHYCTRL_PHYE (1 << 4) /* On-chip UTMI PHY enable */ +#define PHYCTRL_BSENH (1 << 3) /* Bit Stuff Enable High */ +#define PHYCTRL_BSEN (1 << 2) /* Bit Stuff Enable */ +#define PHYCTRL_LSFE (1 << 1) /* Line State Filter Enable */ +#define PHYCTRL_PXE (1 << 0) /* PHY oscillator enable */ + +int fsl_usb2_mpc5121_init(struct platform_device *pdev) +{ + struct fsl_usb2_platform_data *pdata = pdev->dev.platform_data; + struct clk *clk; + char clk_name[10]; + int base, clk_num; + + base = pdev->resource->start & 0xf000; + if (base == 0x3000) + clk_num = 1; + else if (base == 0x4000) + clk_num = 2; + else + return -ENODEV; + + snprintf(clk_name, sizeof(clk_name), "usb%d_clk", clk_num); + clk = clk_get(&pdev->dev, clk_name); + if (IS_ERR(clk)) { + dev_err(&pdev->dev, "failed to get clk\n"); + return PTR_ERR(clk); + } + + clk_enable(clk); + pdata->clk = clk; + + if (pdata->phy_mode == FSL_USB2_PHY_UTMI_WIDE) { + u32 reg = 0; + + if (pdata->invert_drvvbus) + reg |= GC_PPP; + + if (pdata->invert_pwr_fault) + reg |= GC_PFP; + + out_be32(pdata->regs + ISIPHYCTRL, PHYCTRL_PHYE | PHYCTRL_PXE); + out_be32(pdata->regs + USBGENCTRL, reg); + } + return 0; +} + +static void fsl_usb2_mpc5121_exit(struct platform_device *pdev) +{ + struct fsl_usb2_platform_data *pdata = pdev->dev.platform_data; + + pdata->regs = NULL; + + if (pdata->clk) { + clk_disable(pdata->clk); + clk_put(pdata->clk); + } +} + +struct fsl_usb2_platform_data fsl_usb2_mpc5121_pd = { + .big_endian_desc = 1, + .big_endian_mmio = 1, + .es = 1, + .le_setup_buf = 1, + .init = fsl_usb2_mpc5121_init, + .exit = fsl_usb2_mpc5121_exit, +}; +#endif /* CONFIG_PPC_MPC512x */ + static const struct of_device_id fsl_usb2_mph_dr_of_match[] = { { .compatible = "fsl-usb2-mph", }, { .compatible = "fsl-usb2-dr", }, +#ifdef CONFIG_PPC_MPC512x + { .compatible = "fsl,mpc5121-usb2-dr", .data = &fsl_usb2_mpc5121_pd, }, +#endif {}, }; -- cgit v1.2.3-70-g09d2