From 5effabbe9e6e0089f7afdde35cb51e8c8b4cf6bc Mon Sep 17 00:00:00 2001 From: Yoshihiro Shimoda Date: Tue, 26 May 2009 18:24:34 +0900 Subject: USB: r8a66597-hcd: use platform_data instead of module_param CPU/board specific parameters (PLL clock, vif etc...) can be set by platform_data instead of module_param. v2: remove irq_sense member in platform_data because it can OR in IRQF_TRIGGER_LOW or IRQF_TRIGGER_FALLING against IORESOURCE_IRQ in the struct resource. Signed-off-by: Yoshihiro Shimoda Reviewed-by: Paul Mundt Signed-off-by: Greg Kroah-Hartman --- drivers/usb/host/r8a66597-hcd.c | 60 ++++++++++------------------------------- drivers/usb/host/r8a66597.h | 38 +++++++++++++++++++++++--- 2 files changed, 48 insertions(+), 50 deletions(-) (limited to 'drivers/usb') diff --git a/drivers/usb/host/r8a66597-hcd.c b/drivers/usb/host/r8a66597-hcd.c index 3e1216ad86b..56976cc0352 100644 --- a/drivers/usb/host/r8a66597-hcd.c +++ b/drivers/usb/host/r8a66597-hcd.c @@ -46,31 +46,10 @@ MODULE_LICENSE("GPL"); MODULE_AUTHOR("Yoshihiro Shimoda"); MODULE_ALIAS("platform:r8a66597_hcd"); -#define DRIVER_VERSION "10 Apr 2008" +#define DRIVER_VERSION "2009-05-26" static const char hcd_name[] = "r8a66597_hcd"; -/* module parameters */ -#if !defined(CONFIG_SUPERH_ON_CHIP_R8A66597) -static unsigned short clock = XTAL12; -module_param(clock, ushort, 0644); -MODULE_PARM_DESC(clock, "input clock: 48MHz=32768, 24MHz=16384, 12MHz=0 " - "(default=0)"); -#endif - -static unsigned short vif = LDRV; -module_param(vif, ushort, 0644); -MODULE_PARM_DESC(vif, "input VIF: 3.3V=32768, 1.5V=0(default=32768)"); - -static unsigned short endian; -module_param(endian, ushort, 0644); -MODULE_PARM_DESC(endian, "data endian: big=256, little=0 (default=0)"); - -static unsigned short irq_sense = 0xff; -module_param(irq_sense, ushort, 0644); -MODULE_PARM_DESC(irq_sense, "IRQ sense: low level=32, falling edge=0 " - "(default=32)"); - static void packet_write(struct r8a66597 *r8a66597, u16 pipenum); static int r8a66597_get_frame(struct usb_hcd *hcd); @@ -136,7 +115,8 @@ static int r8a66597_clock_enable(struct r8a66597 *r8a66597) } } while ((tmp & USBE) != USBE); r8a66597_bclr(r8a66597, USBE, SYSCFG0); - r8a66597_mdfy(r8a66597, clock, XTAL, SYSCFG0); + r8a66597_mdfy(r8a66597, get_xtal_from_pdata(r8a66597->pdata), XTAL, + SYSCFG0); i = 0; r8a66597_bset(r8a66597, XCKE, SYSCFG0); @@ -203,6 +183,9 @@ static void r8a66597_disable_port(struct r8a66597 *r8a66597, int port) static int enable_controller(struct r8a66597 *r8a66597) { int ret, port; + u16 vif = r8a66597->pdata->vif ? LDRV : 0; + u16 irq_sense = r8a66597->irq_sense_low ? INTL : 0; + u16 endian = r8a66597->pdata->endian ? BIGEND : 0; ret = r8a66597_clock_enable(r8a66597); if (ret < 0) @@ -2418,6 +2401,12 @@ static int __devinit r8a66597_probe(struct platform_device *pdev) goto clean_up; } + if (pdev->dev.platform_data == NULL) { + dev_err(&pdev->dev, "no platform data\n"); + ret = -ENODEV; + goto clean_up; + } + /* initialize hcd */ hcd = usb_create_hcd(&r8a66597_hc_driver, &pdev->dev, (char *)hcd_name); if (!hcd) { @@ -2428,6 +2417,8 @@ static int __devinit r8a66597_probe(struct platform_device *pdev) r8a66597 = hcd_to_r8a66597(hcd); memset(r8a66597, 0, sizeof(struct r8a66597)); dev_set_drvdata(&pdev->dev, r8a66597); + r8a66597->pdata = pdev->dev.platform_data; + r8a66597->irq_sense_low = irq_trigger == IRQF_TRIGGER_LOW; #if defined(CONFIG_SUPERH_ON_CHIP_R8A66597) && defined(CONFIG_HAVE_CLK) snprintf(clk_name, sizeof(clk_name), "usb%d", pdev->id); @@ -2458,29 +2449,6 @@ static int __devinit r8a66597_probe(struct platform_device *pdev) hcd->rsrc_start = res->start; - /* irq_sense setting on cmdline takes precedence over resource - * settings, so the introduction of irqflags in IRQ resourse - * won't disturb existing setups */ - switch (irq_sense) { - case INTL: - irq_trigger = IRQF_TRIGGER_LOW; - break; - case 0: - irq_trigger = IRQF_TRIGGER_FALLING; - break; - case 0xff: - if (irq_trigger) - irq_sense = (irq_trigger & IRQF_TRIGGER_LOW) ? - INTL : 0; - else { - irq_sense = INTL; - irq_trigger = IRQF_TRIGGER_LOW; - } - break; - default: - dev_err(&pdev->dev, "Unknown irq_sense value.\n"); - } - ret = usb_add_hcd(hcd, irq, IRQF_DISABLED | irq_trigger); if (ret != 0) { dev_err(&pdev->dev, "Failed to add hcd\n"); diff --git a/drivers/usb/host/r8a66597.h b/drivers/usb/host/r8a66597.h index f49208f1bb7..d72680b433f 100644 --- a/drivers/usb/host/r8a66597.h +++ b/drivers/usb/host/r8a66597.h @@ -30,6 +30,8 @@ #include #endif +#include + #define SYSCFG0 0x00 #define SYSCFG1 0x02 #define SYSSTS0 0x04 @@ -488,6 +490,7 @@ struct r8a66597 { #if defined(CONFIG_SUPERH_ON_CHIP_R8A66597) && defined(CONFIG_HAVE_CLK) struct clk *clk; #endif + struct r8a66597_platdata *pdata; struct r8a66597_device device0; struct r8a66597_root_hub root_hub[R8A66597_MAX_ROOT_HUB]; struct list_head pipe_queue[R8A66597_MAX_NUM_PIPE]; @@ -506,6 +509,7 @@ struct r8a66597 { unsigned long child_connect_map[4]; unsigned bus_suspended:1; + unsigned irq_sense_low:1; }; static inline struct r8a66597 *hcd_to_r8a66597(struct usb_hcd *hcd) @@ -660,10 +664,36 @@ static inline void r8a66597_port_power(struct r8a66597 *r8a66597, int port, { unsigned long dvstctr_reg = get_dvstctr_reg(port); - if (power) - r8a66597_bset(r8a66597, VBOUT, dvstctr_reg); - else - r8a66597_bclr(r8a66597, VBOUT, dvstctr_reg); + if (r8a66597->pdata->port_power) { + r8a66597->pdata->port_power(port, power); + } else { + if (power) + r8a66597_bset(r8a66597, VBOUT, dvstctr_reg); + else + r8a66597_bclr(r8a66597, VBOUT, dvstctr_reg); + } +} + +static inline u16 get_xtal_from_pdata(struct r8a66597_platdata *pdata) +{ + u16 clock = 0; + + switch (pdata->xtal) { + case R8A66597_PLATDATA_XTAL_12MHZ: + clock = XTAL12; + break; + case R8A66597_PLATDATA_XTAL_24MHZ: + clock = XTAL24; + break; + case R8A66597_PLATDATA_XTAL_48MHZ: + clock = XTAL48; + break; + default: + printk(KERN_ERR "r8a66597: platdata clock is wrong.\n"); + break; + } + + return clock; } #define get_pipectr_addr(pipenum) (PIPE1CTR + (pipenum - 1) * 2) -- cgit v1.2.3-70-g09d2