From a7a1d9da2980c2e86eba78d89a156f0b9d04ed4a Mon Sep 17 00:00:00 2001 From: Bruce Allan Date: Thu, 24 Jan 2013 00:50:18 +0000 Subject: e1000e: cleanup checkpatch braces checks Resolve the following strict checkpatch checks: CHECK:BRACES: Blank lines aren't necessary after an open brace '{' CHECK:BRACES: Blank lines aren't necessary before a close brace '}' CHECK:BRACES: braces {} should be used on all arms of this statement Signed-off-by: Bruce Allan Tested-by: Aaron Brown Signed-off-by: Jeff Kirsher --- drivers/net/ethernet/intel/e1000e/82571.c | 1 - drivers/net/ethernet/intel/e1000e/ethtool.c | 5 ++--- drivers/net/ethernet/intel/e1000e/ich8lan.c | 1 - drivers/net/ethernet/intel/e1000e/netdev.c | 2 -- drivers/net/ethernet/intel/e1000e/phy.c | 1 - 5 files changed, 2 insertions(+), 8 deletions(-) (limited to 'drivers') diff --git a/drivers/net/ethernet/intel/e1000e/82571.c b/drivers/net/ethernet/intel/e1000e/82571.c index 1db7e3df43e..2faffbde179 100644 --- a/drivers/net/ethernet/intel/e1000e/82571.c +++ b/drivers/net/ethernet/intel/e1000e/82571.c @@ -1534,7 +1534,6 @@ static s32 e1000_check_for_serdes_link_82571(struct e1000_hw *hw) rxcw = er32(RXCW); if ((rxcw & E1000_RXCW_SYNCH) && !(rxcw & E1000_RXCW_IV)) { - /* Receiver is synchronized with no invalid bits. */ switch (mac->serdes_link_state) { case e1000_serdes_link_autoneg_complete: diff --git a/drivers/net/ethernet/intel/e1000e/ethtool.c b/drivers/net/ethernet/intel/e1000e/ethtool.c index 455e385120b..2c1813737f6 100644 --- a/drivers/net/ethernet/intel/e1000e/ethtool.c +++ b/drivers/net/ethernet/intel/e1000e/ethtool.c @@ -130,7 +130,6 @@ static int e1000_get_settings(struct net_device *netdev, u32 speed; if (hw->phy.media_type == e1000_media_type_copper) { - ecmd->supported = (SUPPORTED_10baseT_Half | SUPPORTED_10baseT_Full | SUPPORTED_100baseT_Half | @@ -328,12 +327,12 @@ static int e1000_set_settings(struct net_device *netdev, } /* reset the link */ - if (netif_running(adapter->netdev)) { e1000e_down(adapter); e1000e_up(adapter); - } else + } else { e1000e_reset(adapter); + } clear_bit(__E1000_RESETTING, &adapter->state); return 0; diff --git a/drivers/net/ethernet/intel/e1000e/ich8lan.c b/drivers/net/ethernet/intel/e1000e/ich8lan.c index 1e838b235e8..dff7bff8b8e 100644 --- a/drivers/net/ethernet/intel/e1000e/ich8lan.c +++ b/drivers/net/ethernet/intel/e1000e/ich8lan.c @@ -3991,7 +3991,6 @@ void e1000_suspend_workarounds_ich8lan(struct e1000_hw *hw) * The SMBus release must also be disabled on LCD reset. */ if (!(er32(FWSM) & E1000_ICH_FWSM_FW_VALID)) { - /* Enable proxy to reset only on power good. */ e1e_rphy_locked(hw, I217_PROXY_CTRL, &phy_reg); phy_reg |= I217_PROXY_CTRL_AUTO_DISABLE; diff --git a/drivers/net/ethernet/intel/e1000e/netdev.c b/drivers/net/ethernet/intel/e1000e/netdev.c index 382b031e7b2..3f7dbd1cdb0 100644 --- a/drivers/net/ethernet/intel/e1000e/netdev.c +++ b/drivers/net/ethernet/intel/e1000e/netdev.c @@ -87,7 +87,6 @@ struct e1000_reg_info { }; static const struct e1000_reg_info e1000_reg_info_tbl[] = { - /* General Registers */ {E1000_CTRL, "CTRL"}, {E1000_STATUS, "STATUS"}, @@ -6394,7 +6393,6 @@ static void e1000_io_resume(struct pci_dev *pdev) */ if (!(adapter->flags & FLAG_HAS_AMT)) e1000e_get_hw_control(adapter); - } static void e1000_print_device_info(struct e1000_adapter *adapter) diff --git a/drivers/net/ethernet/intel/e1000e/phy.c b/drivers/net/ethernet/intel/e1000e/phy.c index a5ff13b9ef8..0930c136aa3 100644 --- a/drivers/net/ethernet/intel/e1000e/phy.c +++ b/drivers/net/ethernet/intel/e1000e/phy.c @@ -2474,7 +2474,6 @@ s32 e1000e_read_phy_reg_bm2(struct e1000_hw *hw, u32 offset, u16 *data) hw->phy.addr = 1; if (offset > MAX_PHY_MULTI_PAGE_REG) { - /* Page is shifted left, PHY expects (page x 32) */ ret_val = e1000e_write_phy_reg_mdic(hw, BM_PHY_PAGE_SELECT, page); -- cgit v1.2.3-70-g09d2