From 4b77f2c93d052adca8cc8690b9b5e7f8798f4ddd Mon Sep 17 00:00:00 2001 From: David Teigland Date: Wed, 1 Nov 2006 09:31:48 -0600 Subject: [DLM] do full recover_locks barrier Red Hat BZ 211914 The previous patch "[DLM] fix aborted recovery during node removal" was incomplete as discovered with further testing. It set the bit for the RS_LOCKS barrier but did not then wait for the barrier. This is often ok, but sometimes it will cause yet another recovery hang. If it's a new node that also has the lowest nodeid that skips the barrier wait, then it misses the important step of collecting and reporting the barrier status from the other nodes (which is the job of the low nodeid in the barrier wait routine). Signed-off-by: David Teigland Signed-off-by: Steven Whitehouse --- fs/dlm/recoverd.c | 8 +++++++- 1 file changed, 7 insertions(+), 1 deletion(-) (limited to 'fs/dlm') diff --git a/fs/dlm/recoverd.c b/fs/dlm/recoverd.c index 6e4ee94ce7d..8bb895ffd90 100644 --- a/fs/dlm/recoverd.c +++ b/fs/dlm/recoverd.c @@ -168,9 +168,15 @@ static int ls_recover(struct dlm_ls *ls, struct dlm_recover *rv) /* * Other lockspace members may be going through the "neg" steps * while also adding us to the lockspace, in which case they'll - * be looking for this status bit during dlm_recover_locks(). + * be doing the recover_locks (RS_LOCKS) barrier. */ dlm_set_recover_status(ls, DLM_RS_LOCKS); + + error = dlm_recover_locks_wait(ls); + if (error) { + log_error(ls, "recover_locks_wait failed %d", error); + goto fail; + } } dlm_release_root_list(ls); -- cgit v1.2.3-70-g09d2