From ec38846ad59d7b780540afcec101b24139933195 Mon Sep 17 00:00:00 2001 From: Alexandre Belloni Date: Thu, 29 May 2014 01:20:16 +0200 Subject: backlight: atmel-pwm-bl: remove obsolete driver The atmel-pwm-bl driver is now obsolete. It is not used by any mainlined boards and is replaced by the generic pwm_bl with the pawm-atmel driver using the generic PWM framework. Signed-off-by: Alexandre Belloni Acked-by: Hans-Christian Egtvedt Acked-by: Jingoo Han Signed-off-by: Nicolas Ferre --- include/linux/atmel-pwm-bl.h | 43 ------------------------------------------- 1 file changed, 43 deletions(-) delete mode 100644 include/linux/atmel-pwm-bl.h (limited to 'include/linux/atmel-pwm-bl.h') diff --git a/include/linux/atmel-pwm-bl.h b/include/linux/atmel-pwm-bl.h deleted file mode 100644 index 0153a47806c..00000000000 --- a/include/linux/atmel-pwm-bl.h +++ /dev/null @@ -1,43 +0,0 @@ -/* - * Copyright (C) 2007 Atmel Corporation - * - * Driver for the AT32AP700X PS/2 controller (PSIF). - * - * This program is free software; you can redistribute it and/or modify it - * under the terms of the GNU General Public License version 2 as published - * by the Free Software Foundation. - */ - -#ifndef __INCLUDE_ATMEL_PWM_BL_H -#define __INCLUDE_ATMEL_PWM_BL_H - -/** - * struct atmel_pwm_bl_platform_data - * @pwm_channel: which PWM channel in the PWM module to use. - * @pwm_frequency: PWM frequency to generate, the driver will try to be as - * close as the prescaler allows. - * @pwm_compare_max: value to use in the PWM channel compare register. - * @pwm_duty_max: maximum duty cycle value, must be less than or equal to - * pwm_compare_max. - * @pwm_duty_min: minimum duty cycle value, must be less than pwm_duty_max. - * @pwm_active_low: set to one if the low part of the PWM signal increases the - * brightness of the backlight. - * @gpio_on: GPIO line to control the backlight on/off, set to -1 if not used. - * @on_active_low: set to one if the on/off signal is on when GPIO is low. - * - * This struct must be added to the platform device in the board code. It is - * used by the atmel-pwm-bl driver to setup the GPIO to control on/off and the - * PWM device. - */ -struct atmel_pwm_bl_platform_data { - unsigned int pwm_channel; - unsigned int pwm_frequency; - unsigned int pwm_compare_max; - unsigned int pwm_duty_max; - unsigned int pwm_duty_min; - unsigned int pwm_active_low; - int gpio_on; - unsigned int on_active_low; -}; - -#endif /* __INCLUDE_ATMEL_PWM_BL_H */ -- cgit v1.2.3-70-g09d2