From 34206f267120c839a479d0237db907fa062e7b0f Mon Sep 17 00:00:00 2001 From: Enric Balletbo i Serra Date: Tue, 5 Apr 2011 07:08:41 +0000 Subject: can: mcp251x: Allow pass IRQ flags through platform data. When an interrupt occurs, the INT pin is driven low by the MCP251x controller (falling edge) but in some cases the INT pin can be connected to the MPU through a transistor or level translator which inverts this signal. In this case interrupt should be configured in rising edge. This patch adds support to pass the IRQ flags via mcp251x_platform_data. Signed-off-by: Enric Balletbo i Serra Acked-by: Wolfgang Grandegger Acked-by: Marc Kleine-Budde Signed-off-by: David S. Miller --- include/linux/can/platform/mcp251x.h | 2 ++ 1 file changed, 2 insertions(+) (limited to 'include/linux/can/platform') diff --git a/include/linux/can/platform/mcp251x.h b/include/linux/can/platform/mcp251x.h index 8e20540043f..089fe43211a 100644 --- a/include/linux/can/platform/mcp251x.h +++ b/include/linux/can/platform/mcp251x.h @@ -12,6 +12,7 @@ /** * struct mcp251x_platform_data - MCP251X SPI CAN controller platform data * @oscillator_frequency: - oscillator frequency in Hz + * @irq_flags: - IRQF configuration flags * @board_specific_setup: - called before probing the chip (power,reset) * @transceiver_enable: - called to power on/off the transceiver * @power_enable: - called to power on/off the mcp *and* the @@ -24,6 +25,7 @@ struct mcp251x_platform_data { unsigned long oscillator_frequency; + unsigned long irq_flags; int (*board_specific_setup)(struct spi_device *spi); int (*transceiver_enable)(int enable); int (*power_enable) (int enable); -- cgit v1.2.3-70-g09d2