From 2a0fe914a38745f5b03534c4e4f4056cbd6978b8 Mon Sep 17 00:00:00 2001 From: Yong Ding Date: Tue, 15 May 2012 13:09:43 +0800 Subject: mmc: sdio: fix setting card data bus width as 4-bit SDIO_CCCR_IF[1:0] in SDIO card is used for card data bus width setting as below: 00b: 1-bit bus 01b: Reserved 10b: 4-bit bus 11b: 8-bit bus (only for embedded SDIO) And sdio_enable_wide is for setting data bus width as 4-bit. But currently, it first reads the register, second OR' 1b with SDIO_CCCR_IF[1], and then writes it back. As we can see, this is based on such assumption that the SDIO_CCCR_IF[0] is always 0. Apparently, this is not right. Signed-off-by: Yong Ding Acked-by: Philip Rakity Signed-off-by: Chris Ball --- include/linux/mmc/sdio.h | 2 ++ 1 file changed, 2 insertions(+) (limited to 'include/linux/mmc/sdio.h') diff --git a/include/linux/mmc/sdio.h b/include/linux/mmc/sdio.h index c9fe66c58f8..17446d3c360 100644 --- a/include/linux/mmc/sdio.h +++ b/include/linux/mmc/sdio.h @@ -98,7 +98,9 @@ #define SDIO_CCCR_IF 0x07 /* bus interface controls */ +#define SDIO_BUS_WIDTH_MASK 0x03 /* data bus width setting */ #define SDIO_BUS_WIDTH_1BIT 0x00 +#define SDIO_BUS_WIDTH_RESERVED 0x01 #define SDIO_BUS_WIDTH_4BIT 0x02 #define SDIO_BUS_ECSI 0x20 /* Enable continuous SPI interrupt */ #define SDIO_BUS_SCSI 0x40 /* Support continuous SPI interrupt */ -- cgit v1.2.3-70-g09d2