From 6a2e9b738cb5c929df73b6acabdd8f9a4e9a0416 Mon Sep 17 00:00:00 2001 From: Sam Ravnborg <sam@ravnborg.org> Date: Mon, 11 Jul 2005 21:13:56 -0700 Subject: [NET]: move config options out to individual protocols Move the protocol specific config options out to the specific protocols. With this change net/Kconfig now starts to become readable and serve as a good basis for further re-structuring. The menu structure is left almost intact, except that indention is fixed in most cases. Most visible are the INET changes where several "depends on INET" are replaced with a single ifdef INET / endif pair. Several new files were created to accomplish this change - they are small but serve the purpose that config options are now distributed out where they belongs. Signed-off-by: Sam Ravnborg <sam@ravnborg.org> Signed-off-by: David S. Miller <davem@davemloft.net> --- net/wanrouter/Kconfig | 29 +++++++++++++++++++++++++++++ 1 file changed, 29 insertions(+) create mode 100644 net/wanrouter/Kconfig (limited to 'net/wanrouter/Kconfig') diff --git a/net/wanrouter/Kconfig b/net/wanrouter/Kconfig new file mode 100644 index 00000000000..1debe1cb054 --- /dev/null +++ b/net/wanrouter/Kconfig @@ -0,0 +1,29 @@ +# +# Configuration for WAN router +# + +config WAN_ROUTER + tristate "WAN router" + depends on EXPERIMENTAL + ---help--- + Wide Area Networks (WANs), such as X.25, frame relay and leased + lines, are used to interconnect Local Area Networks (LANs) over vast + distances with data transfer rates significantly higher than those + achievable with commonly used asynchronous modem connections. + Usually, a quite expensive external device called a `WAN router' is + needed to connect to a WAN. + + As an alternative, WAN routing can be built into the Linux kernel. + With relatively inexpensive WAN interface cards available on the + market, a perfectly usable router can be built for less than half + the price of an external router. If you have one of those cards and + wish to use your Linux box as a WAN router, say Y here and also to + the WAN driver for your card, below. You will then need the + wan-tools package which is available from <ftp://ftp.sangoma.com/>. + Read <file:Documentation/networking/wan-router.txt> for more + information. + + To compile WAN routing support as a module, choose M here: the + module will be called wanrouter. + + If unsure, say N. -- cgit v1.2.3-70-g09d2