From 3d1cc41432b0491a39a3185b52bfa1d0411bba10 Mon Sep 17 00:00:00 2001 From: Steven Rostedt Date: Fri, 30 Sep 2011 22:14:21 -0400 Subject: ktest: Add OVERRIDE keyword to DEFAULTS section The OVERRIDE keyword will allow options defined in the given DEFAULTS section to override options defined in previous DEFAULT sections. Normally, options will error if they were previous defined. The OVERRIDE keyword allows options that have been previously defined to be changed in the given section. Note, the same option can not be defined in the same DEFAULT section even if that section is marked as OVERRIDE. Signed-off-by: Steven Rostedt --- tools/testing/ktest/sample.conf | 15 +++++++++++++++ 1 file changed, 15 insertions(+) (limited to 'tools/testing/ktest/sample.conf') diff --git a/tools/testing/ktest/sample.conf b/tools/testing/ktest/sample.conf index ae2a93c732a..0fd3ca30ad0 100644 --- a/tools/testing/ktest/sample.conf +++ b/tools/testing/ktest/sample.conf @@ -72,6 +72,21 @@ # the same option name under the same test or as default # ktest will fail to execute, and no tests will run. # +# DEFAULTS OVERRIDE +# +# Options defined in the DEFAULTS section can not be duplicated +# even if they are defined in two different DEFAULT sections. +# This is done to catch mistakes where an option is added but +# the previous option was forgotten about and not commented. +# +# The OVERRIDE keyword can be added to a section to allow this +# section to override other DEFAULT sections values that have +# been defined previously. It will only override options that +# have been defined before its use. Options defined later +# in a non override section will still error. The same option +# can not be defined in the same section even if that section +# is marked OVERRIDE. +# # # # Both TEST_START and DEFAULTS sections can also have the IF keyword -- cgit v1.2.3-70-g09d2