if ARCH_DAVINCI

menu "TI DaVinci Implementations"

comment "DaVinci Core Type"

config ARCH_DAVINCI644x
	default y
	bool "DaVinci 644x based system"

comment "DaVinci Board Type"

config MACH_DAVINCI_EVM
	bool "TI DaVinci EVM"
	default y
	depends on ARCH_DAVINCI644x
	help
	  Configure this option to specify the whether the board used
	  for development is a DaVinci EVM


config DAVINCI_MUX
	bool "DAVINCI multiplexing support"
	depends on ARCH_DAVINCI
	default y
	help
	  Pin multiplexing support for DAVINCI boards. If your bootloader
	  sets the multiplexing correctly, say N. Otherwise, or if unsure,
	  say Y.

config DAVINCI_MUX_DEBUG
        bool "Multiplexing debug output"
        depends on DAVINCI_MUX
        help
          Makes the multiplexing functions print out a lot of debug info.
          This is useful if you want to find out the correct values of the
          multiplexing registers.

config DAVINCI_MUX_WARNINGS
        bool "Warn about pins the bootloader didn't set up"
        depends on DAVINCI_MUX
        help
          Choose Y here to warn whenever driver initialization logic needs
          to change the pin multiplexing setup.  When there are no warnings
          printed, it's safe to deselect DAVINCI_MUX for your product.

config DAVINCI_RESET_CLOCKS
	bool "Reset unused clocks during boot"
	depends on ARCH_DAVINCI
	help
	  Say Y if you want to reset unused clocks during boot.
	  This option saves power, but assumes all drivers are
	  using the clock framework. Broken drivers that do not
	  yet use clock framework may not work with this option.
	  If you are booting from another operating system, you
	  probably do not want this option enabled until your
	  device drivers work properly.

endmenu

endif