# # Atmel device configuration # config NET_CADENCE bool "Cadence devices" depends on HAS_IOMEM default y ---help--- If you have a network (Ethernet) card belonging to this class, say Y. Make sure you know the name of your card. Read the Ethernet-HOWTO, available from . If unsure, say Y. Note that the answer to this question doesn't directly affect the kernel: saying N will just cause the configurator to skip all the remaining Atmel network card questions. If you say Y, you will be asked for your specific card in the following questions. if NET_CADENCE config ARM_AT91_ETHER tristate "AT91RM9200 Ethernet support" depends on GENERIC_HARDIRQS && HAS_DMA select NET_CORE select MACB ---help--- If you wish to compile a kernel for the AT91RM9200 and enable ethernet support, then you should always answer Y to this. config MACB tristate "Cadence MACB/GEM support" select PHYLIB ---help--- The Cadence MACB ethernet interface is found on many Atmel AT32 and AT91 parts. This driver also supports the Cadence GEM (Gigabit Ethernet MAC found in some ARM SoC devices). Note: the Gigabit mode is not yet supported. Say Y to include support for the MACB/GEM chip. To compile this driver as a module, choose M here: the module will be called macb. endif # NET_CADENCE