/* * Definitions for RTL818x hardware * * Copyright 2007 Michael Wu * Copyright 2007 Andrea Merello * * Based on the r8187 driver, which is: * Copyright 2005 Andrea Merello , et al. * * This program is free software; you can redistribute it and/or modify * it under the terms of the GNU General Public License version 2 as * published by the Free Software Foundation. */ #ifndef RTL818X_H #define RTL818X_H struct rtl818x_csr { u8 MAC[6]; u8 reserved_0[2]; __le32 MAR[2]; u8 RX_FIFO_COUNT; u8 reserved_1; u8 TX_FIFO_COUNT; u8 BQREQ; u8 reserved_2[4]; __le32 TSFT[2]; __le32 TLPDA; __le32 TNPDA; __le32 THPDA; __le16 BRSR; u8 BSSID[6]; u8 RESP_RATE; u8 EIFS; u8 reserved_3[1]; u8 CMD; #define RTL818X_CMD_TX_ENABLE (1 << 2) #define RTL818X_CMD_RX_ENABLE (1 << 3) #define RTL818X_CMD_RESET (1 << 4) u8 reserved_4[4]; __le16 INT_MASK; __le16 INT_STATUS; #define RTL818X_INT_RX_OK (1 << 0) #define RTL818X_INT_RX_ERR (1 << 1) #define RTL818X_INT_TXL_OK (1 << 2) #define RTL818X_INT_TXL_ERR (1 << 3) #define RTL818X_INT_RX_DU (1 << 4) #define RTL818X_INT_RX_FO (1 << 5) #define RTL818X_INT_TXN_OK (1 << 6) #define RTL818X_INT_TXN_ERR (1 << 7) #define RTL818X_INT_TXH_OK (1 << 8) #define RTL818X_INT_TXH_ERR (1 << 9) #define RTL818X_INT_TXB_OK (1 << 10) #define RTL818X_INT_TXB_ERR (1 << 11) #define RTL818X_INT_ATIM (1 << 12) #define RTL818X_INT_BEACON (1 << 13) #define RTL818X_INT_TIME_OUT (1 << 14) #define RTL818X_INT_TX_FO (1 << 15) __le32 TX_CONF; #define RTL818X_TX_CONF_LOOPBACK_MAC (1 << 17) #define RTL818X_TX_CONF_LOOPBACK_CONT (3 << 17) #define RTL818X_TX_CONF_NO_ICV (1 << 19) #define RTL818X_TX_CONF_DISCW (1 << 20) #define RTL818X_TX_CONF_SAT_HWPLCP (1 << 24) #define RTL818X_TX_CONF_R8180_ABCD (2 << 25) #define RTL818X_TX_CONF_R8180_F (3 << 25) #define RTL818X_TX_CONF_R8185_ABC (4 << 25) #define RTL818X_TX_CONF_R8185_D (5 << 25) #define RTL818X_TX_CONF_R8187vD (5 << 25) #define RTL818X_TX_CONF_R8187vD_B (6 << 25) #define RTL818X_TX_CONF_HWVER_MASK (7 << 25) #define RTL818X_TX_CONF_DISREQQSIZE (1 << 28) #define RTL818X_TX_CONF_PROBE_DTS (1 << 29) #define RTL818X_TX_CONF_HW_SEQNUM (1 << 30) #define RTL818X_TX_CONF_CW_MIN (1 << 31) __le32 RX_CONF; #define RTL818X_RX_CONF_MONITOR (1 << 0) #define RTL818X_RX_CONF_NICMAC (1 << 1) #define RTL818X_RX_CONF_MULTICAST (1 << 2) #define RTL818X_RX_CONF_BROADCAST (1 << 3) #define RTL818X_RX_CONF_FCS (1 << 5) #define RTL818X_RX_CONF_DATA (1 << 18) #define RTL818X_RX_CONF_CTRL (1 << 19) #define RTL818X_RX_CONF_MGMT (1 << 20) #define RTL818X_RX_CONF_ADDR3 (1 << 21) #define RTL818X_RX_CONF_PM (1 << 22) #define RTL818X_RX_CONF_BSSID (1 << 23) #define RTL818X_RX_CONF_RX_AUTORESETPHY (1 << 28) #define RTL818X_RX_CONF_CSDM1 (1 << 29) #define RTL818X_RX_CONF_CSDM2 (1 << 30) #define RTL818X_RX_CONF_ONLYERLPKT (1 << 31) __le32 INT_TIMEOUT; __le32 TBDA; u8 EEPROM_CMD; #define RTL818X_EEPROM_CMD_READ (1 << 0) #define RTL818X_EEPROM_CMD_WRITE (1 << 1) #define RTL818X_EEPROM_CMD_CK (1 << 2) #define RTL818X_EEPROM_CMD_CS (1 << 3) #define RTL818X_EEPROM_CMD_NORMAL (0 << 6) #define RTL818X_EEPROM_CMD_LOAD (1 << 6) #define RTL818X_EEPROM_CMD_PROGRAM (2 << 6) #define RTL818X_EEPROM_CMD_CONFIG (3 << 6) u8 CONFIG0; u8 CONFIG1; u8 CONFIG2; #define RTL818X_CONFIG2_ANTENNA_DIV (1 << 6) __le32 ANAPARAM; u8 MSR; #define RTL818X_MSR_NO_LINK (0 << 2) #define RTL818X_MSR_ADHOC (1 << 2) #define RTL818X_MSR_INFRA (2 << 2) #define RTL818X_MSR_MASTER (3 << 2) #define RTL818X_MSR_ENEDCA (4 << 2) u8 CONFIG3; #define RTL818X_CONFIG3_ANAPARAM_WRITE (1 << 6) #define RTL818X_CONFIG3_GNT_SELECT (1 << 7) u8 CONFIG4; #define RTL818X_CONFIG4_POWEROFF (1 << 6) #define RTL818X_CONFIG4_VCOOFF (1 << 7) u8 TESTR; u8 reserved_9[2]; u8 PGSELECT; u8 SECURITY; __le32 ANAPARAM2; u8 reserved_10[12]; __le16 BEACON_INTERVAL; __le16 ATIM_WND; __le16 BEACON_INTERVAL_TIME; __le16 ATIMTR_INTERVAL; u8 PHY_DELAY; u8 CARRIER_SENSE_COUNTER; u8 reserved_11[2]; u8 PHY[4]; __le16 RFPinsOutput; __le16 RFPinsEnable; __le16 RFPinsSelect; __le16 RFPinsInput; __le32 RF_PARA; __le32 RF_TIMING; u8 GP_ENABLE; u8 GPIO; u8 reserved_12[2]; __le32 HSSI_PARA; u8 reserved_13[4]; u8 TX_AGC_CTL; #define RTL818X_TX_AGC_CTL_PERPACKET_GAIN_SHIFT (1 << 0) #define RTL818X_TX_AGC_CTL_PERPACKET_ANTSEL_SHIFT (1 << 1) #define RTL818X_TX_AGC_CTL_FEEDBACK_ANT (1 << 2) u8 TX_GAIN_CCK; u8 TX_GAIN_OFDM; u8 TX_ANTENNA; u8 reserved_14[16]; u8 WPA_CONF; u8 reserved_15[3]; u8 SIFS; u8 DIFS; u8 SLOT; u8 reserved_16[5]; u8 CW_CONF; #define RTL818X_CW_CONF_PERPACKET_CW_SHIFT (1 << 0) #define RTL818X_CW_CONF_PERPACKET_RETRY_SHIFT (1 << 1) u8 CW_VAL; u8 RATE_FALLBACK; #define RTL818X_RATE_FALLBACK_ENABLE (1 << 7) u8 ACM_CONTROL; u8 reserved_17[24]; u8 CONFIG5; u8 TX_DMA_POLLING; u8 reserved_18[2]; __le16 CWR; u8 RETRY_CTR; u8 reserved_19[3]; __le16 INT_MIG; /* RTL818X_R8187B_*: magic numbers from ioregisters */ #define RTL818X_R8187B_B 0 #define RTL818X_R8187B_D 1 #define RTL818X_R8187B_E 2 __le32 RDSAR; __le16 TID_AC_MAP; u8 reserved_20[4]; u8 ANAPARAM3; u8 reserved_21[5]; __le16 FEMR; u8 reserved_22[4]; __le16 TALLY_CNT; u8 TALLY_SEL; } __attribute__((packed)); struct rtl818x_rf_ops { char *name; void (*init)(struct ieee80211_hw *); void (*stop)(struct ieee80211_hw *); void (*set_chan)(struct ieee80211_hw *, struct ieee80211_conf *); void (*conf_erp)(struct ieee80211_hw *, struct ieee80211_bss_conf *); }; /** * enum rtl818x_tx_desc_flags - Tx/Rx flags are common between RTL818X chips * * @RTL818X_TX_DESC_FLAG_NO_ENC: Disable hardware based encryption. * @RTL818X_TX_DESC_FLAG_TX_OK: TX frame was ACKed. * @RTL818X_TX_DESC_FLAG_SPLCP: Use short preamble. * @RTL818X_TX_DESC_FLAG_MOREFRAG: More fragments follow. * @RTL818X_TX_DESC_FLAG_CTS: Use CTS-to-self protection. * @RTL818X_TX_DESC_FLAG_RTS: Use RTS/CTS protection. * @RTL818X_TX_DESC_FLAG_LS: Last segment of the frame. * @RTL818X_TX_DESC_FLAG_FS: First segment of the frame. */ enum rtl818x_tx_desc_flags { RTL818X_TX_DESC_FLAG_NO_ENC = (1 << 15), RTL818X_TX_DESC_FLAG_TX_OK = (1 << 15), RTL818X_TX_DESC_FLAG_SPLCP = (1 << 16), RTL818X_TX_DESC_FLAG_RX_UNDER = (1 << 16), RTL818X_TX_DESC_FLAG_MOREFRAG = (1 << 17), RTL818X_TX_DESC_FLAG_CTS = (1 << 18), RTL818X_TX_DESC_FLAG_RTS = (1 << 23), RTL818X_TX_DESC_FLAG_LS = (1 << 28), RTL818X_TX_DESC_FLAG_FS = (1 << 29), RTL818X_TX_DESC_FLAG_DMA = (1 << 30), RTL818X_TX_DESC_FLAG_OWN = (1 << 31) }; enum rtl818x_rx_desc_flags { RTL818X_RX_DESC_FLAG_ICV_ERR = (1 << 12), RTL818X_RX_DESC_FLAG_CRC32_ERR = (1 << 13), RTL818X_RX_DESC_FLAG_PM = (1 << 14), RTL818X_RX_DESC_FLAG_RX_ERR = (1 << 15), RTL818X_RX_DESC_FLAG_BCAST = (1 << 16), RTL818X_RX_DESC_FLAG_PAM = (1 << 17), RTL818X_RX_DESC_FLAG_MCAST = (1 << 18), RTL818X_RX_DESC_FLAG_QOS = (1 << 19), /* RTL8187(B) only */ RTL818X_RX_DESC_FLAG_TRSW = (1 << 24), /* RTL8187(B) only */ RTL818X_RX_DESC_FLAG_SPLCP = (1 << 25), RTL818X_RX_DESC_FLAG_FOF = (1 << 26), RTL818X_RX_DESC_FLAG_DMA_FAIL = (1 << 27), RTL818X_RX_DESC_FLAG_LS = (1 << 28), RTL818X_RX_DESC_FLAG_FS = (1 << 29), RTL818X_RX_DESC_FLAG_EOR = (1 << 30), RTL818X_RX_DESC_FLAG_OWN = (1 << 31) }; #endif /* RTL818X_H */