blob: 143a29dfe8701c3940f56c804a421047398fc672 (
plain)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
62
63
64
65
66
67
68
69
70
71
72
73
74
75
76
77
78
79
80
81
82
83
84
85
86
87
88
89
90
|
/*
* File: include/asm-blackfin/mach-bf518/anomaly.h
* Bugs: Enter bugs at http://blackfin.uclinux.org/
*
* Copyright (C) 2004-2009 Analog Devices Inc.
* Licensed under the GPL-2 or later.
*/
/* This file shoule be up to date with:
* - Revision B, 02/03/2009; ADSP-BF512/BF514/BF516/BF518 Blackfin Processor Anomaly List
*/
#ifndef _MACH_ANOMALY_H_
#define _MACH_ANOMALY_H_
/* Multi-Issue Instruction with dsp32shiftimm in slot1 and P-reg Store in slot2 Not Supported */
#define ANOMALY_05000074 (1)
/* Rx.H Cannot Be Used to Access 16-bit System MMR Registers */
#define ANOMALY_05000122 (1)
/* False Hardware Error from an Access in the Shadow of a Conditional Branch */
#define ANOMALY_05000245 (1)
/* Incorrect Timer Pulse Width in Single-Shot PWM_OUT Mode with External Clock */
#define ANOMALY_05000254 (1)
/* Sensitivity To Noise with Slow Input Edge Rates on External SPORT TX and RX Clocks */
#define ANOMALY_05000265 (1)
/* False Hardware Errors Caused by Fetches at the Boundary of Reserved Memory */
#define ANOMALY_05000310 (1)
/* PPI Underflow Error Goes Undetected in ITU-R 656 Mode */
#define ANOMALY_05000366 (1)
/* Lockbox SESR Firmware Does Not Save/Restore Full Context */
#define ANOMALY_05000405 (1)
/* Lockbox Firmware Memory Cleanup Routine Does not Clear Registers */
#define ANOMALY_05000408 (1)
/* Speculative Fetches Can Cause Undesired External FIFO Operations */
#define ANOMALY_05000416 (1)
/* TWI Fall Time (Tof) May Violate the Minimum I2C Specification */
#define ANOMALY_05000421 (1)
/* TWI Input Capacitance (Ci) May Violate the Maximum I2C Specification */
#define ANOMALY_05000422 (1)
/* Speculative Fetches of Indirect-Pointer Instructions Can Cause False Hardware Errors */
#define ANOMALY_05000426 (1)
/* Software System Reset Corrupts PLL_LOCKCNT Register */
#define ANOMALY_05000430 (1)
/* Incorrect Use of Stack in Lockbox Firmware During Authentication */
#define ANOMALY_05000431 (1)
/* Certain SIC Registers are not Reset After Soft or Core Double Fault Reset */
#define ANOMALY_05000435 (1)
/* PORTx_DRIVE and PORTx_HYSTERESIS Registers Read Back Incorrect Values */
#define ANOMALY_05000438 (1)
/* Preboot Cannot be Used to Program the PLL_DIV Register */
#define ANOMALY_05000439 (1)
/* bfrom_SysControl() Cannot be Used to Write the PLL_DIV Register */
#define ANOMALY_05000440 (1)
/* IFLUSH Instruction at End of Hardware Loop Causes Infinite Stall */
#define ANOMALY_05000443 (1)
/* Incorrect L1 Instruction Bank B Memory Map Location */
#define ANOMALY_05000444 (1)
/* Incorrect Default Hysteresis Setting for RESET, NMI, and BMODE Signals */
#define ANOMALY_05000452 (1)
/* PWM_TRIPB Signal Not Available on PG10 */
#define ANOMALY_05000453 (1)
/* PPI_FS3 is Driven One Half Cycle Later Than PPI Data */
#define ANOMALY_05000455 (1)
/* Anomalies that don't exist on this proc */
#define ANOMALY_05000125 (0)
#define ANOMALY_05000158 (0)
#define ANOMALY_05000183 (0)
#define ANOMALY_05000198 (0)
#define ANOMALY_05000230 (0)
#define ANOMALY_05000244 (0)
#define ANOMALY_05000261 (0)
#define ANOMALY_05000263 (0)
#define ANOMALY_05000266 (0)
#define ANOMALY_05000273 (0)
#define ANOMALY_05000278 (0)
#define ANOMALY_05000285 (0)
#define ANOMALY_05000305 (0)
#define ANOMALY_05000307 (0)
#define ANOMALY_05000311 (0)
#define ANOMALY_05000312 (0)
#define ANOMALY_05000323 (0)
#define ANOMALY_05000353 (0)
#define ANOMALY_05000363 (0)
#define ANOMALY_05000380 (0)
#define ANOMALY_05000386 (0)
#define ANOMALY_05000412 (0)
#define ANOMALY_05000432 (0)
#endif
|
